A enotne time connected to a pressure gage through a double U manometer, as shown in...
Kerosene at 20°C flows through a contraction section as shown. A pressure gage connected between the upstream pipe and throat section shows a pressure difference of 14 kPa. The gasoline velocity in the throat section is 12 m/s. What is the velocity (m/s) in the upstream pipe? 12m/s Kerosene at 20° C 14kPa VA = m/s Click here to access the appendices. the tolerance is +/-2%
Question 3: A simple U-tube manometer is shown in Figure 2. One end of the U-tube is connected to the pipe A so that the pressure at A (PA) is to be measured. The other end is left to be open to the atmosphere. The U-tube contains a liquid (mercury with specific gravity slig-13.54) called the gage fluid, which does not mix with the fluid (water). If the reading of inside pipe A
Q3) An inclined manometer tube is connected to two closed tanks as shown in the figure below where !-210 cm. A gage was used to measure the pressure at the center of tank A and the reading was 60 kPa. A barometer locates near the tanks reads 72 cm of mercury. Specific weight of water is 9.81 kN/m3 and specific gravity (SG) of mercury is 13.6. a) Find the gage pressure in the center of tank B. b) Find the...
4 A U-Tube manometer is connected to a closed tank, shown below, containing oil a density of 800 kg/m², the pressure of the air above the oil being 6000 Pa, if the pressure at point A is 20 kPa and the manometer fluid has a relative density of 5, Assume x=0.6m. determine the following i. The depth of oil, Z ii. The differential reading, Z2 on the manometer. (5marks) Z2 Z A OIL 5 Explain about the steady and unsteady...
A 5-m-wide. 5-m-high rectangular plate blocks the end of a 4.m-deep freshwater channel, as shown in the figure. The plate is hinged about a horizontal axis along its upper edge through a point A and is restrained from opening by a fixed ridge at point B. Determine the forge exerted on the plate by the ridge BE) (25 pts) )water = 9810 I m rI For a vertical rectangular wall the resultant force is applied at one third of depth...
summatize the following info and break them into differeng key points. write them in yojr own words apartus 6.1 Introduction—The design of a successful hot box appa- ratus is influenced by many factors. Before beginning the design of an apparatus meeting this standard, the designer shall review the discussion on the limitations and accuracy, Section 13, discussions of the energy flows in a hot box, Annex A2, the metering box wall loss flow, Annex A3, and flanking loss, Annex...