Answer:
A reducing pipe bend in place by a pedestal s shown in the below figure.
A reducing pipe bend is held in place by a pedestal as shown. There are expansion...
Can I get a solution for this question about fluid
mechanics?
It is hard to solve
30 This 30 vertical bend in a pipe with a 2.5 ft diameter carries water (p 624 lbm/t) at a rate of 31.4 cfs. If the pressure p, is 10 psig at the lower end of the bend, where the elevation is 100 ft, and is 8.5 psig at the upper end, where the elevation is 103 ft, what will be the vertical component...
A construction equipment accident cut the pipe bend shown. Gasoline (S = 0.75) discharges to the atmosphere at a steady rate of 65 ft3/s. Open pipe Area 0.5 ft2· (a) Sketch the appropriate diagrams and set up the equations to analyze the total force (z-and x-components) thatthe flange must ·ý esupply to hold the pipe bend in place. 120 (b) Calculate the z- and x-components of force. Assume that the volume of fluid in the pipe section shown is 2...
As shown in the figure we are dealing with a pipe system in which there are 125 ft of 2-in pipe, 75 ft of 6-in pipe, and 150 ft of 3-in pipe, all cast iron. There are two 90° elbows and an open globe valve. If the exit elevation is zero, what horsepower is extracted by the turbine when the flow rate is 0.16 ft3/s of water at 20°C? Elevation 100 sudden expansion from 2" to 3": KL =0.79 2...
Water is flowing through a horizontal pipe with diameter, D1, at
a velocity, V1, and under a pressure, P1. It enters a 900 reducing
bend (Shown in grey in Fig 2) that connects to a vertical pipe of
diameter, D2. The inlet of the bend is 50 cm above the exit of the
bend (as shown in Fig 2). Axes for positive directions of x and z
coordinates are provided. Figure 2 Side view of reducing bend from
horizontal to...
The water pump, as shown in the figure below, maintains a
pressure of 6.5 psig at point 1. There is a filter, a half-open
disk valve, and two regular screwed elbows. There are 80 ft of
4-inch diameter commercial steel pipe. For water, take ρ = 1.94
slug/ft3 and μ = 2.09E−5 slug/ft⋅s. Take kvalve ≈ 2.8, kelbow ≈
0.64, kexit ≈ 1, and kvalve ≈ 0 (when the disk valve wide open). If
the flow rate is 0.55 ft3/s,...