Question

Question 4 You are given three different readings of voltages, which are 240 V, 237 V...

Question 4
You are given three different readings of voltages, which are 240 V, 237 V and 241 V.

Determine if their imbalance across the phases is within range.
Show all your calculations.

This question is based on Refrigeration

0 0
Add a comment Improve this question Transcribed image text
Answer #1

LUULUT Given V= 2400 U2= 237V U3=2411 Step 1: Find the average of @ voltages 240+ 237 +241 = 239.33 V Step 2: Find the Unbala

Add a comment
Know the answer?
Add Answer to:
Question 4 You are given three different readings of voltages, which are 240 V, 237 V...
Your Answer:

Post as a guest

Your Name:

What's your source?

Earn Coins

Coins can be redeemed for fabulous gifts.

Not the answer you're looking for? Ask your own homework help question. Our experts will answer your question WITHIN MINUTES for Free.
Similar Homework Help Questions
  • Question 4 In Figure Q4, a resistance, R is connected in series with an iron-cored choke coil (r in series with L). The circuit draws a current of 5 A at 240 V, 60 Hz. The voltages across the res...

    Question 4 In Figure Q4, a resistance, R is connected in series with an iron-cored choke coil (r in series with L). The circuit draws a current of 5 A at 240 V, 60 Hz. The voltages across the resistance and the coil are 100 V and 200 V respectively. Analyze the circuit to determine the following (a) the resistance, reactance and impedance of the coil, (b) the power absorbed by the coil, and (c) the power factor (pf) of...

  • Please show work. Nice handwriting appreciated. thank you V1 0/12V C.I Rl 0.25 L1 1mH 22uF...

    Please show work. Nice handwriting appreciated. thank you V1 0/12V C.I Rl 0.25 L1 1mH 22uF 1kHz Use Complex Analysis to analyze circuit. Express complex results in exponential notation. Analyze the RLC circuit. All phases are relative to the input voltage. 1. Determine the complex voltage (amplitude and phase) across the inductor. (76.7 V, 165 degh 2. Determine the complex voltage (ampl and phase) across the capacitor. (88.3V, -14 deg) 3. Determine the complex voltage (ampl and phase) across the...

  • Please show all work: 5. Conceptual question, no calculations are required. You have a 4 V...

    Please show all work: 5. Conceptual question, no calculations are required. You have a 4 V battery, E, and two resistors, R and R2, that you configure in two different ways, A and B, shown below. Assume that R2 is twice as large as R1. A) For configuration A, what is the current l3 (expressed in terms of the other currents)? B) for configuration B, what is the current l3 (expressed in terms of the other currents)? C) Which configuration...

  • Use the circuit below to complete the given MATLAB script to plot the three voltages Vr,...

    Use the circuit below to complete the given MATLAB script to plot the three voltages Vr, Vc and VL. Run MATLAB then pick an answer from the choices below that matches the MATLAB plot. MATLAB uncomplete script clc; close all; clear all; Mvs= 10; Avs=30*pi/180; [Xvs Yvs]=pol2cart(Avs, Mvs); Vs=Xvs+j*Yvs; % Impedances values Zr=4; ZL=10j; Zc=-12j; % total equivalent impedance of series R, L and C Zeq = ; %complete % Calculate current It = ; %complete Vr= ; %complete Vc=...

  • Problem 2: A pump station is fed by a 2000 A, 480 V three-phase electrical service....

    Problem 2: A pump station is fed by a 2000 A, 480 V three-phase electrical service. The station runs two small motors, giving it a load profile of 350 kW with a 0.82 lagging PE. Determine the minimum allowed gauge of the service conductors. Feeder lines are aluminum, THW, contained within a raceway with an ambient temperature of 40 °C. State the specific article(s)/tables used to determine your answer. 13 55 The station is being expanded to include two new...

  • Suppose you are given several resistors whose resistances are within the range 15 to 40 Ω....

    Suppose you are given several resistors whose resistances are within the range 15 to 40 Ω. You connect them all in parallel and let your three partners measure the total resistance. Three different measurements have been obtained: 8, 34 and 92Ω. Which of these three you would assume to be correct?

  • Solve question 3 Only, Be very clear/ about evry single step Mark all currents/ voltages assign...

    Solve question 3 Only, Be very clear/ about evry single step Mark all currents/ voltages assign label and polarity redraw simplified circuits then write KVL and KCl equations dont use values, write plain equations first then apply Ohms law. Substitute values last. in equations solve equations for unknowns show step by step solution for each unknown. write clearly. evry step. Do In Every Circuit app Do only question 3 and attach screenshot of the outputs. Make sure answers found match...

  • Q1. You are given a 12 V DC power supply. You are expected to develop a voltage divider to achieve a voltage of no...

    Q1. You are given a 12 V DC power supply. You are expected to develop a voltage divider to achieve a voltage of nominal 5V value using a pair of resistors from the E 12 range, with the restrition that you are not expected to draw a current of more than 1 mA from the 12 V DC supply i. Develop a simple circuit showing the possible values for each resistor pair, and the range of the DC output possible...

  • Part A Five different substances are given to you to be dissolved in water. Which substances...

    Part A Five different substances are given to you to be dissolved in water. Which substances are most likely to undergo dissolution in water? Check all that apply. sodium fluoride, NaF propanol, CH3CH2CH2OH hexane, C6H14 potassium iodide, KI heptane, C7H16 Part B Gastric acid pH can range from 1 to 4, and most of the acid is HCl. For a sample of stomach acid that is 8.22×10−3 M in HCl, how many moles of HCl are in 19.7 mL of...

  • Use the circuit below to complete the given MATLAB script to plot the three voltages Vr....

    Use the circuit below to complete the given MATLAB script to plot the three voltages Vr. Vc and VL. Run MATLAB then pick an answer from the choices below that matches the MATLAB plot. 412 1102 W m Zr ZL + Vr - + VL - + Vc Zc 5-122 10/30°v vs MATLAB uncomplete script clc; close all; clear all; Mvs= 10; Avs=30pi/180; [Xvs Yvs]=pol2cart(Avs, Mvs); Vs=Xvs+j"Yvs; % Impedances values Zr=4; ZL=10j; Zc--12j; % total equivalent impedance of series R....

ADVERTISEMENT
Free Homework Help App
Download From Google Play
Scan Your Homework
to Get Instant Free Answers
Need Online Homework Help?
Ask a Question
Get Answers For Free
Most questions answered within 3 hours.
ADVERTISEMENT
ADVERTISEMENT
ADVERTISEMENT