college algebra word problem as heat in a resistor varies directly with the square of the...
Problem: Given the following voltage variation: volts 4o time, Sea 3 a. Find the average voltage in volts b. Find the effective voltage in volts. c. If this voltage wave is applied to a 15 ohm resistor, find the dissipated power in watts.
How much energy is dissipated as heat during a two-minute time interval by a 1 .5-k ohm resistor which has a constant 20-V potential difference across its leads? a) 58 J b) 46 J c) 32 J d) 72 J e) 17 J When a voltage VI is placed across a series combination of an unknown resistor R and a 65-ohm resistor, the power delivered to the resistors is Pl. When the 65-ohm resistor is replaced by a 20-ohm resistor...
Problem #3 From ECE 102 Engineering Computation textbook→ Problem #13, page 127: 47 Ω 8Ω 3Ω 22 Ω 7Ω 2Ω Express resistance in ohms (2), voltage in volts (V), current in amperes (A), and power in watts W). Show your answers rounded to two (2) decimal places a) What is the equivalent resistance Rey of the circuit between points a and e? For the remaining questions, assume the positive side of a 12 volt DC voltage supply is connected to...
Determins the power dissipated by the 4-ohm resistor in the right hand circuit using algebra. Show the following calculations. 4. Take a Screenshot of the full circuit board showing all four circuits and save it as "DC Circuit_2.pog". Print it out and submit it with your lab report. 5. Determine the power dissipated by the 4-2 resistor in the left-hand circuit by adding either an ammeter or a voltmeter to the circuit. Use the reading from that meter in calculating...
All of them have short answers. 1. If a 19.9mA current source, a 32.6kΩ resistor, a 49.6kΩ resistor and a 42.6kΩ resistor are all connected in parallel, then what is the current through the 42.6kΩ resistor in milliamps? 2. If a 8.9V voltage source is applied across a 43.6kΩ resistor connected in series with a 25.3kΩ resistor, then what is the voltage across the 25.3kΩ resistor in volts? 3. If the Thevenin equivalent for a circuit is a 5.5V voltage...
Two resistors are connected in parallel across an ideal 12.0 Volts battery. Resistor A has a value of 28 ohm and resistor B carries a current of 1.0169 A. 1.) What is the potential difference across resistor A? 2.) What is the potential difference across resistor B? 3.)What is the current in resistor A? 4.)What is the resistance of B? 5.)What is the total power dissipated in the circuit?
QUESTION 3 and the lifting speed As the resistance before the motor decreased the motor voltage QUESTION 4 Consider a circuit with a resistor in series with a motor, like observed in Activity 2 of the Week 10 Practical, when the load on the motor increases the voltage across the motor and the current through the motor Under this higher load the lifting speed and the motor torque QUESTION5 If the power supply is set to 5 V and a...
The voltage supplied by a wall socket varies with time,reversing its polarity with a constant frequency, as shown in thegraph. (Intro 1 figure) Intro Fig. Fig Part B 1. What is the rms value of the voltage plotted in the graph? Express your answer in volts. = ? V 2. When a lamp is connected to a wall plug, theresulting circuit can be represented by a simplified AC circuit, asshown in the figure. (Part B figure) Here the lamp has...
9. A resistor R2=6.0 Q is mounted in parallel with a resistor R3=7.0 Q, and this combination is connected in series with a resistor R1=9.0 Q and a 10 Volts battery. What is the power dissipated in the R3 resistor? Watts R2 ww R3 10. Four resistors R1=9.0 Q, R2=3.0 Q,R3=11.0 2, and R4-4.0 2 are mounted as shown in the figure. The voltage of the battery is V = 18 Volts. What is the current in the R3 resistor?...
A small heater can be created by connecting a 10-ohm resistor across a 24-volt battery. Assume the battery is an ideal 24-volt potential source, and that any wires used to connect the battery to the resistor are also ideal and have negligible resistance. Part A) Calculate the power dissipated as heat by this circuit. (Answer in Watts) Part B) 4.18 Joules of energy are required raise 1.0 mL of water by 1∘ C. We wish to modify our 24-volt heater...