using given data and required pressure balance we can find the required height
for any doubts write in comments
3. (10 points) A U-tube manometer (manometer fluid SG - 3.05) is connected to a closed...
3. (10 points) A U-tube manometer (manometer fluid SG = 3.05) is connected to a closed tank containing a storage liquid as shown in the figure below. The air pressure in the tank is 2.50 psig and the liquid in the tank is oil (SG = 0.865). The pressure at point A is 4.00 psig and x 2.0 ft. Determine: a) the depth of oil, z (ft), and b) the differential reading, h (ft), on the manometer. Open Air kd...
Pot eeeeeeeeeeeeee.pdf x + v Y FAQ BX 3 of 14 + O Fit to page IL Page view AV Read aloud Add notes OP A U-tube manometer (manometer fluid SG = 2.6) is connected to a closed tank containing a storage liquid as shown in the figure below. The air pressure in the tank is 3.00 psig and the liquid in the tank is oil (SG = 1.5). The pressure at point A is 6.0 psig and x= 1.0...
1.16 An inverted U-tube manometer containing oil (SG = 0.8) is connected to two vessels as shown in Fig. 1.16. The vessel on the left contains liquid carbon tetrachloride (density 1600 kg/m3), is closed and pressurised to 50 kPa (gauge). The vessel on the right contains water and is open to the atmosphere. Use the given data to determine the depth H of the liquid stored in the left vessel. Ans: 0.89 m Carbon tetrachloride 50 kPa 02 m Oil...
4 A U-Tube manometer is connected to a closed tank, shown below, containing oil a density of 800 kg/m², the pressure of the air above the oil being 6000 Pa, if the pressure at point A is 20 kPa and the manometer fluid has a relative density of 5, Assume x=0.6m. determine the following i. The depth of oil, Z ii. The differential reading, Z2 on the manometer. (5marks) Z2 Z A OIL 5 Explain about the steady and unsteady...
Q3) An inclined manometer tube is connected to two closed tanks as shown in the figure below where !-210 cm. A gage was used to measure the pressure at the center of tank A and the reading was 60 kPa. A barometer locates near the tanks reads 72 cm of mercury. Specific weight of water is 9.81 kN/m3 and specific gravity (SG) of mercury is 13.6. a) Find the gage pressure in the center of tank B. b) Find the...
Pipe A contains gasoline(SG=0.70) , pipe B contains oil(SG=0.90), and the manometer fluid is mercury. Determine the new differential reading if the pressure in pipe A is decreased 25 kPa, and the pressure in pipe B remains constant. The initial differential reading is 0.30 m as shown. Use unit weight of water = 9810 N/m3 0.4 m Oil 0.3 m , Merc Gasoline?
Question 3: A simple U-tube manometer is shown in Figure 2. One end of the U-tube is connected to the pipe A so that the pressure at A (PA) is to be measured. The other end is left to be open to the atmosphere. The U-tube contains a liquid (mercury with specific gravity slig-13.54) called the gage fluid, which does not mix with the fluid (water). If the reading of inside pipe A
A closed tank is filled with water and has a 4-ft-diameter hemispherical dome as shown in the figure below. A U-tube manometer is connected to the tank. Determine the vertical force of the water on the dome if the differential manometer reading is 7 ft and the air pressure at the upper end of the manometer is 13.6 psi. Setting up the manometer equation, I found the pressure in the closed tank to be 2894.4 lb/ft^2, but when doing the...
Problems in Fluid Pressure and Pressure Force 1. AU-tube manometer with mercury is connected to two points on an inclined pipe carrying water. There is an elevation difference of 4ft between the lower and upper points. If the mercury level difference between the two sides of the manometer is 20.3 inches, what is the pressure at the lower point in the pipe, if the pressure at the upper point is 17.5 psi? 2. A vertical semicircular disc of 2 m...
A closed tank is filled with water and has a 4-ft-diameter hemispherical dome as shown in Fig. P2.129. A U-tube manometer is connected to the tank. Determine the vertical force of the water on the dome if the differential manometer reading is 7 ft and the air pressure at the upper end of the manometer is 13.4 psi.