Question 4 It is estimated that a particular aluminium component has been exposed to the following...
Question 1 An end capped cylindrical pressure vessel with internal pressure p = fully supported at one end, is also subjected to a force F= 10 kN in the y direction at the other end as shown. The internal diameter of the pressure vessel is d= 160 mm and its thickness is t= 10 mm 3 MPa, assumed to be Determine the magnitudes of the stress components in x, y and z coordinates at points H and K and sketch...
Q6. (a) Three identical fatigue specimens (denoted A, B and C) are fabricated from a non-ferrous alloy. Each is subjected to one of the maximum- minimum stress cycles listed in Table 26 (the frequency is the same for all tests) Table 26 Specimen Omax (MPa) Omin (MPa) A +450 -150 +300 -300 +500 -200 Rank the three specimens in terms of their fatigue lifetimes (highest to lowest). Justify this ranking [5 marks] (b) A cylindrical tie rod of diameter 20...
(a) Part 1-7 6) Leeding Digun The figure shows the tentative design of a cantilevered machine component, and the corresponding loading diagram. The component resists a load P varying from 0 to 3400 1bs., for an infinite number of cycles at ambient room tem- perature and 95% reliabilfity. The part is machined from cold drawn steel with an ultimate strength of S 64 kpsi and a yield strength S, = 54 kpsi. con for the part, if the stress c...