Homework Answers
Draft = W/(lby)
Where, y(water) = 62.4 lbf/ft^3
= 200000/(20*40*62.4)
= 4 ft
Draft = 4 ft < 8 ft
The barge will float stable.
Add Answer to:
Problem 5 A barge 20 ft wide and 40 ft long is loaded with rocks as...
5. A rectangular barge is 128 ft long, 30 ft wide, and 18 ft deep, and...
5. A rectangular barge is 128 ft long, 30 ft wide, and 18 ft deep, and it weighs 544 tons when empty. The barge light weight may be assumed uniformly distributed over its length. It is divided into four holds of equal lengths. Cargo is loaded into each hold as follows, stowed uni formly and level in each hold: Hold #1 Hold #2 Hold #3 Hold #4 192 tons 224 tons 272 tons 176 tons Construct weight, buoyancy, load, shear,...
6. A tank 20 ft long and 10 ft deep is 8 ft wide at the...
6. A tank 20 ft long and 10 ft deep is 8 ft wide at the bottom and 18 ft wide at the top. In the bottom is an orifice having an area of 24 84 0.61? in. and å coefficient of discharge of 0.60. If the tank is full at the begin. ning, how long will it take to lower the water surface 6 ft? T
(1 point) Book Problem 9 A heavy rope, 20 ft long, weighs 0.9 lb/ft and hangs...
(1 point) Book Problem 9 A heavy rope, 20 ft long, weighs 0.9 lb/ft and hangs over the edge of a building 130 ft high a) How much work is done in pulling the rope to the top of the building? Work ft-lb. a) How much work is done in pulling half the rope to the top of the building? Work ft-lb. (1 point) Book Problem 15 An aquarium 10m long, 5m wide, and 9m deep is full of water....
A swimming pool is 20 ft wide and 40 ft long and its bottom is an inclined plane, the shallow end having a depth of 3 ft...
A swimming pool is 20 ft wide
and 40 ft long and its bottom is an inclined plane, the shallow end
having a depth of 3 ft and the deep end, 10 ft. Assume the pool is
full of water. (Round your answers to the nearest whole number.
Recall that the weight density of water is 62.5 lb/ft3.)
swimming pool is 20 ft wide and 40 ft long and its bottom is an inclined plane, the shallow end having a...
Problem 5 (20 %) The beam below was loaded with uniform load of 3kip/ft. Using the...
Problem 5 (20 %) The beam below was loaded with uniform load of 3kip/ft. Using the Muller-Breslau principle draw the influence lines for bending moment at critical points G and just right of B, considering a unit moving load. (G is located at the mid-span of AB). Calculate the maximum magnitude bending moment at B and at G if a) the uniform load of 3kip/ft is live and b) the uniform load of 3kip/ft is dead. NOTE: Dead loads are...
0.2 Ft/sec. 3. Castor oil At 100,0F flows OVER A wide 20. for LONG heated plate....
0.2 Ft/sec. 3. Castor oil At 100,0F flows OVER A wide 20. for LONG heated plate. At The plate SURFACE temperature is 2000F. bis properties are p=595 kom lc = 0.123 BT / RETF, 5=7x10 25 2.8x103A%, Pe= 900. Findeed hydandymanie Bouwdary Layer thickness At End of the phate) And ) the smal lovundary layer thickness At End of the PLATE,
Problem 5: Design of Idealized Compression Member A 20-ft long column is pinned at the bottom...
Problem 5: Design of Idealized Compression Member A 20-ft long column is pinned at the bottom and fixed against rotation, but free to translate, at the top. It must support a service dead load of 110 kips and a service live load of 110 kips. a) Select the lightest W12 of A992 steel. Use the column load tables b) Select the lightest W18 of A992 steel. Use the trial-and-error process.
Problem 15.28 (Multistep) A strip of invisible tape 0.15 m long by 0.017 m wide is...
Problem 15.28 (Multistep) A strip of invisible tape 0.15 m long by 0.017 m wide is charged uniformly with a total net charge of 5 nC (nano 1 x10- and is suspended horizontally, so it lies along the axis, with its center at the origin, as shown in the figure below. Calculate the approximate electric field at location <0, 0.07, 0> m (location A) due to the strip of tape. Do this by dividing the strip into three equal sections,...
Problem Description A 20 m wide, 2km long, and Im thickness embankment should be constructed for...
Problem Description A 20 m wide, 2km long, and Im thickness embankment should be constructed for a railway project in Melbourne city. The required soil for the embankment construction will be transported from a borrow pit located in a rural site. The borrow pit has loosely compacted sandy loam soil. Porosity of this borrow pit's soil is 0.40 and the specific gravity is 2.7. Part A; In order to maintain the stability of the railway project the embankment needs to...
Problem 1 (40%) A thin rectangular plate is 6 meters long and 0.8 meter wide. The...
Problem 1 (40%) A thin rectangular plate is 6 meters long and 0.8 meter wide. The plate is submerged (both sides) and held stationary in a stream of water (T = 10°C) that has a velocity of 0.5 meters/second. a) (5%) What is the boundary layer thickness at a distance x = 0.5m downstream of the leading edge? b) (5%) What is the shear stress on the plate at the same point? c) (10%) What is the friction drag on...
