Question

Can someone put step by step directions how to make this in creo 4.0

*some dimensions can be made up

109 Extrusions Problems Design "frame guide" (Figure 4-94) with the origin located on the centerline of the 1.500-inch diameter through hole directly below the center of the 0.19-inch diameter hole. The two through holes need to be 1.69 inches from the centerline of the large hole. All dimensions are in inches. Design change: increase the 0.19-inch diameter hole to 0.25 inches. 4.19 2x R1.19 .44 1,50 FILLETS R. R06 2.00 1.88 Figure 4-94 Problem 9

Answer 1

Please comment if you need any further clarification?