The diameters of each solid segment are dAB=0.75 in., dec=1.5 in., and dcD=0.5 in. Draw all...
The diameters of each solid segment are dAB=0.75 in,
dBC=1.5 in, and dCD= 0.5 in. Draw all appropriate FBD and determine
the values of average normal stresses at points E and F. Indicate
Tension or Compression.
8 kip 5 kip 2 kip 6 kip А D 5 kip B C 2 kip E F
Statics problems
Question A2 The plane truss shown in Figure A2 is supported at points A and J. -30° and the external loads are Fi 1.5 kN and F 3 kN. Draw the free body diagram of the truss. Determine all the reactions at the supports or, if this is not possible, explain why. a) Calculate the internal forces in members CF, EH, GH and HI, stating whether they are in tension or compression. b) (12) Are members CF and...
Make sure to consider all parts of the
problem with detail and accuracy. Please show your work and
explain. Thank you!
A cylindrical wheel of uniform density with mass M=11kg and radius R= 2m rolls without slipping on an incline that makes an angle of 0 = 30° with the horizontal, as shown in the diagram; there is friction between the wheel and the ramp. A block of equal mass Mis sliding on a separate, frictionless incline, also forming an...
Figure 1 shows the layout of countershaft used to transmit power to a blower through a pulley drive (4-5). Pulley (driving sheave) 4 has a diameter of 125-mm and pulley (driven sheave) 5 has a diameter of 75 mm. Pulley 5 is mounted vertically below pulley 4 (as shown in the figure). Belt tension on the loose side is 20% of the tension on the tight side. A power of 7.5 kW is transmitted via the gear set (2-3) from...