A platinum resistance thermometer has resistances of 180.0 when placed in a 0
Initial temperature is 20C, Final temperature is
0C,R0=180?
R0 = R20 [1+(3.92x10-3)(0-20)]
180? = R20 (.9216)
R20 = 195.3 ?
Rmeltingtemp = 249.8?
Let T = melting temp
249.8 = 195.3[1+(3.93x10-3)(T-20)]
1.279 = 1+(3.93x10-3)(T-20)
0.279 = (3.93x10-3)(T-20)
T - 20 = 71
T=91 C
A platinum resistance thermometer has resistances of 180.0 when placed in a 0
A platinum resistance thermometer has a resistance of 200 Ω when placed in an ice 0◦C bath and 232.6 Ω when immersed in a crucible containing a melting substance. What is the melting point of the substance? The temperature coefficient of the platinum is 0.00392 (◦C)−1 . The resistor was calibrated at a temperature of 20◦C. Answer in units of ◦C.
A platinum resistance thermometer has a resistance of 200 Ω when placed in an ice 0◦C bath and 204.7 Ω when immersed in a crucible containing a melting substance. What is the melting point of the substance? The temperature coefficient of the platinum is 0.00392 (◦C)−1 . The resistor was calibrated at a temperature of 20◦C. Answer in units of ◦C.
A platinum resistance thermometer has a re- sistance of 200 ohms. A platinum resistance thermometer has a resistance of 200 ohm when placed in an ice 0 degree C bath and 290.8 Ohm when immersed in a crucible containing a melting substance. What is the melting point of the substance? The temperature coefficient of the platinum is 0.00392 (degreeC)^-1 . The resistor was calibrated at a temperature of 20 degree C. Answer in units of degree C. A platinum resistance...
An unknown length of platinum wire 1.14 mm in diameter is placed as the unknown resistance in a Wheatstone bridge (see figure). Arms 1 and 2 have resistance of 39.6 92 and 28.8 12, respectively. Balance is achieved when R3 is 3.88 22.(Figure 1) Part A How long is the platinum wire? 190 AED ? Figure C 1 oft m B Rs Submit Request Answer Ammeter Provide Feedback RA 2 D
2. Consider the Wheatstone bridge shown above in a platinum resistance thermometer between 0°C and 50°C. The resistance temperature rate is 8.2/°C. At 0°C, the nominal resistance is 500 12. This indicates that the three arms have a resistance of 500 12 each (R = R2 = R3 = 500 l) with an excitation voltage of 10 V. (a) Calculate the output voltage, V, at balance (0°C). (b) What is R4 at 25°C and 50°C? (c) What is the output...
Whole questions 20 marks Q.4 Here WX is 1m wire of uniform resistance, Y is a sliding contact Its position is adjusted until voltmeter V is equal to 0 a) Use loops WZYW and XYZX ) Find the equation for resistance of the PRT using Kirchhoff's laws.(in terms of I and 11 and explain the steps.) i) Find the value of the resistor (R) using Kirchhoff's laws. b)Here the resistor R is a 224 ohm resistor v is 0 when...
Determine the potential of a platinum electrode (vs. SHE) when placed in a mixture of 0.00266 M TIC12 and 0.0371 M TICi at 25 °C 3+ TI (aq)2 e TI* (aq) E° = 1.25 V Ept = V Determine the potential of a platinum electrode when placed in a mixture of 0.0144 M potassium permanganate (KMnO4) and 0.0821 M manganese chloride (MnCl2) at pH 6.21 and 25 °C ,2+ MnO4 (aq)5e +8H* (aq) Mn2(aq) 4H201) E 1.51 V ЕPРЕ V...
(20) A platinum temperature sensor operates over a broad temperature. Its resistance is related to the temperature by R Ro Gt+ C2t2, where t is temperature in C and R is in Ω. Suppose one platinum temperature sensor has a resistance of 100 Ω at a reference temperature 0 °C; its resistance is measured as 139.4 Ω at a temperature 1. at a temperature of 200 °C. (a) Find the values of coefficients Ro. C and C2
,. Design an Op-Amp-based thermometer as shown below. The thermistor has a resistance, Rr, that early with increasing temperature; thus RT-α1 +8, where is the temperature in Fahrenheit, nts and AT is the resistance in k2. Two typical temperature/resistance values are shown in the table Temperature Room Temperature 70.6 50 Body Temperature 98.6 T (F) RT (ks2) 36 (a) Find the constants a and B. (b) Find RF, so that at room temperature, vi6 V (c) Find values for Ri...
A carbon resistor is to be used as a thermometer. On a winter day when the temperature is 4.0 ∘C, the resistance of the carbon resistor is 218.0 Ω . Part A What is the temperature on a spring day when the resistance is 215.2 Ω ? (Take the reference temperature T0 to be 4.0 ∘C.)