please rate positively. It helpa me alot.
Find the instantaneous frequency of the next signal at t = 4. (a) x(t) = 10...
please show all steps and explaination Suppose a digital data signal b(t) is transmitted using Binary Phase Shift Keying (BPSK) modulation. a. If the digital data signal b(t) is NRZ binary waveform with bit rate of 1 Mbps and the 2. modulation carrier frequency is 10 MHz, provide an approximate magnitude plot of the frequency spectrum. What is the required bandwidth of this BPSK modulated signal? What happens if you half the bit rate? Provide an approximate magnitude plot of...
Communication systems d) The angle modulated signal is presented as = 1008 (2*10*4 +0.5sin(10*x+)) 1. Find and determine the frequency modulated signal x(C) with k, = 5. (5 marks) II. Calculate and find out the message signal m(t). (5 marks) e) A 40 MHz carrier is frequency-modulated by a sinusoidal signal with mascimum frequency deviation of 500 KHz. I. Find and calculate the approximate bandwidth of the FM signal the frequency of the message signal is 1 kHz. (5 marks)...
5. Consider the following message signal: m(t) -2 .3 10 Assume that the carrier frequency is f are kf = 105, kp-25 respectively. 108 Hz, and frequency and phase deviation constants Find the maximum and minimum frequency deviation for FM, and sketch the FM wave for a duration of 103 seconds shown in the above figure (5 points). a. b. Find the maximum and minimum frequency deviation for PM, sketch the PM wave for a duration of 103 seconds shown...
Find he 20 200 114 pts) Problem 6) A phase-modulated signal is denoted by the following equation: (a) Find the power of the modulated signal. (b) Find the carrier frequency fe (c) Find the frequency deviation Δ. (d) Find the deviation ratio B (e) Find the phase deviation A (t Estimate the bandwidth of pptt). (g) Knowing that the k, of the frequency modulator equal to 2n, what will the FM representation of this signal be if the FM modulator...
Question 1 In the shown block diagram, the missing block is an integrator m(1) SIA True False AA Moving to another question will save this respo Question 2 The narrowband FM signal is expressed as: A(t) cos {2 11 ft+tan- '[kfa(t)}} True False Question 3 Given the message signal m(t) with peak value 2 and carrier signal 5 cos (108 11 t). If ky = x10, the value of (min equals 50.1 MHz O True False Question 4 The following...
1. [20 points] An angle modulated signal is given as d(1-8 cos(wl + 2 sin (5000π1)) with carrier frequency 1 MHz (a) Find the power of the modulated signal (b) Find the frequency deviation and the phase deviation (c) Find the bandwidth of the modulated signal (d) Repeat the above parts when the signal is ф(1) : 7 cos(wct + 10 sin( 1300nt) + 12 cos(6000t))
below is used to modulate a carrier to generate the AM signal yt) (Am()) cos(1000t) The periodic signal m() shown a) The power efficiency of the system is measured to be 1 () The type of AM modulation, i.e. SSB, DSBSC, (i) The constant A. (ili) The modulation index 1/13. Determine DSB with carrier enit -3 b) An angle modulated signal is given by d(t-2 cos (2n1061+ sin 2 1000). Find i) The carrier frequency. ii) The baseband signal bandwidth....
1. FM modulation. Consider a message signal m(t)-(2nt and a carrier wave c(t)-cos(400rt) (a) (20 points) Derive the FM modulated signal s(t) for ky-2 (b) (25 points) Find the Fourier transform, S(), of s(t) (Sketch to scale). (c) (5 points) What is the bandwidth of the modulated signal s(t).
Consider an FM system where the modulated signal is s(t) = 10 cos (2πfct + 2πkf∫0t m(τ)dτ)where the carrier frequency is fc = 100 MHz. The modulation signal is m(t) = 10 cos(2πfmt), where fm = 3 kHz. (a) Assuming that kf = 10, what is the approximate bandwidth of s(t)? (b) Find the instantaneous frequency fi(t) of s(t). What are the maximum and minimum values of fi(t) ?
(b) IT SUIS JILI find m(t) 10. An angle-modulated signal is described by the equation below (1) = 10 cos(2111084 +200 cos 2.10°r) signal IJ TUM using the Bessel function table 9. An angle-modulated signal is described by the equation below s(t) = 10 cos[2 (106+0.1 sin(103) (a) If s(t) is the signal obtained by phase modulation with ky=10, find m(t) (b) If st) is the signal obtained by frequency modulation with kf=107 find m(t) bolo modulated signal is described...