Problem 1 (50): A 3100 lb car has a 5-speed manual transmission with i;= 3.22, 12...
Problem 1 (50): A 3100 lb car has a 5-speed manual transmission with in = 3.22, 1,2 = 2.15, 1,4 = 1.05, 1,5 = 0.68. The final drive ratio 3.08. The air drag coefficient is 0.29 and the front projected area is 22 square feet. The rolling resistance coefficient is 0.02 and the tire radius is 11 inches. The mass factor is 1.0. The drive train efficiency is 0.93. The engine wide-open-throttle output is shown in the figure. a) Determine...
Please help asap with this. I will rate with a thumbs up. Problem 1 (50): A 3100 b car has a 5-speed manual transmission with in = 3.22, 1,2 = 2.15, 1,4 = 1.05, 1,5 = 0.68. The final drive ratio 3.08. The ar drag coefficient is 0.29 and the front projected area is 22 square feet. The rolling resistance coefficient is 0.02 and the tire radius is 11 inches. The mass factor is 1.0. The drive train efficiency is...
13. Based upon the speed ratios given in a car owner's manual, compute the rotational speed of the engine shaft for the specifications below. Also determine the approximate required engine horse power (HP) at 55 mph. The following data is known: . Total coefficient of resistance = 0.09 Differential efficiency = 95% Automatic transmission efficiency = 88% Wheel diameter = 22.5 inches Loaded car weight = 3000 lb Differential speed ratio = 3.889 . 5 . Automatic transmission: 1st gear...
Could you please help with this. I will upvote the response. Problem: A 4-speed FWD AT is shown in the sketch. The numbers of teeth for the sun, planet and ring of the two planetary gear trains and of the final drive gears are shown in the sketch. The tire radius is 11 inches. The front projected area is 21ft and the air drag coefficient is 0.30. The roll resistance coefficient is 0.02. The transmission efficiency is 0.86. The vehicle...
Consider the pickup truck with the following specs: Vehicle dimensions and weight: Curb Weight Manual (lb.)- 8290 Front/Rear Axle Weights (lb.)- 4890/3400 Center of Mass Height (in)- 49 Wheelbase (in.) 172.40 Track Front (in.) 88.50 Track Rear (in.) -84.50 6 Speed Manual Transmission: st 5.79 2nd 3.30 3rd 2.10 4th .30 5th 1.00 Tires 225/70R20 Maximum Payload (lb.) 6120 Standard Towing (lb.) - 6000 Maximum Towing (Ib.) - 24,500 Max. trailer tongue load (lb.) 2500 6th 0.72 Final drive 4.88...
Could you please help I will upvote. Problem: The stick diagram of a RWD 5-speed MT is shown below. The final drive ratio is ia and the tire radius is R (ft.) a) Find the transmission ratios in forward and reverse gears in terms of the tooth numbers as labeled. b) What is the speed difference that needs to be synchronized in a 1-2 shift when the shift is made at a vehicle speed V (mph)? c) What is the...
A car weighing 13 kN has an engine with performance characteristics as shown in Figure 1 below. The car equipped with a 5-speed manual transmission system with 90% efficiency, final drive gear ratio (final drive) is 3.0. The equivalent weight of the rotating parts of driveline at 3500 rpm is 300 N with a radius of gyration of 10.1 cm. Each tyres is 66 cm in diameter with a radius of gyration of 25.2 cm and weighs 220.4 N. Each...