Question

For this problem, consider a site which is experiencing a wind speed of 9.5 m/s. You...

For this problem, consider a site which is experiencing a wind speed of 9.5 m/s. You are to calculate how much power there is in the wind in Watts at this moment as it flows through the rotor of a wind turbine. Please assume that the air temperature is 14 degrees C at hub height conditions and the pressure can be considered to be 99.78 kPA for a rotor diameter of 32 m. (answer to 0 decimal places)

0 0
Add a comment Improve this question Transcribed image text
Know the answer?
Add Answer to:
For this problem, consider a site which is experiencing a wind speed of 9.5 m/s. You...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • The wind data of a site is listed in the attached file. The data summarizes the wind speeds and t...

    The wind data of a site is listed in the attached file. The data summarizes the wind speeds and their frequencies at the hub height of the turbine described below. Select a generator size that maximizes the annual energy output. Consider generator ratings in increments of 25 kw. Express the final answer in kWh. Parameters Turbine rotor diameter: 70.0 m Overall efficiency: air density low speeds: 33% 1.16 kg/m generator disengaged for the input values below 30% Site Generator cutoff...

  • The available power in a stream of wind of the same cross-sectional area as the wind...

    The available power in a stream of wind of the same cross-sectional area as the wind turbine can easily be shown to be Available power in watts P pU3 Td where U is the wind speed in m/s p is the density of air in kg/m d is the rotor diameter in m - a. If the temperature is 0°C, and the air density p at 0°C is 1.2754 kg/m', the available power is 225 kW, and the wind speed...

  • 2. A wind turbine has the maximum power output at the rated speed of 12 m/s...

    2. A wind turbine has the maximum power output at the rated speed of 12 m/s and a rotor diameter of 82 meters. The cut-in and cut-out speeds for this type of wind turbine are 4 m/s and 23 m/s, respectively. The table below shows the annual wind data near a potential site for setting up a wind farm using this type of wind turbine and the power coefficient of the wind turbine at the specific wind speed. The air...

  • A 20-m/sec wind speed enters a two-bladed, high speed wind turbine .What should be the rotor...

    A 20-m/sec wind speed enters a two-bladed, high speed wind turbine .What should be the rotor diameter of this turbine to attain power of 100 kW at power coefficient of 0.3? Also calculate the rotor speed and torque produced. Assume the density of Air 1.2 kg/m.

  • There is a wind turbine close to the shoreline. The turbine capacity is 3 MW, the rotor diameter ...

    There is a wind turbine close to the shoreline. The turbine capacity is 3 MW, the rotor diameter is 90 meters, and tower height is 110 meter. The Cp is 43.7%. The yearly average wind speed at 10 m is 5.5 m/s. There is a potential to move the machine to a 120 meter tower. How much power is in wind at 110 & 120m height at the site? (Use the power law for wind speed calculation)

  • -1. Consider a wind turbine of diameter 52 m. At a wind speed 16 m/s, the...

    -1. Consider a wind turbine of diameter 52 m. At a wind speed 16 m/s, the wind turbine reaches is maximum power output of 850 kW. What is the coefficient of performance at this wind speed?

  • 7.26. The conversion of the kinetic energy of wind to electricity may be an attractive altemative...

    7.26. The conversion of the kinetic energy of wind to electricity may be an attractive altemative to the use of fossil fuels. Typically, wind causes the rotor of a turbine to turn, and a generator converts the rotational kinetic energy ofthe rotor into electricity. Power generated by a wind turbine (Ws) can be estimated from the density of the air (p), wind speed (u), and turbine rotor diameter (D) using the following formula лD? 1 W. ти* х п, where...

  • The state of Iowa is among the top three states in U.S. in wind power generation....

    The state of Iowa is among the top three states in U.S. in wind power generation. In 2016, over 20 billion kWh of electrical energy in Iowa was generated by wind power. Assuming that wind speed at the altitude of wind turbine is in average of 6 m/s, the efficiency of converting wind energy to the electricity is 80 %, and all wind turbines work constantly throughout the year. We can further assume that the air in Iowa has an...

  • 5. (4x5pts = 20pts) An anemometer mounted 10 m above a surface with crops, hedges, and...

    5. (4x5pts = 20pts) An anemometer mounted 10 m above a surface with crops, hedges, and shrubs, shows a wind speed of 5 m/s. Assuming 15°C and 1 atm pressure, determine the following for a wind turbine with hub height 80 m and rotor diameter of 80 m: V top - - 80 m 120 m V bottom - 80 m 5 m/s 40 m 10 m Crops, shrubs, hedges FIGURE P7.2 a. Estimate the wind speed and the specific...

  • What is the power coefficient for the Vestas V52-850 kW wind turbine at rated conditions? Rated...

    What is the power coefficient for the Vestas V52-850 kW wind turbine at rated conditions? Rated capacity (kW) 850 Cut-in speed (m/s) 4 Cut-out speed (m/s) 25 Rated wind speed (m/s) 16 Rotor diameter 52 Swept area (m^2) 224 Rotor speed (rpm) 14-31.4

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT