If the unmodulated current in the antenna load of an AM transmitter is 10 A, determine...
If the unmodulated current in the antenna load of an AM transmitter is 10 A, determine the increase in this current resulting from 80% modulation.
Homework Answers
Answer: The unmodulated current is 10A and modulation index is
.8. so apply the formula of current of increase in current as
I=Ic
1+.82/2
Detailed solution is attached here
Add Answer to:
If the unmodulated current in the antenna load of an AM
transmitter is 10 A, determine...
What is the total average power for a commercial AM transmitter with an unmodulated carrier power...
What is the total average power for a commercial AM transmitter with an unmodulated carrier power of 20 kW and 100% modulation? 20 kW 30 kW 53.34 kW 80 kW
A radio transmitter is connected to an antenna having impedance 8 + j40 Ω with a 50 coaxial cable. If the transmitter can deliver 30 W to the load, how much power is delivered to the antenna? a....
A radio transmitter is connected to an antenna having impedance 8 + j40 Ω with a 50 coaxial cable. If the transmitter can deliver 30 W to the load, how much power is delivered to the antenna? a. (10 Marks) b. Alossless 50 ohms transmission line is connected to unknown load impedance. Voltage measurements along the line reveal that the maximum and minimum voltage values are (1)volts and (V2 - 1)volts respectively. The distance at which maximum voltage is observed...
An ECE student decided to replace his radio transmitter and design a new one. He soon...
An ECE student decided to replace his radio transmitter and design a new one. He soon found out that the antenna current of his new transmitter, which is modulated to a depth of 72% by an audio signal, is equal to 14 A. It increase to 16.08 A as a result of simultaneous modulation by another audio signal. What is the modulation index of the second audio signal?
Problem 5 An antenna with a load impedance Z. = (73 + j42.5) 2 is connected...
Problem 5 An antenna with a load impedance Z. = (73 + j42.5) 2 is connected to a transmitter through a 50- 2 lossless transmission line. If under matched conditions (50-22 load) the transmitter can deliver 10 W to the load, how much power can it deliver to the antenna? Assume that Ze=Zo.
A transmitter antenna broadcasts a non-commercial FM signal having modulation index mf = 5 and carrier...
A transmitter antenna broadcasts a non-commercial FM signal having modulation index mf = 5 and carrier deviation Δfc = 40.5 kHz. Find the number of pairs of sidebands from Bessel’s table. What is the frequency separation between the sidebands? Find the bandwidth required to transmit the FM signal from parts a and b.
A tank circuit in a radio transmitter is a series RCL circuit connected to an antenna....
A tank circuit in a radio transmitter is a series RCL circuit connected to an antenna. The antenna broadcasts radio signals at the resonant frequency of the tank circuit. Suppose that a certain tank circuit in a shortwave radio transmitter has a fixed capacitance of 1.2 x 10-11 F and a variable inductance. If the antenna is intended to broadcast radio signals ranging in frequency from 4.6 MHz to 8.4 MHz, find the (a) minimum and (b) maximum inductance of...
In a broadcasting communication system, the transmitter power is 40 KW, the channel attenuation is 80...
In a broadcasting communication system, the transmitter power is 40 KW, the channel attenuation is 80 dB, and the noise power spectral density is 10-10 W/Hz. The message signal has a bandwidth of 104 Hz and a normalized message signal power of 0.2 Determine the output SNR if the modulation format of the signal is: (a) DSB-SC (b) SSB-SC (c) Conventional AM with a modulation index of 0.85. (d) FM with a frequency modulation index of 3
Assume that an AM transmitter is modulated with a video testing signal given by em(t) =...
Assume that an AM transmitter is modulated with a video testing signal given by em(t) = =20 + 60 sin (2πf1t), where f1 = 3.57 MHz. Let the carrier signal c(t) = Ac cos(2πfct), where Ac = 100 and fc = 100 MHz. The AM signal is fed into a 50-Ω load. (a) Derive an expression for the AM DSB-FC signal in time domain. (b) Construct the AM waveform, giving numerical values of the maximum amplitude, Amax and the minimum...
