please rate please
= 2.4-8 The fixed-end bar ABCD consists of three prismatic segments, as shown in the figure....
The pin-connected structure shown in Fig. 5 consists of a rigid bar ABCD and two 1,500-mm-long bars. Bar (1) is steel [E=200 GPa] with a cross-sectional area of A1 = 510 mm2. Bar (2) is an aluminium alloy [E-70 GPa] with a cross-sectional area of A2 1,300 mm2. All bars are unstressed before the load P is applied. If a concentrated load of P 200 kN acts on the structure at D determine: (a) the normal stresses in both bars...
A 3 m rigid bar AB is supported with a vertical translational spring at A and a pin at B The bar is subjected to a linearly varying distributed load with maximum intensity g Calculate the vertical deformation of the spring if the spring constant is 700 kN/m. (ans: 21.43 mm) 2. A steel cable with a nominal diameter of 25 mm is used in a construction yard to lift a bridge section weighing 38 kN. The cable has an...
A bar ABCD with varying cross section and subjected to axial loads is shown schematically in Figure Q3. Take modulus of elasticity of bar as 202 GPa. The length of each section L1 = 111 mm; L2 = 205 mm; and L3 = 451 mm. The cross sectional dimensions are as follows: Section 1 is square with side 49 mm, Section 2 is circular with diameter 79 mm and Section 3 is circular with diameter 32 mm. The forces are...
3- (SKMMIH3/SME2113) from plastic having modulus of elasticity, E-4.0GPa a) Bar ABCD shown in Figure Q3a is made The bar consists of three segments, AB, BC, and CD. Segment AB is hollow and segments BC and CD are solids If the shortening (contraction) of bar ABCD is limited to 4.0 mm, determine the maximum allowable force P to be applied at C. (8 marks) 90 mm ΟΙ 00 mm 1080 min PL 500 mm 250 mm 250 mm Figure Q3a...
The fixed end bar ABCD is constructed of two different metals as shown in the figure. Determine Question 2 (30 pts): The fixed-end bar ABCD is constructed of two different metals as shown in the figure. Determine: Reactions at A and B (14 pts) 6 Maximum normal stress (8 pts) 00w 0 Displacement of point C with respect to point D(8pts) Se* (Hint 1: Derive the expressions for the reactions using equilibrium and equation of compatibility a. b. c. A2...
Chapter 5, Problem 35P Bookmark Show all steps ON Problem The pin-connected structure shown in Figure P5.35/36 consists of a rigid beam ABCD and two supporting bars. Bar (1) is a bronze alloy [E105 GPa] with a cross-sectional area of A1 290 mm2. Bar (2) is an aluminum alloy [E70 GPa] with a cross-sectional area of A2 650 mm2. If a load of P 30 kN is applied at B, determine (a) the normal stresses in both bars (1) and...
The three-bar truss ABC shown in the figure has a span L = 3 m and is constructed of steel pipes having cross-sectional area A = 3900 mm and modulus of elasticity E = 200 GPa. A load P acts horizontally to the right at joint C. (a) If P= 500 kN, what is the horizontal displacement of joint B? (b) What is the maximum permissible load Pox if the displacement of joint B is limited to 2.5mm? 45 45°...