If a steel cylindrical specimen is stressed nominally to 58 MPa, what stress level exists at the tip of an elliptical surface flaw, whose length is 6.3 microns and radius of curvature is 1092 nanometers ?
If a steel cylindrical specimen is stressed nominally to 58 MPa, what stress level exists at...
What is the magnitude of the maximum stress that exists at the tip of an internal crack having a radius of curvature of 4 × 10-4 mm (1.575 × 10-5 in.) and a crack length of 3 × 10-2 mm (1.181 × 10-3 in.) when a tensile stress of 160 MPa (23210 psi) is applied?
Chapter 9 1. What is the magnitude of the maximum stress that exists at the tip of an internal crack having a radius of curvature of 2.5 x 10-4 mm (10-5 in.) and a crack length of 2.5 x 10-2 mm (10-3 in.) when a tensile stress of 170 MPa (25,000 psi) is applied? 2. A large plate is fabricated from a steel alloy that has a plane strain fracture toughness of 55 MPa m (50 ksi in.). If the plate is...
The theoretical failure strength of high-purity and fully-dense aluminum oxide (Al2O3, alumina) can be up to 4 GPa ! In other words, a pristine alumina sample is expected to support this stress, even in tension, since no stress magnifying flaws would be present. Think about that for a second ... most metals yield (bend permanently) at stress levels on the order of 0.1 - 0.5 GPa ... and this is considered their upper limit for structural use. Ceramics like alumina...
1-Determine the % elongation, yield stress and ultimate tensile strength of the material tested above 2-Calculate the elastic modulus of the material tested above 3-If a 200mm cylindrical rod of the material tested above, with radius 20mm, was subjected to a tensile load of 200kN, what would the length be? 4-An underground wastewater steel pipe with 2mm walls carries an ammonia solution of 40 g/m3. The pipe is in contact with groundwater (assume 0 g/m3 ammonia). Determine the diffusion rate...