A 120/240 volt, single-phase system is a system with its center tap as the neutral point. (See drawing below). The load of circuit No. 1 connected between Line 1 and neutral is 1500 watts and that of circuit No. 2 between Line 2 and neutral is 1000 watts. Assuming PF = 1.
The current in amperes carried for the 1500 watt circuit is?
The current in amperes carried for the 1000 watt circuit is?
The combined neutral is?
Homework Answers
Add Answer to:
A 120/240 volt, single-phase system is a system with its center
tap as the neutral point....
an open delta three phase transformer system has one transformer center tap that provide in neutral...
an open delta three phase transformer system has one transformer center tap that provide in neutral for single phase voltage. if the voltage from line to center tap 277 volt ,what is high leg voltage?
7. on. Suppose an engineer designs a 120/240 Volt single phase power system for a restaurant...
7. on. Suppose an engineer designs a 120/240 Volt single phase power system for a restaurant including the indoor wiring circuits. He had some conversations with the restaurant owner prior to completing his final design but the owner was not very organized so only shared the other kitchen equipment technical specs by telephone. The restaurant hired an electrician to install the kitchen equipment and inside wiring. However, when the owner met with the electrician he found the kitchen oven to...
A balanced 3 phase system is given with the following specifications: - The balanced system has...
A balanced 3 phase system is given with the following specifications: - The balanced system has a single delta-connected source and a single Y-connected load side. - Between the source and the load side there is the line_impedance = Rlinr+ jXline. - The average power and reactive power delivered form the source is Pin = 500 Watt and Qin = 500 VAR respectively. - The source side line voltage is Vline_source=100 Volt (rms). - The load side average and reactive...
Given the single phase power system shown in Figure 2, determine the following (use 240 V_base...
Given the single phase power system shown in Figure 2, determine the following (use 240 V_base and 30 kVA S_ base for the system at Bus 1): a) Draw the per-unit circuit b) Determine the per-unit impedances and per-unit source voltage c) Calculate the load current in both per-unit and in amperes at Bus 3 d) Calculate the apparent power, real power, reactive power and power factor at Bus 1
3.10 A 240/120 V, 4.8 kVA, 60 Hz, single-phase transformer is used to supply a 4.8...
3.10 A 240/120 V, 4.8 kVA, 60 Hz, single-phase transformer is used to supply a 4.8 kVA resistive load (i.e., the load has a power factor of 1.0) at rated voltage of 120 V a) If you assume the transformer is ideal, what would be the magni- tude of the expected primary side (240 V side) current? b) Again, if you assume the transformer is ideal, what is the apparent impedance of the load viewed from the high-voltage side of...
The line-to-neutral voltage at the terminals of the balanced three-phase load in the circuit shown in...
The line-to-neutral voltage at the terminals of the balanced three-phase load in the circuit shown in A I į 480, kVAI 1 08 pf Q Tap image to zoom is 1900 V.At this voltage, the load is absorbing 480 kVA at 0.8 pf lag Part A Use VAN as the reference and express Ina in polar form. Enter your answer using polar notation. Express argument in degrees. Submit Request Answer Part B Calculate the complex power associated with the ideal...
1 A single phase AC system Consider a single phase AC distribution system in which there...
1 A single phase AC system Consider a single phase AC distribution system in which there a single home connected to a 10kVA service transformer. Let’s assume that the primary of the distribution transformer can be modeled as an ideal 240V (rms) AC source and that the effective impedance of the transformer is 2% resistance and 3% reactance. (See lecture notes for converting % to Ohms). Connected to the secondary of the transformer is 200 ft of #6 AWG aluminum...
Question 1 [30pts]: For the single-phase circuit shown in the figure below, I = 10230° A....
Question 1 [30pts]: For the single-phase circuit shown in the figure below, I = 10230° A. a) [15pts] Compute the phasors I, I, and V. b) [15pts] Draw the phasor diagram showing 1, 1, and V. 1 la :-1612 822 422 162 Question 2 [30pts]: Two parallel balanced Y connected loads are supplied by a balanced 36 240 volt source. The first load draws 20kVA at 0.5 p.f leading and the second load draws 15KVA at 0.7 p.f. lagging. a)...
[29] SECTION B: TRANSFORMERS QUESTION 2 2.1 A 240:48-volt, 50-F power factor of 0.8 lagging. If...
[29] SECTION B: TRANSFORMERS QUESTION 2 2.1 A 240:48-volt, 50-F power factor of 0.8 lagging. If the no load current and iron loss of this e transformer supplies a load of 10 ampere at a ampere and 12-watt respectively, calculate the total current supplied and the powe oad current and iron loss of this transformer are factor. (7) KVA, 50-Hz, 1200:230-volt single phase transformer has the following series impedance values: Z1 = (0.047 +0.112) Z2 = (0.00172 +0.00411)2 Calculate: 2.2.1...
Problem 1.A (2 pnts) In a balanced 3-phase circuit, a 3-phase voltage source with negative phase...
