Problem 8 For the lengths and show directions of all reactions a) structures in Figure 8...
1. Qualitatively sketch the deformed shape and the direction of all reactions for the structures given below.(10pts) a. Moment release b. d. e.
1. Qualitatively sketch the deformed shape and the direction of all reactions for the structures given below. (10pts) Moment release b. d. e.
For Problem 8.21 qualitatively
sketch the deformed shape of the structures for the given loads.
Also sketch the direction of all reactions.
P8.21 Problems 8.21
It's a problem of Mechanics of Solids. Kindly show all the
works.
QUESTION 1 (TEST 2) (a) For the beams shown in Figure Q1(a) to Q10), select the beam which is under pure bending. Explain what is pure bending. No calculation is required. (2 marks) P(N) P(N) PIN (Nm) P (N) Figure Q1(a) Figure Q1(b) Figure Q1(c) (6) For the beams shown in Figure Q1(d) to Q1(f), select the beam which you expect to have the contra- flexure point. Explain...
PROBLEM 2 25 Points 60 kN 45 kN/m X A B C D 2.5 m 2.5 m 4 m Draw the shear-force and bending-moment for the beam shown in figure. You can use any method but you need to show your calculations. Label all significant points on each diagram and identify the maximum moment along with its location. Clearly differentiate straight-line and curved portions of the diagrams. Points 25 Distribution Drawing of SF and BM: 10 Calculation of SF and...
A continuous beam ABC shown in Figure 2 is fixed at A. Supports at B and C are rollers. A uniform distributed load 40kN/m is applied force acts downward on the span of BC as shown in Figure 2. The EI of the beam is over the span of AB and a 60kN constant (a) Determine the internal moments at A and B using the slope-deflection method [10 marks] (b) Draw the bending values of bending (c) Sketch the deformed...
500 N/m 2b Figure 1 (a) Determine the reactions at the supports at A and B. 4 Marks) Determine the equations defining the shear force and bending moment at any (6 Marks) Draw the shear force and bending moment diagrams for the beam, showing the (6 Marks) (b) point between points A and C (c) values at all points between points A and B. (d) Find the dimensions of the cross-section of the beam if the allowable bending stress for...
Draw the complete mechanism for the following reactions. Be sure to
show all intwrmediate structures and all electron flow using curved
arrows
а. НЭРОА 250 °C CH3CH2OH + b. Br КОН CH3CH2OH с. ROOR, HBr d. HBr
INSTRUCTIONS For PROBLEM do the following steps: 1. Show ALL your work 2. Draw appropriately labeled FBDs 3. Use appropriate segments to develop expressions for the shear force and bending moment. diagrams in a standard format the required stresses in the critical points in the 4. Draw the shear force and bending moment 5. Draw the deflected shape of the beam and check beam. 6. Perform a CHECK on your answers 7. Append appropriate units to ALL your answers 5....
Simply supported beam is loaded as shown in figure. (a) Compute support reactions. (3) (b) Draw Shear Force Diagram (SFD) to the scale. (c) Locate the point where shear force is zero. Do not use properties of similar triangles. (3) (d) Compute bending moment at all important points including point where shear force is zero. (4) (e) Draw Bending Moment Diagram (BMD) to the scale. (4) (1) Show deflected shape of the beam. Indicate which part is sagging and which...