Communication system 4. a) Find the carrier and modulating frequencies, the modulation index, and the maximum...
Communication systemProblems A 25 MHz carrier is modulated by a 400 Hz audio sine wave If the carrier voltage 4 V and the maximum deviation is 10 KHz, write the equation of this modulated wave for FM. If the modulating frequency is now changed to 2 KHz, all else remaining constant, write the new equation for FM2. In an FM system, when the audio frequency (AF) is 500 Hz and the AF voltage is 2.4 V, the deviation is 4.8 KHz....
In an FM system the carrier frequency is 1MHz, the modulating signal at 10 kHz, the maximum deviation is 150 kHz. What is frequency modulation fm?
1 2 4. The amplitude modulation signal is given by the following expression and is applied to 75 load. Vam(t) = 10 sin (21fct) - 2.5 cos (1500krt) + 2.5 cos (1450krt) V Determine: a) Modulation index b) The frequency of the carrier and the information signal c) The bandwidth d) The total power e) The transmission power efficiency be ar e 5. One of the inputs to a frequency modulator is a 250 kHz carrier signal with amplitude of...
()=< a) Consider the case where a modulating tone v, a cos(2ft) is used in a Double Side Band m Amplitude Modulation (DSC-AM) scheme whose varying with time carrier amplitude is [K+a cos(2ft Provide the equation of the modulated carrier signal v (t and then derive from that an expression that shows the spectral components of v (t). Furthermore provide the phasor representation of DSB-AM. Now consider the case of Double Side Band Suppressed carrier AM and provide both the...
14. Given a sinusoidal modulating signal with frequencies f," 10 kHz and a carrier signal of 100 MHz, determine the bandwidth of FM for the three cases (amplitudes: 1. 10, 100, 1000) when the maximum frequency deviation is 50 kHz and k,-2? × 100 rad/sec/volt.
Communication system 2. In an FM system, when the audio frequency (AF) is 500 Hz and the AF voltage is 2.4 V, the deviation is 4.8 KHz. If the AF voltage is now increased to 7.2 V, what is the new deviation? Find the modulation index in each case
A single-tone angle-modulated signal is given by ?(?) = 20cos[6 ∗ 108 ? + 40 sin(1000??)] Assume that the function is an FM signal. Determine (a) the unmodulated carrier frequency, (b) the modulating frequency, (c) the modulation index, and (d) the maximum frequency deviation. Express all frequencies in hertz. (e) Determine the average power dissipated in a 50Ω resistor
Prob. 5 (a) Consider the FM signal with modulation index B 2 is passed through an ideal band-pass filter (BPF) with mid-band frequency f and bandwidth 5f. where f is the carrier frequency and fmis the frequency of the baseband modulating signal (i) Sketch the spectrum of the BPF output. (ii) Determine the fraction of the power of the FM signal that is present at the output of the filter (b) Consider the FM signal given by фFM (t)-100 cos...
A transmitter antenna broadcasts a non-commercial FM signal having modulation index mf = 5 and carrier deviation Δfc = 40.5 kHz. Find the number of pairs of sidebands from Bessel’s table. What is the frequency separation between the sidebands? Find the bandwidth required to transmit the FM signal from parts a and b.
2. 12 pts] An FM system has a modulation index β-6 aid the input signal-to-noise ratio SNR 25dB. The message is a periodic square wave given in the figure below pulse width -0.2m 2 0 0 t (ms) a) What is the output SNR.? b) What is the proper value of the message bandwidth? [Justify your answer. c) What is the corresponding FM transmission bandwidth? d) If the modulation index is kept at β 6, what should be the increase...