3. A student pipetted 25.00 mL of a 0.2531 M solution of HCl into an Erlenmeyer...
A titration of 25.00 mL of O.1550 M HCl solution with a solution of NaOH of unknown molarity starts at a buret reading for NaOH of 0.33 mL The phenolphthalein indicator turns light pink the acid solution for over 30 seconds at a buret reading of 24.19 mL 2) What was the volume of HCl you started with? 3) How many moles of HCl were in the original solution? 4) Write the balanced chemical equation for the titration reaction. 5)...
A titration of 25.00 mL of an acetic acid solution with 0.1220 M NaOH solution starts at a burette reading for NaOH of 0.17 mL. The phenolphthalein indicator turns light pink in the acid solution for over 30 seconds at a burette reading of 36.32 mL. The volume of NaOH used to neutralize the acid is _______ mL.
A student titrates 25.00 mL of HCl(aq) with standard NaOH(aq) solution, requiring 33.72 mL of 0.2014 M NaOH to reach the end point. Calculate the molarity of the HCl(aq) solution.
1.If 23 ml of 2.0 M NaOH was required to neutralize 10.0 ml of HCl, what is the molarity of the HCl? 2.What volume (in L) of a 2.08 M NaOH solution is required to neutralize 0.53 mol of HCl? *Remember to report your answer using the proper significant digits. 4.A student has finished the titration of a sample of HBr of unknown concentration with 0.2 M NaOH. The student notices small drops of unreacted NaOH were left on the...
please write out calculations for each box missing an answer data the experiment Record For the lab report, attach this data sheet (signed by your TA) to your calculations page. REPORT ALL VALUES TO AT LEAST THREE SIGNIFICANT FIGURES. READ YOUR BURETTE TO THE NEAREST 0.05 mL increment. for on this sheet. Do your calculations on a separate piece of paper. Part One-Standardization of a NaOH solution of approximately 0.1 M. Trial 1 | Trial 2 | Trial 3 Mass...
stion 62 of 65 > The flask contains 10.0 mL of HCl and a few drops of phenolphthalein indicator. The buret contains 0.320 M NaOH. It requires 19.4 mL of the NaOH solution to reach the end point of the titration. What is the initial concentration of HCI? CH concentration: 1.6 M HCI Incorrect 63 of 65 > A barium hydroxide solution is prepared by dissolving 1.67 g of Ba(OH), in water to make 33.6 mL of solution. What is...
4 pt Question 18 A student titrates 25.00 mL of HCl(aq) with standard NaOH(aq) solution, requiring 33.72 mL of 0.2014 M NaOH to reach the end point. Calculate the molarity of the HCl(aq) solution. 1 pts Question 19 In the titration problem above, how many signincant digits should your answer contain?
Procedure 1. Arrange the burette and other equipment as shown in Figure 1. Use a 250-ml Erlenmeyer flask for the titration 2. Fill the burette with NaOH solution using a funnel. (Wear goggles and gloves!) Record the concentration (molarity) of the base in the Data Table on the Worksheet. 3. Measure out 100 mL of flat Mountain Dew in a graduated cylinder and transfer it to the 250-ml Erlenmeyer flask. (If you will be using a magnetic stirrer, place a...
11.83 mL of 0.5008 M NaOH was required to neutralize 25.00 mL of HCl with unknown molarity. How many moles per liter of NaOH was used?
1.639 g of an unknown diprotic acid are used to make a 100.00 mL solution. Then 25.00 mL of this solution is transferred to an Erlenmeyer flask and is titrated with 0.1032 M NaOH. The titration endpoint is reached after 0.00414 mol of NaOH is added using the burette. What is the molar mass of the diprotic acid? Provide your answer to the correct number of significant figures.