-73.575 kPa is the gauge pressure at throat.
10. As shown in Figure 5.31, when water flows out of the water tank with a...
Water flows steadily from a large tank as shown in the figure. The height of water in the tank is H = 4 m represents the height from the centerline of the horizontal pipe to the surface of the water in the tank. The water flows out of the tank through a pipe with diameter of 4 cm. The stream of water flows through a bend (= 30 degrees, L = 2.88 m) and exits as a free jet through...
Water at 60°F flows from a large tank as shown in the figure below. Atmospheric pressure is indicated by the mercury barometer, where H is 30”. If viscous effects are neglected, at what height, h, of water in the tank will cavitation begin? Dz = 4 in. 1 De = 1 in. 1 De='2 in. Figure 3.83 John Way & Sons, Inc. All these
4. Water flows steadily in the vertical variable area pipe as shown in Figure 4. Determine the flowrate if the pressure in each section is as given in figure. (Assume that frictional losses are negligible and power 1000 kg/m) (20 pnt) alm Di= 100cm 4T 2m 15m Dz=50cm < Figure 4
y otEhsineering Problem 3 125 points): Water flows out of a upper pontion of the tank is filled with upper portion of the tank to measure the pressure of the gas where h pressurized tank and into the atmosphere as shown in Figure P3 below. The pressurized gas. A U-tube manometer is attached to the 50H cm. The tank has a rectangular cross section as shown in the figure, and the jet has a circular cross section of diameter d...
13.
3.6×10-3 m3 of water flows out every second from the orifice with a
diameter of d=50 mm installed on the side of the tank in Figure
5.34. The minimum cross-sectional area of the jet was d=40 mm.
Find the contraction coefficient ??, velocity coefficient ??, and
flow coefficient ? of this orifice.
with explaination please
46cm zot dt
a) Water flows out of a shower in a typical house at a rate of 20 liters/min. If this shower is fed through a pipe that is 2.1 cm in diameter and 18 m from the high-pressure water tank, what is the difference between the pressure in the tank and atmospheric pressure? Assume the tank is at the same height as the shower and assume an ideal fluid. Pa (b) What pressure difference is needed for an energy-efficient shower head,...
Water flows steadily from an open tank as shown in the figure.
The elevation of
point 1 is H = 13 m ,
and the elevation of points 2 and 3 is h = 2 m .
The cross-sectional area at point 2 is 0.00069 m 2
; at point 3, where the water is
discharged, it is 0.00158 m 2 . The
cross-sectional area of the tank is very large compared with the
cross-sectional area of the pipe. Find...
6. (Bonus question) In the experimental setup shown in Figure 6, water flows through soils 1 and 2 upward under constant head. Assume c-c as the datum. (1) Find the total and pressure heads at c-c; (2) If the head loss after flowing through Soil 2 is 30% of the total head difference, determine the total and pressure heads at b-b; (3) Given the coefficient of permeability of Soil 2 as 0.05 cm/sec, determine the rate of discharge; (4) Calculate...
In the figure, water flows through a horizontal pipe and then
out into the atmosphere at a speed v1 = 16.0
m/s. The diameters of the left and right sections of the pipe are
5.20 cm and 3.00 cm. (a) What volume of water
flows into the atmosphere during a 10 min period? In the left
section of the pipe, what are (b) the speed
v2 and (c) the gauge
pressure?
Question 1 In the figure, water flows through a...
QS: (20 marks) Salt water flows from the tank A through a hole of diameter 25 mm as shown in Figure Q5. Initially (time t-0) tank A contains salt water with a specific gravity of 1.15 and the tank B contains pure water. Each tank has a diameter of 2 m and an initial depth of 3 m Determine the specific gravity of the salt water in the lower tank as a function of time, from 0 to when tank...