Homework Answers
Add Answer to:
Engine Cycles a) Bituminous coal has an energy content of 3.0 x 107 J/kg. A coal-fired...
4. A coal-fired power plant has thermal efficiency, η = 30%. It produces 100 MW of...
4. A coal-fired power plant has thermal efficiency, η = 30%. It produces 100 MW of power. does the coal combustor transfer energy (heat) to the plant? Answer: 100 MW At what 0 < 400 MH At what rate is heat rejected to the environment? Answer: 100 MW < Qく400 Mw. a. rate b.
please show all computations PILULUH.001 1. How many metric tons of bituminous coal needed to run...
please show all computations
PILULUH.001 1. How many metric tons of bituminous coal needed to run a coal power plant rated at 4,000 MW thermal for one year? How many kilograms of CO2 is produced from this plant? Assume a capacity factor of 100%.
How much coal is burned in a day by a coal-fired power plant producing 500 MW...
How much coal is burned in a day by a coal-fired power plant producing 500 MW of electrical power with an efficiency of 34%? The heating value of coal is 25,000,000 (25x106) Btu/ton. Give your answer in tons.
One tonne of coal, if fully burned, releases 28 Gigajoules (GJ) of thermal energy. However, for...
One tonne of coal, if fully burned, releases 28 Gigajoules (GJ) of thermal energy. However, for each tonne of coal burned in its boiler, a modern electrical power plant produces only 9.5 GJ of electrical energy. a) Which law of nature explains the difference? [1 Mark] b) What is the energy conversion efficiency of such a power plant? [1 Mark] c) If the electrical transmission and distribution network between the power plant and your home has an efficiency of 93%,...
A typical coal-fired power plant burns 290 metric tons of coal every hour to generate 800...
A typical coal-fired power plant burns 290 metric tons of coal every hour to generate 800 MW of electricity. 1 metric ton= 1000 kg. The density of coal is 1500 kg/m3 and its heat of combustion is 28 MJ/kg. Assume that all heat is transferred from the fuel to the boiler and that all the work done in spinning the turbine is transformed into electrical energy. Part A)Suppose the coal is piled up in a 8.0 m × 11 m...
A typical large coal fired electric power plant produces 1,200MW of electricity by burning fuel with...
A typical large coal fired electric power plant produces 1,200MW of electricity by burning fuel with energy content of 3,000 MW. Three hundred and forty (340) MW are lost as heat up the smokestack leaving the rest to drive a generator to produce electricity. However, the thermal efficiency of the turbine is only 45%. That is 45% of the remaining power goes to drive the generator, and 55% is waste heat that must be removed by cooling water. Assume that...
A gasoline engine in a large truck takes in 10,000 J of heat and deliver 2,000...
A gasoline engine in a large truck takes in 10,000 J of heat and deliver 2,000 J of mechanical work. per cycle. The heat is obtained by burning gasoline with heat of combustion L-5.0 10* J/g. Heat of combustion of gasoline is how much energy gasoline produces by combustion per g.(20 points) a) What is the thermal efficiency of this engine? (4 points) b) How much heat is discard in each cycle? (4 points) c) How much gasoline is burned...
Ans. During one aycle, an engine extracts 2.00 X 10' J of energy from a hot...
Ans. During one aycle, an engine extracts 2.00 X 10' J of energy from a hot reservoir transfers 1.5 X 103 J to a cold reservoir. 2. and a. Find the thermal efficiency of the engine Ans. b. How much work does the engine do in one cycle? Ans. c. How much power does the engine generate if it goes through four cycles in 2.5 see?
Ans. 2. During one cyele, an engine extracts 2.00 x 10' J of energy from a...
