Given the crystal structure of Zn is HCP (a = 266.49 pm, c = 494.68 pm):
(a) Determine the slip system(s) based on the given information.
(b) Estimate the Peierls-Nabarro Stress for given that G = 43 GPa, and ?=0.25.
1) Since Zinc has a HCP structure. So no of slip system for a HCP structure is = 3.
2) G = 43 GPa, v = .25,. a = 266.49pm,. c = 494.68pm
Given the crystal structure of Zn is HCP (a = 266.49 pm, c = 494.68 pm):...
1. For zine (Zn) with a perfect HCP crystal structure having a c/a ratio of 1.633 and a density of 7.13 g/cm, (18 marks) a) Show that the volume of the Zn unit cell is given by 6v3R2c. (10 marks) b) Compute the atomic radius for Zn in nm. (8 marks)
1. For zinc (Zn) with a perfect HCP crystal structure having a c/a ratio of 1.633 and a density of 7.13 g/cm'. (18 marks) a) Show that the volume of the Zn unit cell is given by 6V3R'C. (10 marks) b) Compute the atomic radius for Zn in nm. (8 marks)
1. A single crystal sample of a metal with a HCP structure is subjected to an axial tensile force. The sample is of circular cross-section, with a diameter of 4 mm, and is of 50 mm length. An elastic extension of 0.047 mm is measured when an axial tensile force of 1.25 kN is applied. When the tensile force is increased to 2.8 kN plastic deformation commences. (a) Given that Poisson’s ratio for the metal is 0.35, estimate the theoretical...
Magnesium has the HCP crystal structure. Given the data from the previous problem and the fact that we can take the lattice constant in the c-direction to be 0.497, what is the planar packing factor for the (10 -1 0) (... forgive the formating as I cannot do an overbar here) plane?
(1) A crystalline grain of iron (BCC crystal structure) in a metal plate is situated so that a tensile stress is applied along the [110] crystal direction of the grain, if slip occurs on a (101) plane and a [111] direction, determine the amount of tensile stress that is required to produce a critical resolved shear stress of 31.1MPa in the grain? [15 points] (2) Draw the unit cell structure, and on your sketch indicate: (i) the tensile direction, (ii)...
Iron titanate, FeTiO3, forms in the ilmenite crystal structure that consists of an HCP arrangement of 02- ions. (a) Which type of interstitial site will the Fe2+ ions occupy? sites (b) Which type of interstitial site will the Ti4+ ions occupy? sites (c) What fraction of the total tetrahedral sites will be occupied? (In decimal form to two places to the right of the decimal) (d) What fraction of the total octahedral sites will be occupied? (In decimal form to...
A single crystal in the form of a cube has two possible slip planes. (1) and (2). as shown in the sketch below. Each of these planes has two possible slip directions, (a) and (b), as is also shown. The angle between the tensile load axis and slip plane normal for both slip planes is 450 40 <plane (1)> <plane (2)> a) If a stress is applied to this crystal in the direction noted, specify which particular (eg. plane (1),...
20 points. The frictional shear stress to move a dislocation through a perfect crystal is given by Ti = G exp((-2nd / b(1-v)) where d is the atomic spacing on close packed plane and b is the magnitude of the Burgers vector. Calculate ty for an fcc Cu crystal, if the dislocation is a Shockley partial. The shear modulus Cu is 42 GPa, its Poisson's ratio is 0.3, and its lattice parameter is 3.618.
For the reaction Zn(s) + Cla) -- 2ZnCl2 (s) given the following information: S [Cl2(g)] = +215.0 J/mol K, S [Zn(s) - 41.2 l/mol K and SIZnCl2631 = +107.1 J/mol K a) Determine AS (10 p) b) Determine the AG*rn of ZnCl2() if the AH- -409.1 kJ/mol, at 25°C (10p) c) Determine the AG on for the preparation of 11 g of ZnCl2l) (MM= 136.30 g/mol) (10p)
Q2. Atomic radius, crystal structure, electronegativity, and the most common valence are given in the following table for several elements: for those that are nonmetals, only atomic radii are indicated. Atemic Radias (nm) Electro- negativity Crystal Stractare Which of these elements would you expect to form the following with nickel: (a) a substitutional solid solution having Valence Element +2 18 FCC 0.1246 Ni. 0,071 C complete solubility (b) a substitutional solid solution of incomplete solubility 0.046 0.060 +1 1.9 0.1445...