Power radiation Tolerance of the resistor should be around 1 W.
Feel free to ask if you have any query.Thank you.
Question 4 A 2000 resistor connected to a 10 Voltage power source, the calculated power radiation...
Question 3 Which one of the following is a chemical Voltage source? signal generator voltmeter battery cell Power supply 4 points Save to prevent resistor from heating up a 200 resistor of A 2000 resistor connected to a 10 Voltage power source, the calculated power radiation W tolerance should be used.
Question 13) An AC voltage source, with a peak output of 200 V, is connected to a 50.0-resistor. What is the rate of energy dissipated due to heat in the resistor? 566 W 800 W 400 W 200 W O 128 W
5. (Extra 10 pts) A voltage source vs(t) is connected across a 10 resistor. find the average power absorbed by the resistor if vs() equals: vy(t) = 10 cos(25t) + 10sin? (20+) - 4 sin(25t +15°) + 5 V P10 n =
A resistor with a 100 Ω is connected to an AC source with a maximum voltage of 10V. The RMS current and the average power of this resistor are?
An ac source of maximum voltage Vo = = 40 V is connected to a resistor R = 60 12, an inductor L = 0.5 H, and a capacitor C = 30 uF. Find the average power at 60 Hz. Select one: a. 35.3 W b. 70.6 W C. 0.13 W d. 3.53 W e. 7.06 W X
4. (10 pts) Find the voltage across the 202 resistor (marked as V) and the power (P) of the 10V voltage source. 25Q 10V 50 V = + 7A 200 5V 15Q Iy P =
Question 10 4 pts A resistor and an inductor are connected to a source of alternating voltage. The inductor's self inductance is 0.180 H and the resistor's resistance is 90.0 Ohms. The voltage across the inductor is given by VL(t)(12.0 Volts) sin [ (480 rad/sec) t] Calculate the amplitude of the alternating voltage across the resistor. Hints: Use Ohm's Law twice. Once to find the amplitude of the current through the inductor. Then again to find the answer. Also, do...
The total average power dissipated on the s. A Y-connected load has a 1012 resistor on cach phas a、 The power factor is c. Assume the load is switched from Y load is 3000 W ase ure to A. The total average power dissipated on the load Th is 5V 9. Using voltage division, find vi and v2 V2 300Ω 100Ω 200Ω 200Ω 10. A sinusoidal source of voltage is connected in series with a resist tor, a capacitor, and...
The instantaneous power dissipated by a 20Ω resistor connected to an AC source is shown in (Figure 1).Part AWhat is the \(\mathrm{rms}\) voltage across the resistor?Part BWhat is the peak current through the resistor?Part CWhat is the frequency of the AC source?
A 200-Ω resistor is connected across an ac voltage source V = (150 V) sin [2π(60 Hz)t]. What is the average power delivered to this circuit (in Watt)?