Problem 1.A (2 pnts) In a balanced 3-phase circuit, a 3-phase voltage source with negative phase sequence is connected to a three phase load. If the current between the C and B nodes at the load is ſcb = 1202 - 120° Arms what is the line current ſaa? + CC Cm A 2 line Problem 1.B (8 pnts) A balanced 3-phase circuit consists of a Y-connected 3-phase source with negative phase sequence, a delta-connected load, and a 3-phase transmission...
7. on. Suppose an engineer designs a 120/240 Volt single phase power system for a restaurant including the indoor wiring circuits. He had some conversations with the restaurant owner prior to completing his final design but the owner was not very organized so only shared the other kitchen equipment technical specs by telephone. The restaurant hired an electrician to install the kitchen equipment and inside wiring. However, when the owner met with the electrician he found the kitchen oven to...
Given the single phase power system shown in Figure 2, determine the following (use 240 V_base and 30 kVA S_ base for the system at Bus 1): a) Draw the per-unit circuit b) Determine the per-unit impedances and per-unit source voltage c) Calculate the load current in both per-unit and in amperes at Bus 3 d) Calculate the apparent power, real power, reactive power and power factor at Bus 1
3.10 A 240/120 V, 4.8 kVA, 60 Hz, single-phase transformer is used to supply a 4.8 kVA resistive load (i.e., the load has a power factor of 1.0) at rated voltage of 120 V a) If you assume the transformer is ideal, what would be the magni- tude of the expected primary side (240 V side) current? b) Again, if you assume the transformer is ideal, what is the apparent impedance of the load viewed from the high-voltage side of...
The line-to-neutral voltage at the terminals of the balanced three-phase load in the circuit shown in A I į 480, kVAI 1 08 pf Q Tap image to zoom is 1900 V.At this voltage, the load is absorbing 480 kVA at 0.8 pf lag Part A Use VAN as the reference and express Ina in polar form. Enter your answer using polar notation. Express argument in degrees. Submit Request Answer Part B Calculate the complex power associated with the ideal...
Question 1 [30pts]: For the single-phase circuit shown in the figure below, I = 10230° A. a) [15pts] Compute the phasors I, I, and V. b) [15pts] Draw the phasor diagram showing 1, 1, and V. 1 la :-1612 822 422 162 Question 2 [30pts]: Two parallel balanced Y connected loads are supplied by a balanced 36 240 volt source. The first load draws 20kVA at 0.5 p.f leading and the second load draws 15KVA at 0.7 p.f. lagging. a)...
[29] SECTION B: TRANSFORMERS QUESTION 2 2.1 A 240:48-volt, 50-F power factor of 0.8 lagging. If the no load current and iron loss of this e transformer supplies a load of 10 ampere at a ampere and 12-watt respectively, calculate the total current supplied and the powe oad current and iron loss of this transformer are factor. (7) KVA, 50-Hz, 1200:230-volt single phase transformer has the following series impedance values: Z1 = (0.047 +0.112) Z2 = (0.00172 +0.00411)2 Calculate: 2.2.1...
Problem 1.A (2 pnts) In a balanced 3-phase circuit, a 3-phase voltage source with negative phase sequence is connected to a three phase load. If the current between the C and B nodes at the load is ſcb = 1202 - 120° Arms what is the line current ſaa? + CC Cm A 2 line Problem 1.B (8 pnts) A balanced 3-phase circuit consists of a Y-connected 3-phase source with negative phase sequence, a delta-connected load, and a 3-phase transmission...
Most questions answered within 3 hours.
-
1. A 1200 kg car is practicing on a flat test
track. The car begins moving...
asked 24 minutes ago -
An
agency collects demographics concerning the number of people in
families per household in a certain...
asked 25 minutes ago -
Writing a Persuasive Essay on:
(Smoking in public places should be banned) Can i please get...
asked 28 minutes ago -
Q23 Suppose H0 is left-tailed and tTest = -2.26. (Note tTest not
zTest). The tTest value...
asked 37 minutes ago -
A runaway train car that has a mass of 1.71e+4 kg travels at a
speed of...
asked 36 minutes ago -
Question 1: For each of the sections in this part, the
competitive market for labor is...
asked 34 minutes ago -
Lincoln, Inc., which uses a volume-based cost system, produces
cat condos that sell for $170 each....
asked 41 minutes ago -
On November 3, the spot price for cotton was $0.81/lb., and the
February futures price was...
asked 42 minutes ago -
Using Python:
A Prime number is an integer greater than 1 that cannot be
formed by...
asked 1 hour ago -
Read about Cokes strategy in Africa in the article below and
discuss the ethics of selling...
asked 51 minutes ago -
What made of a 40.0% NaOH solution should be diluted to 1.00 L
with water to...
asked 51 minutes ago -
Draw and describe the results of the Meselson-Stahl experiments
showing that DNA replication followed the Semi-conservative...
asked 56 minutes ago