"2-8. The wire AB is unstretched when θ--45°. If a load is applied to the bar AC, which causes 0 to become 47 determine the normal strain in the wire.
Express your answer using three significant figures. Review VAEc ? The force applied at the handle of the rigid lever causes the of le The wires are unstretched when the lever is in the 2.4 horizontal position. (Figure 1) (CAHA mm/mm Request Answer Submit Part B wire CG. Determine the average normal strain developed Express your answer using three significant figures. vec AE ww (eccg mm/mm Request Answer Submit Figure 1 of 1 Part C wire DF. Determine the average...
2-9. If a horizontal load applied to the bar AC causes point A to be displaced to the right by an amount AL, determine the normal strain in the wire AB. Originally, 0 45 Probs. 2-8/9
If a horizontal load applied to the bar AC causes point A to be displaced to the right by an amount A L, determine the normal strain in the wire AB. Originally, theta = 45 degree.
The allowable tensile stress for wires AB and AC is allow = 175 MPa, and wire AB has a diameter of 5.6 mm and AC has a diameter of 6.6 mm. WA Part A Determine the greatest force P that can be applied to the chain. Express your answer to three significant figures and include appropriate units. UA ? Pmax = Value Units Submit Request Answer
Part of a control linkage for an airplane consists of a rigid member CB and a flexible cable AB BO 900 mm Originally the cable is unstretched. Part A If a force is applied to the end B of the member and causes it to rotate by B=0.35°, determine the normal strain in the cable. Express your answer to three significant figures. VALOlt veco ? mm/mm Submit Request Answer
Bar AB has the angular motions shown. Suppose that WAB = 5 rad/s and a AB = 6.6 rad/s2. (Figure 1) Part A Determine the velocity of the slider block C at this instant Express your answer to three significant figures and include the appropriate units. ? (vc. = Value Units Submit Request Answer Part B Figure < 1 of 1 Determine the acceleration of the slider block C at this instant. Express your answer to three significant figures and...
Problem 3.24 4 of 8> Part A The wires AB and BC have original lengths of 2 ft and s ft, and diametefn. andin respecivey (Figure 1) 16 If these wires are made of a material that has the approximate stress-strain diagram shown (Figure 2), determine the elongation of the wire AB after the 1620-lb load is placed on the platform. Express your answer to three significant figures and include the appropriate units. AB63.27 ksi SubmitP Previous Answers Request Answer...
Part A -Normal Strain at a Specified Point Consider the pre-deformation cross-section of a bar, a side view of which is shown in the figure below The dia meter of the bar is d- 120 mm. A bending moment is applied that causes the neutral axis to become conca o up. What is the normal strain h Express your answer to three significant figures. View Available Hint(s) 20 mm from the bottom of the bar if the radius of curvature...
Problem 4.38 Part A The load in (Figure 1) of 2490 lb is to be supported by the two vertical steel wires for which oy = 68 ksi. Originally wire AB is 60 in. long and wire AC is 60.04 in. long. Each wire has a cross-sectional area of 0.02 in2. Est = 29.0(103) ksi. Determine the force developed in wire AB after the load is suspended. Express your answer to three significant figures and include appropriate units. TAB =...