1. What are the functions and design Requirements for a hydraulic jack used for a car...
A hydraulic lift is used to jack a 950-kg car 42 cm off the floor. The diameter of the output piston is 17 cm , and the input force is 360 N . What is the area of the input piston? What is the work done in lifting the car 42 cmcm ? If the input piston moves 13 cmcm in each stroke, how high does the car move up for each stroke? How many strokes are required to jack...
A hydraulic lift is used to jack a 940-kg car 42 cm off the floor. The diameter of the output piston is 19 cm , and the input force is 360 N . A) What is the area of the input piston? Express your answer using two significant figures. B)What is the work done in lifting the car 42 cm ? Express your answer using two significant figures. C)If the input piston moves 14 cm in each stroke, how high...
A hydraulic jack is designed to lift a car by exerting an output force 100 times as large as the input. (a) What must be the ratio of the cylinder diameter on the output side to that on the input side? (b) If the input side is pushed down by 10 cm, how much does the output side move up? (The fluid volume loss on the input side is gained on the output side.) (c) Show that the work we...
A hydraulic jack is made with a small piston 1.4 cm in diameter that is used to move a large piston 5.3 cm in diameter. If a man can exert a force of 400 N on the small piston, how heavy a load can he lift with the jack?
7.The hydraulic jack of a car illustrates: a.Hooke's Law b.Newton's Third Law c.The Pascal Principle d.None of the above 10. Bernoulli's equation is a derivation of the conservation law of: a.Mass b.Energy c.Linear momentum d.None of the above
Consider the hydraulic jack represented beside. It is filled with mineral oil (a lubricating liquid). Assume that a person is able to push the left piston (F1) with a maximum force of 343 N. The diameter of the piston on the left is only 2 cm and that of the piston on the right much larger at 40 cm. • A) If the piston on the right is used to lift a car, what is the highest car weight (in...
a force of 227N is applied to a hydraulic jack piston that is 0.0250m in diameter. the piston supporting the load has a diameter of 0.175m (ignore any difference in height between the two pistons) a. what is the magnitude of the output force (N) on the hydraulic jack? b. how much mass (kg) can be lifted by the jack?
just make automation circuit for it PROJECT 4: DESIGN A HYDRAULIC MOBILE CRANE . . REQUIREMENTS: Design the system to carry load of up to 5000 lb Use a hydraulic winch (rotary actuator) to move the pulleys up and down Use fail-safe measures to support positive loads and run-away issues The speed of the crane should be changeable Use dampeners to prevent vibration and maintain pressure and flow where necessary . . . MOBILE CRANE :- 2 8 7
Question 4Co Comps A hydraulic jack can be used to raise point B of the cantilever beam ABC shown in Figure Q4. The beam was originally straight, horizontal, and unloaded. A 20 kN load was then applied at point C, causing this point to move down. By drawing the bending- moment diagram by parts, determine a) the reaction at B when the jack raise to return point C to its original position, [10 marks [10 marks] 15 marks] b) how...
Which of the following is a type of lifting mechanism used in the automotive industry? hydraulic jack pneumatic jack mechanical jack all listed above