Question

IME 258 Manufacturing Methods and Materials I Owsmall Homework 3 From Fundamentals of Modern Manufacturing, Se (published by Wiley) O MPGroover 2012, with selected additional exercises. e data st test s ocodo nsdf owoy no titge mengog ail 4. Write a part program that will make an end mill cut the curved slot shown below. The end mill should enter the slot at point (x,y) = (3 in, 0 in), cut with a depth of cut 0.1 in until point (x.y)= (-3 in, 0 in), and cut with a depth of cut 0.1 in back to (x,y)= (3 in, 0 in). The feed 20 in/min and the spindle speed 1000 rpm. The radius of curvature of the center line of the slot is 12 in. What are the coordinates of the center point of the center line of the slot? Assume the tool has a diameter equal to the width of the slot. sibnige y 3 in, 0 in -3 in, 0 in hou X Note: The plane of the figure is at height z= 0. Cut into the page.

Answer 1

(3,6) Co,o) ake absaluto made 20 GRO G12 G 90 puating fogin at (o,0,) Xo Yo ze G92 S1000 M3 X 3 G00 NO2 Cut (o) Gol Z-I NO 3 Hord rate Ro F20 RI2 GO3 メー6 hON Gol NOS R12 X+6 Go2 Nob to the paint (3, o) ol Z +1.2 No2 N08 No9 progtam and rauind M 30 135 144-9 VI44-9 OB 1162 inch Contr coordinate To, -11-63, 7