Determine the maximum number of 50 w/100 v light bulbs that can be connected together in...
Determine the maximum number of 50 w/100 v light bulbs that can be connected together in parallel so as not to burn out a 15 A fuse when the bulbs are powered by a 75 v source (assume that the resistance of the fuse is negligible).
A.40
B.30
C.20
D.10
Homework Answers
Add Answer to:
Determine the maximum number of 50 w/100 v light bulbs that can
be connected together in...
(a) What is the resistance of ten 100-W light bulbs connected in parallel? (b) in series?...
(a) What is the resistance of ten 100-W light bulbs connected in parallel? (b) in series? The resistance of a 100-W, 120-V light bulb is 144 Ohms.
How many 34-W light bulbs, connected to 120 V battery in parallel , can be used...
How many 34-W light bulbs, connected to 120 V battery in parallel , can be used without blowing a 12-A fuse?
several 60 w light bulbs are connected in parallel to a 120 v source. the circuit...
several 60 w light bulbs are connected in parallel to a 120 v source. the circuit has a circuit breaker cb that is placed right after the battery that interrupts the current through itself whenever that current exceeds 9 A. Calculate the largest number of bulbs that can glow together.
The powers of two light-bulbs are 40 W and 115 W when connected in parallel across...
The powers of two light-bulbs are 40 W and 115 W when connected in parallel across a 110-V source. What is the power of the bulb that will output less power when the two light-bulbs are connected in series with the same source?
The powers of two light-bulbs are 60 W and 125 W when connected in parallel across...
The powers of two light-bulbs are 60 W and 125 W when connected in parallel across a 130-V source. What is the power of the bulb that will output less power when the two light-bulbs are connected in series with the same source?
A 100-W light bulb is connected to a 110-V source. What is the resistance of this bulb
A 100-W light bulb is connected to a 110-V source. What is the resistance of this bulb?a) 121 Ob) 8.00 x 10-3 Oc) 6.00 x 10-3 Od) 242 Oe) 100 O
Three 70.0-W, 130-V lightbulbs are connected across a ΔV = 130-V power source, as shown in...
Three 70.0-W, 130-V lightbulbs are connected across a
ΔV = 130-V power source, as shown in the figure below.
Find the total power delivered to the three bulbs and the potential
difference across each. Assume the resistance of each bulb is
constant (even though, in reality, the resistance increases
markedly with current).
An open circuit begins at a terminal with a wire extending
horizontally rightwards until it reaches a lightbulb
R1. After the light bulb, the wire splits
downwards into...
a.When two resistors RA and RB are combined in series and connected to a battery it...
a.When two resistors RA and RB are combined in series and connected to a battery it is observed that the ratio of the power dissipated in RA to that dissipated in RB is equal to 10. If this arrangement is dismantled and the same two resistors connected in parallel to the same battery, what is the ratio of the power dissipated in RA to that dissipated in RB in this new circuit? b.How much energy is converted by a 12...
If a l V rms signal source with an internal resistance of 50 Ω is connected...
If a l V rms signal source with an internal resistance of 50 Ω is connected to the amplifier in Figure what is the actual rms signal applied to the amplifier input? Assume Bac 200 +15 V RI 1.0 kΩ 01 Di C3 02 75 Ω 1.0 kΩ Class C Power Amplifiers A certain class C amplifier transistor is on for 10 percent of the input cycle. If Veetsa) 0.18 V and Ie(sa)25 mA, what is the average power dissipation...
Q5/// The maximum power dissipated in a 40 load is 100 w when connected to a...
Q5/// The maximum power dissipated in a 40 load is 100 w when connected to a d.c. voltage V and internal resistance R. Calculate: the current in the load, internal resistance .R, and voltage V Q3/11 Some copper wire has a resistance of 200 Ohm at 20-C. A current is passed through the wire and the temperature rises to 90°C. Determine the resistance of the wire at 90°C, assuming that the temperature coefficient of resistance *.is 0.004/-C at 0°C
Three 70.0-W, 130-V lightbulbs are connected across a
ΔV = 130-V power source, as shown in the figure below.
Find the total power delivered to the three bulbs and the potential
difference across each. Assume the resistance of each bulb is
constant (even though, in reality, the resistance increases
markedly with current).
An open circuit begins at a terminal with a wire extending
horizontally rightwards until it reaches a lightbulb
R1. After the light bulb, the wire splits
downwards into...
If a l V rms signal source with an internal resistance of 50 Ω is connected to the amplifier in Figure what is the actual rms signal applied to the amplifier input? Assume Bac 200 +15 V RI 1.0 kΩ 01 Di C3 02 75 Ω 1.0 kΩ Class C Power Amplifiers A certain class C amplifier transistor is on for 10 percent of the input cycle. If Veetsa) 0.18 V and Ie(sa)25 mA, what is the average power dissipation...
Q5/// The maximum power dissipated in a 40 load is 100 w when connected to a d.c. voltage V and internal resistance R. Calculate: the current in the load, internal resistance .R, and voltage V Q3/11 Some copper wire has a resistance of 200 Ohm at 20-C. A current is passed through the wire and the temperature rises to 90°C. Determine the resistance of the wire at 90°C, assuming that the temperature coefficient of resistance *.is 0.004/-C at 0°C
Most questions answered within 3 hours.
-
A college student is employed as a door-to-door newspaper
salesman. Historical data suggests that the student...
asked 31 minutes ago -
MATLAB HW 11 problem using Switch Case and Input commands
Write a script file that calculates...
asked 16 minutes ago -
Considering gravitational time dilation, calculate the time that
passes in Earth’s surface while 1 hour passes...
asked 55 minutes ago -
Minitab Problem: Take the Lake Hume June rainfall data and find
use the processes outlined in...
asked 1 hour ago -
X Company is trying to decide whether to continue using old
equipment to make Product A...
asked 1 hour ago -
IN PYTHON ONLY !! Program 2: Re-work
program #5 (WeeklyHours) from the previous assignment such that...
asked 2 hours ago -
The average length of time between arrivals at a turnpike
toll-booth is 26 seconds. What is...
asked 4 hours ago -
(a) A piston at 6.1 atm contains a gas that occupies a volume of
3.5 L....
asked 5 hours ago -
Please answer true or false. Words
cannot be changed or added in to make it true...
asked 5 hours ago -
An empty test tube weighs 15.923 grams. Then,
MgCl2•6H2O is added into the test tube. After...
asked 5 hours ago -
Assume memory access is 10 units of time and disk access is
10000 units of time....
asked 5 hours ago -
1. Are all good samples random?
2. Magazines often report surveys giving statistics such as “63%...
asked 5 hours ago