The solution of the given problem is given below
6. (5 points) The rigid har ABC is suspended from three steel wires as shown Cables...
3. The 6m x 6 m square steel plate shown is suspended at Aby three cables: AB, AC, and AD. If the tension in the hook AE is 40KN, determine the tension in each of the three cables. ZTE 40 KN A 4 m С В. 3 m х 3 m D 3 m 3 m V
The rigid bar DEF is supported by three wires as shown in the figure below. There is a concentrated load P at E. The wires are all made of steel with E 289809 MPa, a vield stress of 400 MPa, each has a cross-sectional area of 1000 mm2 and each has a length of 6m. The coefficient of thermal expansion α of the wires is 20x10-6 per℃ Write down the equation of compatibility for the elongations in the three wires....
A 3 m rigid bar AB is supported with a vertical translational spring at A and a pin at B The bar is subjected to a linearly varying distributed load with maximum intensity g Calculate the vertical deformation of the spring if the spring constant is 700 kN/m. (ans: 21.43 mm) 2. A steel cable with a nominal diameter of 25 mm is used in a construction yard to lift a bridge section weighing 38 kN. The cable has an...
The three-bar truss ABC shown in the figure has a span L = 3 m and is constructed of steel pipes having cross-sectional area A = 3900 mm and modulus of elasticity E = 200 GPa. A load P acts horizontally to the right at joint C. (a) If P= 500 kN, what is the horizontal displacement of joint B? (b) What is the maximum permissible load Pox if the displacement of joint B is limited to 2.5mm? 45 45°...
A rigid beam BCD is supported on a roller support at C (4m from B) and has two bars AB and DE attached at each end. The bars can carry either tension or compressive forces. The rigid beam carries a UDL of I kN/m across BC and a point load of P at D as shown in the figure above. The length of the two bars is 3000 mm. The elastic modulus of both bars is 200 GPa and the...
3- (SKMMIH3/SME2113) from plastic having modulus of elasticity, E-4.0GPa a) Bar ABCD shown in Figure Q3a is made The bar consists of three segments, AB, BC, and CD. Segment AB is hollow and segments BC and CD are solids If the shortening (contraction) of bar ABCD is limited to 4.0 mm, determine the maximum allowable force P to be applied at C. (8 marks) 90 mm ΟΙ 00 mm 1080 min PL 500 mm 250 mm 250 mm Figure Q3a...