An AM receiver is tuned to broadcast station at 600 kHz. Calculate the image rejection in...
An AM receiver is tuned to broadcast station at 600 kHz. Calculate the image rejection in dB, assuming that the input filter consist of one tuned circuit with a Q of 40? An SSB system transmit a peak envelope power of 100 W into a 75 ohms load. The carrier signal is modulated by two tones, with frequencies 2 kHz and 3 kHz with equal magnitude and only the lower sideband is transmitted with a suppressed carrier. Determine the average...
Please show all the necessary steps to get the answers Answer Q5 A given DSB-LC transmitter...
Please show all the necessary steps to get the
answers
Answer
Q5 A given DSB-LC transmitter develops an unmodulated power output of 100W across a 50 ? resistive load. When a sinusoidal test tone with a peak amplitude of 5.0 V is applied to the input of the modulator, it is found that the average power output increases by 50% under these conditions. Determine (a) (b) (c) (d) (e) The average power output in each sideband. The modulation index. The...
A radio transmitter is connected to an antenna having impedance 8 + j40 Ω with a 50 coaxial cable. If the transmitter can deliver 30 W to the load, how much power is delivered to the antenna? a. (10 Marks) b. Alossless 50 ohms transmission line is connected to unknown load impedance. Voltage measurements along the line reveal that the maximum and minimum voltage values are (1)volts and (V2 - 1)volts respectively. The distance at which maximum voltage is observed...
Problem 5 An antenna with a load impedance Z. = (73 + j42.5) 2 is connected to a transmitter through a 50- 2 lossless transmission line. If under matched conditions (50-22 load) the transmitter can deliver 10 W to the load, how much power can it deliver to the antenna? Assume that Ze=Zo.
In a broadcasting communication system, the transmitter power is 40 KW, the channel attenuation is 80 dB, and the noise power spectral density is 10-10 W/Hz. The message signal has a bandwidth of 104 Hz and a normalized message signal power of 0.2 Determine the output SNR if the modulation format of the signal is: (a) DSB-SC (b) SSB-SC (c) Conventional AM with a modulation index of 0.85. (d) FM with a frequency modulation index of 3
Please show all the necessary steps to get the
answers
Answer
Q5 A given DSB-LC transmitter develops an unmodulated power output of 100W across a 50 ? resistive load. When a sinusoidal test tone with a peak amplitude of 5.0 V is applied to the input of the modulator, it is found that the average power output increases by 50% under these conditions. Determine (a) (b) (c) (d) (e) The average power output in each sideband. The modulation index. The...
Most questions answered within 3 hours.
-
A fossil is found to have a 14C level of 71.0% compared to
living organisms. How...
asked 32 seconds from now -
Many communist or socialist countries have a department that
addresses public health as well as the...
asked 1 minute ago -
the following questions are either true or false answers
1. The Central Limit Theorem allows one...
asked 1 minute ago -
The patient recovery time from a particular surgical procedure
is normally distributed with a mean of...
asked 7 minutes ago -
Human relations refer to the way a company arranges people,
jobs, and communications so that work...
asked 24 minutes ago -
Python Program: Design the logic for and implement a program
that merges the two files into...
asked 23 minutes ago -
The specific radiocarbon activity of a sample of wood is 6.25
gms dpm/gm of carbon. The...
asked 28 minutes ago -
An aqueous magnesium chloride solution is made by dissolving
6.96 moles of MgCl2 in sufficient water...
asked 30 minutes ago -
Ken believes the average age of men who come to get a haircut at
his barber...
asked 52 minutes ago -
(Ratio Analysis): Last year Co. XYZ had sales of $ 400,000, with
“cost of goods sold”...
asked 1 hour ago -
can someone please write the balanced chemical
equation for the synthesis of Bromoacetanilide
from;
aniline +...
asked 57 minutes ago -
1. If a corporation purchases land and building and subsequently
tears down the building and uses...
asked 1 hour ago