only question e, f, i, j, k You will need graph paper, a calculator, a copy...
A fuel gas consists of 75% butane (C4H10), 10% propane (C3H8) and 15% butene (C4H8) by volume. It is to be fed to the combustion chamber in 10% excess air at 25ºC, where it is completely burnt to carbon dioxide and water. The flue gases produced are to be used to generate 5 bar steam from water at 90ºC. net calorific value (MJm-3) at 25oC Butane (C4H10) = 111.7MJm-3, Butene (C4H8) = 105.2 MJm-3. Propane (C3H8) = 85.8 MJm-3. air...
l Virgin * 01:06 eat.tees.ac.uk You will need graph paper, a caleulator, a copy of Appendix I from lesson HTC-4-2 and access to steam tables to answer this TMA A fuel gas consists of 75% butane (C,Hio), 10% propane (C,Hs) and 15% butene (C4H by volume l. It is to be fed to the combustion chamber in 10% excess air at 25C. where it is completely burnt to carbon dioxide and water. The flue gases produced are to be used...
A Fuel Gas Consists Of 75% Butane (C4H10), 10% Propane (C3H8) And 15% Butene (C4H8) By Volume. ... Question: A fuel gas consists of 75% butane (C4H10), 10% propane (C3H8) and 15% butene (C4H8) by volume. It... A fuel gas consists of 75% butane (C4H10), 10% propane (C3H8) and 15% butene (C4H8) by volume. It is to be fed to the combustion chamber in 10% excess air at 25ºC, where it is completely burnt to carbon dioxide and water. The...
I) Boiler superheater [3 marks) B) A steam boiler fired with oil of calorific value of 42 MJ/kg generates steam at a rate of 2500 kg/h and 1.5 MPa. The generated steam is further heated in a superheater to a temperature of 300°C. Feed water at 30°c is preheated to 90°C through passage in the economizer. The boiler unit has an efficiency of 78% i) Calculate the fuel/oil consumption rate (in kg/h) ii) Calculate the percentage increase in fuel consumption...
I DON'T KNOW HOW TO DO PART C, Thanks What is the enthalpy of reaction at 298 K? b) A fuel gas, with composition 50% CO and 50% N2 is burned using a stoichiometric amount of air. What is the composition of the flue (exhaust) gas by volume? c) If the fuel gas and air enter the burner at 550 K, what is the highest temperature the flame may attain (adiabatic flame temperature)? Note, the heat capacities of the gases...
A fuel gas containing 95 mole% methane and the balance ethane is burned completely with 25% excess air. The stack gas leaves the furnace at 900°C and is cooled to 450°C in a waste-heat boiler, a heat exchanger in which heat lost by cooling gases is used to produce steam from liquid water for heating, power generation, or process applications. (a) Taking as a basis of calculation 100 mol of the fuel gas fed to the furnace, calculate the amount...
Water ackboard X C (L01, 2 Marks)-The following are heat loss data measured, collected and tabulated for What is the approximate boiler efficiency? (percentage, no decimals, no units) steam generator (Boiler) The Boler losses and their approximate locations are lustrated in the block diagram below Hoiler Loss source Value (%) 47 4.12 Loss due to dry flue gas (Sonsible heat) Loss due to hydrogen in fuel (H2) Loss due to moisture in fuel (H2 0) Loss due to moisture in...
DIESel Ehgine Power Plant) a) Write a short note (not more than 10 lines in each ase) Write a short note (not more than 10 lines in each case) for the following: () diesel engine, (ii) for Supercharger and turbocharger, (ii) Heat (energy) balance sheet of a Cooling system of a diesel power plant b) From the data given below, calculate: () indicated power, (i) brake power, and (ii) 20 minutes at full load. drawn heat balance sheet for a...
A fuel gas containing 85.0 mole% methane and the balance ethane is burned completely with 15.0 % excess air. The stack gas leaves the furnace at 900.0 °C and is cooled to 450.0 °C in a waste-heat boiler, a heat exchanger in which heat lost by cooling gases is used to produce steam from liquid water for heating, power generation, or process applications. Physical Property Tables Combustion Gases Correct. Take as a basis 100.0 mol of the fuel gas fed...
A bituminous coal is burned with air in a boiler furnace. The coal is fed at a rate of 40000 kg/h and has an ultimate analysis of 76wt% C, 5wt% H, 8wt% O, negligible amounts of N and S, and 11wt% non-combustible ash. Air enters a preheater at 30 °C and 1 atm with a relative humidity of 30%, exchanges heat with the hot flue gas leaving the furnace and air enters the furnace at temperature Ta (°C). The flue...