2. (15 pts) A tension member made of 18-Ni maraging steel (air melted), (properties in table...
8.13 An engineering member is to be made of an aluminum alloy. It is in the shape of a plate loaded in tension that may have a crack in one edge, as shown in Fig. 8.12(c). The dimensions are width b = 40 mm and thickness t = 4.0 mm, and the crack may be as long as a = 8.0 mm. The member must resist a tension force of P = 7.5 kN. (a) For a safety factor of...
solve this question by writing a code in MATLAB 3. Abending member with a rectangular cross section is made of ABS plastic and has dimensions, as defined in Fig. 8.13(a), of b = 28 mm and t = 10 mm. For a safety factor against brittle fracture of 3.2, determine the largest through-thickness edge crack length, a, that can be allowed if: a. M = 15 N·m. b. M = 4.0 N-m. 4. What are the safety factors against fully...
8.6 A center-cracked plate of AISI 1144 steel has dimensions, as detined in Fig.8.12(a). of 1) /h - 40 mm and - 15mr 4() mni and ,-: 15 mn. F(r a safety fact(rofthree against brittle fracture. what is the maximum permissible force P on the plate if the crack half-length a is (a) 10mm. and (b)24 mm? So2(ab) S( (b 0.2 0,4 0.6 0.8 1.0 Values for small b and linits for 10 % accuracy: (alb s 0.4) (alb s...