please help with steps to solve this problem Figure 2 [25] QUESTION 3 A pinned-pinned round...

Question

Question

Figure 2 [25] QUESTION 3 A pinned-pinned round bar is to be 4m long. It is subjected to a purely axial load. Determine the di

please help with steps to solve this problem

Answer 1

Answer #1

Sall length of bar = 4m. In case of pinned connection le al zam elastic mode to modulus = 207 G8 fos a 1.5 TREI Hone cripling

Answer 2

Similar Homework Help Questions

QUESTION 4 A tourist lodge has a balcony that is supported by a circular column with...

QUESTION 4 A tourist lodge has a balcony that is supported by a circular column with a diametet D = 85mm and it is suspected that the column may fail due to buckling caused by the weight of the balcony The yield stress of the colunu matemal 15 , = 320 MPa and the length of the column 15 1 = 2 23 ni The Rankine constant for the particular system is estimated to be a = 1566 and it...
Looking for Help on 10.19. r of solid circular cross section is 50 mm in diameter....

Looking for Help on 10.19. r of solid circular cross section is 50 mm in diameter. The bar is pinned at each end and subject to axial compression. If the proportional limit of the material is 210 MPa and E 200 GPa, determine the minimum length for which Euler's formula is valid. Also, determine the value of the Euler buckling load if the column has this minimum length. Ans. 1.21 m, 412 kN 10.20. The column shown in Fig. 10-10...
Renang Time! 1 hour, 10 minutes, 56 seconds. Question Completion Status: 1 2. 3 QUESTION 1...

Renang Time! 1 hour, 10 minutes, 56 seconds. Question Completion Status: 1 2. 3 QUESTION 1 A 0.5 m long rod is supported at both of its ends. A fluctuating load of a min. 20,000 N and a max. of 50,000 N acted on the middle of the rod. If the rod has a diameter of 75 mm, and a concentration factor, kt-1.0, find the safety factor of the rod. The material properties of bar are as follows: ultimate strength...