Question 7 10 pts Which of the following will reverse the effects of cold working? O...
Problem 3: Consider a metal single crystal oriented such that the normal to the slip plane and the slip direction are at angles of 43.1° and 47.9°, respectively, with the tensile axis. If the critical resolved shear stress is 20.7 MPa (3000 psi), will an applied stress of 45 MPa (6500 psi) cause the single crystal to yield? If not, what stress will be necessary?
1. Consider a metal single crystal oriented such that the normal to the slip plane and the slip direction are at angles of 43.10 and 47.9° respectively, with the tensile axis. If the critical resolved shear stress is 20.7 MPa will an applied stress of 45 MPa cause the single crystal to yield? If not, what stress will be necessary? (10 points)
the value of a parameter is not given, USE A SYMBOL in its place alues in parenthesis are points awarded to a complete solution. cademic dishonesty will automatically result in spective of points obtained. Question 1 10 pts 1. Consider a metal single crystal oriented such that the normal to the slip plane and the slip direction are at angles of 43.1° and 47.9° respectively, with the tensile axis. If the critical resolved shear stress is 20.7 MPa will an...
pts) ectively, with the tensile stress of 12 MPa (1750 psi) cause the single cry och Aangermal to slip plan and the slip direction are at angles of 60° axis. If the critical resolved shear stress is 6.2 l to yie that the normal to the slip plane Consider a metal single crystal oriented saod 35 res(go ps). nt, what stress nted such shear stress is 6.2 MPa (900 psi), will an applied If not, what stress and 35°, resp...
Problem 1 (10 pts) It is required to manufacture a 2.5 mm diameter copper rod from larger diameter stock by drawing. The rod should have a tensile strength of 300 MPa or more, a yield strength of 200 MPa or more, and ductility of 10% or more. Determine (a) the range of%CW which will allow achieving those properties, and (b) within this range clearly pick a certain%CW and determine the corresponding diameter of the starting stock. yield strength (MPa) tensile...
3. (20 pts. total) The primary slip plane for a BCC structure is the (110 family of planes although slip can also occur on alternate planes. a. (3 pts.) On the left cube below, draw and label two planes from the (110 family of planes. b. (3 pts.) On the right cube below, two alternate slip planes are shown. What are the Miller indices of these planes? (Note: The blue plane intersects the y-axis at 1/2 and the z-axis at...
Which of the following is not a strengthening method for crystalline metals? A. Hot-working B. Cold-working. C. Grain refinement D. Interstitial alloy addition E. None of the above. These are all strengthening methods. A unidirecional composite of 35% by volume Eglans for in apocytsee Table 1)is subjected to a stress of 200 MPa parsial to the fore dinction. The strain in the comples Table 1 pdf 71 kn A 0070 0.000 C 728 OD. 0007 O E 0.004 Table 1...