II. (30 pts) The diatomic molecule CO has a vibrational wavenumber of 2170 cm 'and may...
thank you in advanced! Set 1: (50 pts) 1. (20 pts) The diatomic iodine anion (1:') has a vibrational frequency of approximately 110 cm Predict the total heat capacity of I, in the gas phase at 300 K. II. (30 pts) The diatomic molecule Co has a vibrational wavenumber of 2170 cm and may be treated as a quantized harmonic oscillator. 1. (10 pts) What is the energy of one photon of light which has the same frequency as CO...
The vibrational frequency of a CO molecule is 6.51x10135-1. What frequency of light is needed to excite this molecule from the v=0 vibrational state to the v=1 vibrational state, if it is treated as a harmonic oscillator? Report your frequency as a wavenumber, in units of cm-1. Question 4 1 pts The following table lists the frequency of light absorbed by several different molecules in order to excite their vibrational energy. molecule õ(cm-1) HBr 2649 HCI 2991 NO 1904 In...
10. In the vibrational rotational spectrum of a diatomic molecule, the second line of the P branch (J" = 2 = 1) is observed at 3100 cm and the third line of the R branch (J" = 2- )' = 3) is observed at 3160.cm! Assuming the molecule behaves as a rigid rotor and a harmonic oscillator, calculate the rotational constant (R) and the fundamental vibration wavenumber (V) for the molecule. Hint, you need two equations to solve for the...
Set 1: (50 pts) 1. (20 pts) The diatomic iodine anion (12") has a vibrational frequency of approximately 110 cm Predict the total heat capacity of 1, in the gas phase at 300 K.
Quantum, 1D harmonic oscillator. Please answer in full. Thanks. Q3. The energy levels of the 1D harmonic oscillator are given by: En = (n +2)ha, n=0. 1, 2, 3, The CO molecule has a (reduced) mass of mco = 1.139 × 10-26 kg. Assuming a force constant of kco 1860 N/m, what is: a) The angular frequency, w, of the ground state CO bond vibration? b) The energy separation between the ground and first excited vibrational states? 7 marks] The...
2. (10 pts) Hydrogen molecule bonded to a surface is acting as a quantized harmonic oscillator with a force constant of 300 Nm! What is the wavefunction of the photon whose energy matches the difference between these two energy levels? (10 pts=5 points for correct work shown, 2 points for the correct units, and 3 points for correct answer)
Atkins' Physical C... PZE.4 The force constant for the bond in CO is 1857 Nm . Calculate the vibrational frequencies (in Hz) of 'C', 'C', C'80, and 'C'80. Use integer relative atomic masses for this estimate. harmonic the integra and then u 0. (b) Calc section). (c 297 P7E.5 In infrared spectroscopy it is common to observe a transition from the v=0 to v= 1 vibrational level. If this transition is modelled as a harmonic oscillator, the energy of the...
2. The vibrational frequency of gaseous N O is 1904 cm. Assume this molecule is a harmonic oscillator 2.1 What is the energy of the electromagnetic wave corresponding to this vibrational frequency? 2.2 Calculate the force constant of "NO 2.3 Calculate the vibrational frequency of gaseous N O. The isotopic effect does not change the force constant of the harmonic oscillator. 2.4 When "N'O is bound to hemoglobin A (Hb or Hgb, the iron-containing oxygen-transport metalloprotein in the red blood...
8. (10 pts) (a) (6 pts) Suppose a system consists of N noninteracting, indistin guishable, identical particles and that each particle has available to it only two quantum electronic states, whose energies are 0 and a. Find expressions for z, Z and U. Note: Because we don 't consider translational energy here, so the 1/N! should be om itted when writing Z in terms of z (b) (4 pts) For NO, the ground electronic level and the first exited electronic...
(30) Given the equilibrium bond length of CO is 1.138, explore population fractions (Eq. 2) of the ground state and first 15 pure rotational excited states relative to the ground state (where {=0). Mathematica is recommended. Do this at 298 K and at 100 K. Comment on how the results differ compared to part a). 1) In the application of quantum mechanical and statistical mechanical principles to samples containing large numbers of species (e.g. macroscopic samples of molecules), there is...