Day 7 Non-text: Ethanol is maintained at its boiling point (78.4°C) in a spherical container with...
In a food processing facility, a spherical container of inner radius n = 40 cm, outer radius r2 = 41 cm, and thermal conductivity k = 1.5 W/m 'C is used to store hot water and to keep it at 100°C at all times (see Figure Q2). To accomplish this, the outer surface of the container is wrapped with a 500-W electric strip heater and then insulated. The temperature of the inner surface of the container is observed to be...
Problem 2 (15 pts) A spherical container containing radioactive waste is thrown into the ocean waters maintained at 300 half of the container is made of stainless steel with a thermal conductivity of 15.1 W/mK. The convection coefficient has the same value of 555 W/m2 K with both lid and bottom. The inner radius of the co the container is 600 K (the same for the lid and may be assumed to have an infinite contact resistance. Assume that the...
Two large parallel plates with surface conditions approximating those of a blackbody are maintained at 800°C and 100°C, respectively. Determine the rate of heal transfer by radiation between the plates in Wim and the radiative heat transfer coefficient in W/m K ) 12 Write down the one-dimensional sent heal conduction equation for a plane wall with constant thermal conductivity and heat generation in its simplest form, and indicate what each variable represents 13 Write down the one-dimensional transient heat conduction...
Consider a spherical container of inner radius r1, outer radius r2, and thermal conductivity k. Express the boundary condition on the inner surface of thecontainer for steady one-dimensional conduction for the following cases:(i) specified temperature of 50°C,[2 Marks](ii) specified heat flux of 45 W/m2 toward the center,[2 Marks](iii) convection to a medium at T∞ with a heat transfer coefficient of h.[2 Marks]
Question You are studying heat transfer through a spherical shell container with a thermal conductivity k. The inner and outer radii are identified as a and b, respectively. The inside surface of the shell is exposed to a constant heat flux in the outward direction. The outside surface temperature of the container is measured at Note that only the variables values provided in the problem statement are known. Assume steady one-dimensional radial heat transfer a. Give the mathematical formulation of...
Problem 2. (20 pts) As shown in the figure, uniform generation occurs inside the spherical core with a radius n due to reactive heating at a rate of q 10 W/m3. The thermal conductivity of the reactive material is 20 Wm. K. The spherical shell 1Sr is made of stainless steel (s.s.) with a thermal conductivity k2 -15 W/m K. Given 0.5 m and k2 72=0.6 m, water flows outside to cool the s.s. shell at To-25°C and h =...
Heat transfer. I just need the right choice Qu Choose the correct answer was The handle of a saucepan, 30 (6 cm long and 2 cm in diameter is partially immersed in boling water at 100°C. The average unit conductance over the handle surface is 735 Wim2K in the kitchen air at 24C. The cook is likely to grasp the last 10 cm of the handle and hence, the temperature of this portion should not exceed 32C. What should be...
Chenical reaction, Figure 1: Two end of the rods are maintained at different temperatures A chemically reacting mixture is stored in a thin-walled spherical container of radius 1 200 mm, and the exothermic reaction generates heat at a uniform, but temperature-dependent volumetric rate of q exp( A/T ), where如= 500 W/m3. A = 75 K. and To IS the mixture teinperature in kelvins. The vessel is enclosed by an insulating material of outer radius r2, thermal conductivity k, and emissivity...
2. (10 points) A pharmaceutical fluid is sterilized by heating it from 25 to 75 °C as it moves at 0.2 m/s through a straight thin-walled stainless steel tube of 12.7-mm diameter that is 10 m long. A uniform heat flux is maintained by an electric resistance heater wrapped around the outer surface of the straight tube. The pharmaceutical fluid properties may be approximated as: p = 1000 kg/mº, cp = 4 kJ/kg-K, u = 2.102 kg/s-m, k = 1...
2 ICED WATER IN A SPHERICAL CONTAINER (10 POINTS) Troom = 30°C Iced water O , D; = 5 m 1.5 cm T = 0°C A 5-m-internal-diameter spherical tank made of 1.5-cm-thick stainless steel (k = 15 W/( m K )) is used to store iced water at 0°C. The tank is located in a room whose temperature is 30°C. The walls of the room are also at 30°C. Heat transfer between the outer surface of the tank and the...