(b) A rectangular panel of width equal to 1 m is kept in place through the...
Figure 1: Configuration of the manometer system Figure 2, a triangular panel (with base B As shown in (b) submerged. When the depth of the water h reaches 6 m, the base of the submerged part of the triangular panel is B 4 m For this case, assume that the water temperature is 10°C and find: (i The resultant force on the panel due to pressure (ii) The location where this force acts. (ii) The force R needed to keep...
A homogeneous, 4-ft-wide, 14-ft-long rectangular gate weighing 800 lb is held in place by a horizontal flexible cable as shown in the figure below. Water acts against the gate, which is hinged at point A. Friction in the hinge is negligible. Determine the tension in the cable. 30 Keo Cable Water Gate 9.3ft14ft Hinge 1658.04 lb the tolerance is +/-2%
1. A gate, shown in Fig. Q1, is 1.5 m wide, is hinged at point A and rests against a wall at point B. The fluid is water and the free surface is open to the atmosphere. Calculate (G) the force on the gate due to pressure exerted by the water, and (ii) by taking moments about point A, the horizontal force exerted by the wall at point B. (10 marks) (15 marks) Pa I water 4.5 m 1.8 m...
The rectangle gate AB in Figure 1 is 1.5 m wide, is hinged at point B, and rest against a smooth wall at point A. Compute: (a) the pressure due to seawater at point A, (3 Marks) (b) the force on the gate due to seawater pressure, (5 Marks) C) the horizontal force P exerted by the wall at point A, and (7 Marks) (d) the reaction at the hinge B (5 Marks) Wall Seawater: 10,000 N/m 4.5 m А...
Gate AB in Figure A2 is a homogeneous mass of 180 kg, 1.2 m wide into the paper, hinged at A, and resting on a smooth bottom at B. All fluids are at 200 C. a) If the moment about the centre of gravity of a submerged plate at an angle e is defined as FYCP = Then show that this moment is given by [5marks] [3 marks b) Draw a diagram with all forces acting on the gate AB...
Please help me with both parts
b and c. I am confused
Constants A 9.00 m uniform beam is hinged to a vertical wall and held horizontally by a 5.00 m cable attached to the wall 4.00 m above the hinge, as shown in the figure below (Figure 1). The metal of this cable has a test strength of 1.10 kN , which means that it will break if the tension in it exceeds that amount. Part A What is...
The wall separates water and glycerin (p=120 kg/m^3). Consider a unit width of the rectangular panel AB when d=6ft. (a) Using the panel equations, determine F1, the hydraulic force (in lb) acting on the gate due to water? (b) Where is the line of action of F1 relative to point B in feet? (c) Using the panel equation, determine F2, the hydraulic force (in lb) acting on the gate due to glycerine? (d) Where is the line of action of...
1. The 100 kg weight on hydraulic lift (area = 0.6 m²) shown in figure. At points A, B C and D calculate the pressure. (Ywater=9810 N/m?) Hinge 2. a) Determine the resultant force acting on the inclined circular gate. b) Find the location of center of pressure. c) Calculate the minimum weight of the block that can open the gate. (Assume that gate is weightless) (a=80 cm, water 9810 N/m) 3. The length of submerged gate AB is 5...
on the Bate 2.37 A rectangular gate 1 m by 2m, is own in Figure P2.37. The gate separates water from air at atmospheric pressure. It is held shut by a force F. If the gate has a mass of 100 kg, find F. located in a wall inclined at 45°, as skh Figure P2.38 shows a very delicate balancing act. On one side of a weightless wedge Anid of density 2. If the wedge 2.38
Anooen tark has a vertical partion a dor one side contains gasoline with adensity ρ-880 kg/m, at a depth of 1.1 m, as shown in F empty side of the tank. At whar depth, A, will the gate start to open P2.99. Arectangla gate that is 1.1 high and 2 m wide and hinged at one end is located in the partition water is slowly added to the 1m us Figure P.299 Concepts: The pressure in a fluid is a...