1).VLAN stands for VIRTUAL LOCAL AREA NETWORK.
2).FALSE
as long as two devices in the same network can communicate directly, if they are in a different network then they need a router.
3).the file name is vlan. dat file
its mainly stored in a VLAN database. this default location of the VLAN database is stored in vlan. dat file.
4)TRUE
it is set to default VLAN in access mode.
5).TRUE
a VLAN can be create using a router in layer-3, it is done when we need to communicate with hosts in other networks.
6)FALSE
a switch does not have the capability to assign an IP address and subnet mask.
7).ROUTER
by using router two VLAN having different IP addresses can communicate between themselves.
8).TRUE
as these are Virtual LAN's they cost very less and efficient, a high performance so they reduce the cost for infrastructure.
9).EXTENDED RANGE VLAN id
10).VLAN TRUNKING PROTOCOL (VTP)
which is used to manage normal range VLANs.
11).VLAN 1
VLAN 1is a default ethernet VLAN. It blocks the holes.
12).set vlan <vlan> <mod/port>
please solve all the questions VLAN abbreviation is 2. Two devices is the same network need...
Hi please help me solve this! Been stuck on this for a long time. I don;t know how to upload the file but packet tracer is required. Please help!! I don;t know how to begin or finish this! Regards 200.1.1.2 /24 200.1.1.1/24 Subnet 4 1941 PC-PT PCO 1941 Router0 Router1 Network Address 192.168.21.0/24 5 subnets required Serial link 4 VLANS required VLAN 20 (Staf) (Subnet 0) VLAN 30 (Student) (Subnet 1) VLAN 40 (Server) (Subnet 2) VLAN 100 (Management)(Subnet 3)...
Please answer all question and with a correct response! I really need these points! Thanks What is the name/standard of the two VLAN trunking protocols that have been traditionally supported on Cisco switches? (Choose two.) IEEE 802.1x ISL IEEE ASL Which command will correctly configure a port for VLAN 101? switchport access 101 switchport vlan access 101 switchport mode access vlan 101 switchport access vlan 101 True or False - Layer 2 switches will not forward traffic between VLANs True...
Refer to the network figure above, showing two Ethernet Subnets connected through an IP Router, for questions #1, #2 and #3. For each device, both its Internet Protocol (IP) address and its MAC address (also called the Physical address or the Ethernet address) are shown. The Subnet Mask used by all devices is 255.255.255.192 (which is same as prefix length “/26”). (5 points) Assuming that Client #1 sent a packet to Client #3 and then Client #3 sent a packet...
Q1 Error detection/correction Can these schemes correct bit errors: Internet checksums, two-dimendional parity, cyclic redundancy check (CRC) A. Yes, No, No B. No, Yes, Yes c. No, Yes, No D. No, No, Yes E. Ho, hum, ha Q2 CRC vs Internet checksums Which of these is not true? A. CRC's are commonly used at the link layer B. CRC's can detect any bit error of up to r bits with an r-bit EDC. c. CRC's are more resilient to bursty...