the attached pic belong to pinion shaft with 10tons weight. this table designed to hand a shaft to let the bearing fit on the shaft by using shaft weight.
the bearing set above the table then the shaft installed vertically untill fit on bearing.
is the table will handle the bearing and the shaft with 10 tons weight ?
the table made of mild steel materials
10mm thick sheet cut square 800mm x 800mm with hole in the center with diameter of 480mm
and the strucrure made of 40mmx40mmx4mm square hollow beam 1100mm hight & 780mm width
the attached pic belong to pinion shaft with 10tons weight. this table designed to hand a...