5. A rectangular barge is 128 ft long, 30 ft wide, and 18 ft deep, and it weighs 544 tons when empty. The barge light weight may be assumed uniformly distributed over its length. It is divided into four holds of equal lengths. Cargo is loaded into each hold as follows, stowed uni formly and level in each hold: Hold #1 Hold #2 Hold #3 Hold #4 192 tons 224 tons 272 tons 176 tons Construct weight, buoyancy, load, shear,...
6. A tank 20 ft long and 10 ft deep is 8 ft wide at the bottom and 18 ft wide at the top. In the bottom is an orifice having an area of 24 84 0.61? in. and å coefficient of discharge of 0.60. If the tank is full at the begin. ning, how long will it take to lower the water surface 6 ft? T
(1 point) Book Problem 9 A heavy rope, 20 ft long, weighs 0.9 lb/ft and hangs over the edge of a building 130 ft high a) How much work is done in pulling the rope to the top of the building? Work ft-lb. a) How much work is done in pulling half the rope to the top of the building? Work ft-lb. (1 point) Book Problem 15 An aquarium 10m long, 5m wide, and 9m deep is full of water....
A swimming pool is 20 ft wide
and 40 ft long and its bottom is an inclined plane, the shallow end
having a depth of 3 ft and the deep end, 10 ft. Assume the pool is
full of water. (Round your answers to the nearest whole number.
Recall that the weight density of water is 62.5 lb/ft3.)
swimming pool is 20 ft wide and 40 ft long and its bottom is an inclined plane, the shallow end having a...
Problem 5 (20 %) The beam below was loaded with uniform load of 3kip/ft. Using the Muller-Breslau principle draw the influence lines for bending moment at critical points G and just right of B, considering a unit moving load. (G is located at the mid-span of AB). Calculate the maximum magnitude bending moment at B and at G if a) the uniform load of 3kip/ft is live and b) the uniform load of 3kip/ft is dead. NOTE: Dead loads are...
0.2 Ft/sec. 3. Castor oil At 100,0F flows OVER A wide 20. for LONG heated plate. At The plate SURFACE temperature is 2000F. bis properties are p=595 kom lc = 0.123 BT / RETF, 5=7x10 25 2.8x103A%, Pe= 900. Findeed hydandymanie Bouwdary Layer thickness At End of the phate) And ) the smal lovundary layer thickness At End of the PLATE,
Problem 5: Design of Idealized Compression Member A 20-ft long column is pinned at the bottom and fixed against rotation, but free to translate, at the top. It must support a service dead load of 110 kips and a service live load of 110 kips. a) Select the lightest W12 of A992 steel. Use the column load tables b) Select the lightest W18 of A992 steel. Use the trial-and-error process.
Problem 15.28 (Multistep) A strip of invisible tape 0.15 m long by 0.017 m wide is charged uniformly with a total net charge of 5 nC (nano 1 x10- and is suspended horizontally, so it lies along the axis, with its center at the origin, as shown in the figure below. Calculate the approximate electric field at location <0, 0.07, 0> m (location A) due to the strip of tape. Do this by dividing the strip into three equal sections,...
Problem Description A 20 m wide, 2km long, and Im thickness embankment should be constructed for a railway project in Melbourne city. The required soil for the embankment construction will be transported from a borrow pit located in a rural site. The borrow pit has loosely compacted sandy loam soil. Porosity of this borrow pit's soil is 0.40 and the specific gravity is 2.7. Part A; In order to maintain the stability of the railway project the embankment needs to...
Problem 1 (40%) A thin rectangular plate is 6 meters long and 0.8 meter wide. The plate is submerged (both sides) and held stationary in a stream of water (T = 10°C) that has a velocity of 0.5 meters/second. a) (5%) What is the boundary layer thickness at a distance x = 0.5m downstream of the leading edge? b) (5%) What is the shear stress on the plate at the same point? c) (10%) What is the friction drag on...
Most questions answered within 3 hours.
-
Write a program to solve the Josephus problem, with the following
modification:
Sample Input:
./a.out n...
asked 2 hours ago -
At the start of a CD it is spinning at a rate of 525 rpm
(revolutions...
asked 2 hours ago -
4. Without doing any calculations, predict whether the observed
∆T would increase, decrease or remain the...
asked 4 hours ago -
Based on the range, which of the following sets of scores has
the greatest variability? 3,...
asked 5 hours ago -
Ripples in a pond travel at a velocity of 3 m/s with one peak
passing a...
asked 5 hours ago -
A man stands on the roof of a building of height 13.0 mm and
throws a...
asked 5 hours ago -
The extent to which assets are financed by borrowed funds and
other liabilities is indicated by:...
asked 6 hours ago -
Explain in detail
Germany is the fifth largest economy
explain what goods and services Germany specializes...
asked 6 hours ago -
The density of platinum is 21.45 g/mL. If a cube of platinum
with a mass of...
asked 6 hours ago -
Accounts Receivable
Sales
A/R Posting
Extended Sales Invoice
Packing Slip
Compare invoice to packing slip 2...
asked 6 hours ago -
Michaella, age 23, is a full-time law student and is claimed by
her parents as a...
asked 6 hours ago -
Why are polymers not typically casted into products?
asked 6 hours ago