Ans. 2. During one cyele, an engine extracts 2.00 x 10' J of energy from a hot reservoir and transfers 1.5 X 103 J to a cold reservoir. a. Find the thermal efficiency of the engine. Ans. b. How much work does the engine do in one cycle? Ans. c. How much power does the engine generate if it goes through four cycles in 2.5 sec? Ans.
o) thes at2ciency of 0.22 and delivers 180 J of work per cycle (c) If the...
o) thes at2ciency of 0.22 and delivers 180 J of work per cycle (c) If the energy content gasoline 010 A four-cylinder gasoline engine has acper s (a) thework done per second, and (b) the total heat input per second from icieney ord 1500 pm) has an et nt of gasoline is 130 MJ per gallon, how long is 130 MJ per gallon, how long does one gallon last? 011. rool ch initial sed of 4.0 ms' slides along a...
4. A coal-fired power plant has thermal efficiency, η = 30%. It produces 100 MW of power. does the coal combustor transfer energy (heat) to the plant? Answer: 100 MW At what 0 < 400 MH At what rate is heat rejected to the environment? Answer: 100 MW < Qく400 Mw. a. rate b.
please show all computations
PILULUH.001 1. How many metric tons of bituminous coal needed to run a coal power plant rated at 4,000 MW thermal for one year? How many kilograms of CO2 is produced from this plant? Assume a capacity factor of 100%.
A gasoline engine in a large truck takes in 10,000 J of heat and deliver 2,000 J of mechanical work. per cycle. The heat is obtained by burning gasoline with heat of combustion L-5.0 10* J/g. Heat of combustion of gasoline is how much energy gasoline produces by combustion per g.(20 points) a) What is the thermal efficiency of this engine? (4 points) b) How much heat is discard in each cycle? (4 points) c) How much gasoline is burned...
Ans. During one aycle, an engine extracts 2.00 X 10' J of energy from a hot reservoir transfers 1.5 X 103 J to a cold reservoir. 2. and a. Find the thermal efficiency of the engine Ans. b. How much work does the engine do in one cycle? Ans. c. How much power does the engine generate if it goes through four cycles in 2.5 see?
Ans. 2. During one cyele, an engine extracts 2.00 x 10' J of energy from a hot reservoir and transfers 1.5 X 103 J to a cold reservoir. a. Find the thermal efficiency of the engine. Ans. b. How much work does the engine do in one cycle? Ans. c. How much power does the engine generate if it goes through four cycles in 2.5 sec? Ans.
o) thes at2ciency of 0.22 and delivers 180 J of work per cycle (c) If the energy content gasoline 010 A four-cylinder gasoline engine has acper s (a) thework done per second, and (b) the total heat input per second from icieney ord 1500 pm) has an et nt of gasoline is 130 MJ per gallon, how long is 130 MJ per gallon, how long does one gallon last? 011. rool ch initial sed of 4.0 ms' slides along a...
Most questions answered within 3 hours.
-
Oxidative phosphorylation is achieved through chemiosmotic
coupling, which turns chemical energy into osmotic potential energy
that...
asked 2 hours ago -
Hollywood Shoes would like to maintain their cash account at a
minimum level of $64,000, but...
asked 2 hours ago -
Proteins CtrA-P, DnaA, and GcrA behave similarly to what
molecule in the Eukaryotic Cell Cycle?
asked 2 hours ago -
TRUE OR FALSE
In case of a competitive tender procedure, in the request for
quotation, the...
asked 2 hours ago -
I am a little behind please provide some explanation, will
provide thumbs up.
This question considers...
asked 2 hours ago -
Let say the utility function as U(X,Y) = lnX + Y. Show that the
marginal rate...
asked 2 hours ago -
A current of I=8.0A is flowing in a typical extension cord of
length L=3.00m. The cord...
asked 2 hours ago -
1. When balancing the equation H2SO4 (aq) + NaOH (aq) →
Na2SO4(aq) + H2O(aq), would you...
asked 3 hours ago -
Provide a definition of “classification hierarchy” and
illustrate your definition with an example of how and...
asked 2 hours ago -
1. Describe the four main green solvents. Provide one example of
the use of each solvent....
asked 2 hours ago -
International ethics focus on:
1) exploitation of labor
2)corruption
3) environmental impact
4) none of the...
asked 2 hours ago -
Costing Models You work for XYZ trucking and your boss has asked
you to figure out...
asked 2 hours ago