RI 1111 2:54 PM ぐ Hw 7.pdf (40 pts) Water is pumped from the large tank...
Fig. Q4 shows a piping arrangement used in a food processing facility to transfer water, at 40 C, from a tank, through a heat exchanger to an elevated tank. A suitable pump is selected which, when installed, delivers the water at 2.5 m'/hr. The pipe diameter is 40 mm and the Absolute Roughness of the pipe material is 0.00008 m. The Loss Coefficients [K Factors] for the Bend and Heat Exchanger are shown in Fig. Q4 4. 2 m K...
A pump transports water from Tank 1 to Tank 2 through a constant-diameter piping system as shown below (not to scale). The flow rate is controlled by two gate valves, the gate valve I controls the main pipeline, while the gate valve II controls the loop line from T-joint A to T-joint B. All pipes are galvanized steel pipe of diameter D = 4 in. It has a total length of Li2= 620 ft from tank 1 to tank 2....
1/9 1 Piping system (14 points) Water is pumped from a reservoir to a large receiver vessel which is maintained at p4 6 bar (absolute) through the operation of the pump and a high pressure nitrogen supply that bleeds into the tank through a regulator. The water enters through an opening at the top of the vessel. A drain is provided at the low point in the system. Elevations are as shown. All valves are gate valves (k = 0.15)...
1/9 1 Piping system (14 points) Water is pumped from a reservoir to a large receiver vessel which is maintained at p4 6 bar (absolute) through the operation of the pump and a high pressure nitrogen supply that bleeds into the tank through a regulator. The water enters through an opening at the top of the vessel. A drain is provided at the low point in the system. Elevations are as shown. All valves are gate valves (k = 0.15)...