Question


Each sketch below shows a flask with some gas and a pool of mercury in it. The gas is at a pressure of 2 atm. A J-shaped tube
0 0
Add a comment Improve this question Transcribed image text
Answer #1

Given The gas is at a pressure of zatm. for open tube; Phulp = 2 atm x 760 mm Hg 1 1 atm = 2) (760 mmHg! = 1520 mm Hg = 7.52Gravity = 15 In open tube total size (including Pent) = 1.5 mt 1.52 mHq + (-0.76 mHg/ - 2.26 m .. (In open tube that sige (in

Add a comment
Know the answer?
Add Answer to:
Each sketch below shows a flask with some gas and a pool of mercury in it....
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • Each sketch below shows a flask with some gas and a pool of mercury in it....

    Each sketch below shows a flask with some gas and a pool of mercury in it. The gas is at a pressure of 1 atm. A J-shaped tube is connected to the bottom of the flask, and the mercury can freely flow in or out of this tube. (You can assume that there is so much more mercury in the pool than can fit into the tube that even if the J-tube is completely filled, the level of mercury in...

  • In gas absorption column experiment, the purpose of the experiment is to measure the absorption of...

    In gas absorption column experiment, the purpose of the experiment is to measure the absorption of carbon dioxide into water flowing down the tower, using the gas analysis equipment provided. The experiment procedure is as follows. 1. First fill the two globes of the absorption analysis equipment on the left of the panel with 1.0 Molar caustic soda. Adjust the level in the globes to the '0' mark on the sight tube, using drain valve Cv into a flask to...

  • Draw a picture. Show open surfaces, pistons, boundaries, and other features that affect the pressure. Include...

    Draw a picture. Show open surfaces, pistons, boundaries, and other features that affect the pressure. Include height and area measurements and fluid densities. Identify the points at which you need to find the pressure. These objects make up the system; the environment is everything else. Determine the pressure at the various surfaces. For a surface open to the air, p0=patmos, usually 1 atm. For a surface covered by a gas, p0=pgas. For a closed surface, p=F/A, where F is the...

  • In problems about liquids in hydrostatic equilibrium

    ± Tactics Box 14.1 Hydrostatics Learning Goal:To practice Tactics Box 14.1 Hydrostatics.In problems about liquids in hydrostatic equilibrium, you often need to find the pressure at some point in the liquid. This Tactics Box outlines a set of rules for thinking about such hydrostatic problems.TACTICS EOX 14+ Hydrostatics1. Draw a picture. Show open surfaces, pistons, boundaries, and other features that affect the pressure. Include height and area measurements and fluid densities. identify the points at which you need to find the...

  • Please answer this problem FULLY with detail steps on how to slove. My professor normally has us ...

    Please answer this problem FULLY with detail steps on how to slove. My professor normally has us answer these questions by hand, and for complex imformation to put the rest into Excel. So, the handworked steps and solutions would be greatly apprecited. Thank you! For the following problems you must develop a diagram to show the situation, include a brief problem statement and clearly show the energy balance equations you are using (start from the appropriate form of the energy...

  • EXPERIMENT 12 Name MEASUREMENT OF THE GAS CONSTANT PRE-LAB EXERCISES Central to the study of gases...

    EXPERIMENT 12 Name MEASUREMENT OF THE GAS CONSTANT PRE-LAB EXERCISES Central to the study of gases is the idea of pressure. Historically pressure was determined as the ability the raise a column of mercury (Hg) to a particular height. Today, pressures are still often (erroneously) quoted just as a simple distance measurement, such as 75 cm. What is really meant is a column of Hg 75 cm high, so it is not too bad to say P - 75 cm...

  • Indicate whether the following experimental mistake will increase, decrease, or have no effect on the calculated...

    Indicate whether the following experimental mistake will increase, decrease, or have no effect on the calculated value of R. A student completed the experiment without waiting for the test tube to cool after heating. Select ALL of the correct answers. a. All measurements should be made at the same temperature. b. The volume measured from the beaker will be high. c. The measured temperature is room temperature. d. The calculated value of Ris low. e. The calculated value of Ris...

  • With the data given, help on the calculations please - Tes Name Determination of the Gas...

    With the data given, help on the calculations please - Tes Name Determination of the Gas Constant, R, and the Purity of KCIO, Data Unknown number or letter Mass of test tube and iron (IIT) oxide 44.5928 Mass of test tube, iron (III) oxide and sample 44.979 8 Mass of test tube and contents after heating 44.8488 Volume of water displaced Barometric pressure 976 mbar Temperature of water temperature of O, 23 Vapor pressure of water at this temperature 21.068_mm...

  • Experiment 9 Analysis of an Antacid using the ideal gas law. Calculations: 1) Find moles of...

    Experiment 9 Analysis of an Antacid using the ideal gas law. Calculations: 1) Find moles of CO2 2) Find moles of NaHCO3 3) Find mass of NaHCO3 4) Find mass % of NaHCO3 5) Find average mass % NaHCO3 in Alka-Seltzer Sheet 23° torr Atmospheric pressure, mmHg 755.0 Temperature of H,O, "C Vapor pressure of H.O at this temperature 21.1 Calculated pressure of CO, in the system, mmHg 733.9 Balanced reaction of NaHCO, and HCl (see Pre-Laboratory Question 4a) =...

  • Please answer all the blanks (volume if H2 and everything in analysis). TIA! Data 5 1...

    Please answer all the blanks (volume if H2 and everything in analysis). TIA! Data 5 1 oong 0.00 10.5ml 2 o.olag 0.00 11.0 Trial 3 o.org 0.00 12.00 o Daag o.albg 0.00 10.0 ml 11.5ml Mass of Mg (g) Initial volume of Syringe (mL) Final volume of Syringe (mL) Volume of H (mL) Barometric pressure (torr) Ambient temperature (°C) Vapor pressure of H2O (torr) 779.314har 23. Oi 21.0 forr TA.314tar 23.0c 179.3 14ton 23.0¢ 779.314 ton 23.0c 779.31472 23.0c 21.0...

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT