Suppose that a flow reactor operates isothermally at 800 K and 3 atm where ideal gas behavior can be assumed. A gas mixture at 800 K and 3 atm containing 90% N2, 8% O2 and 2% NH3 by volume flows into the reactor at a rate of 4 L min-1 and reacts according to reaction .
4NH3+5O2----->4NO+6H20
(a) If this reactor was being used to generate kinetics data, it might be necessary to write an expression for the outlet partial pressure of ammonia in terms of known constants and the outlet molar flow rate of ammonia in order to analyze the data. In doing so, it is important to recognize that the total outlet molar flow rate will change when the outlet molar flow rate of ammonia changes. Write the expression for the outlet partial pressure of ammonia in terms of known constants and the outlet molar flow rate of ammonia.
(b) Further suppose that in one kinetics experiment using this reactor, the outlet flow was found to contain 1.6% NO. During the analysis of the data, it might also be necessary to calculate the outlet molar flow rate of NH3 in this experiment. What is the outlet molar flow rate of ammonia in this experiment and what ammonia conversion does this correspond to?
here
t=800k
p=3
reaction
4NH3+5O2----->4NO+6H20
given that it can be behave like idealy
The ideal gas equation is:
pV = nRT
Suppose that a flow reactor operates isothermally at 800 K and 3 atm where ideal gas...
Note: The following information may or may not be used in solving the problems. Gas constant, R=8.314 kPa L/(mol K) (1-)|150(1-φ)4+1. PgeDpa where is porosity, p is gas density, dP G The Ergun equation: Dp dz p is gas viscosity, G is superficial mass velocity, and D, is particle diameter. 5. (20 pts.) Consider a dehydrogenation of alkane (A B+C) in an inert membrane reactor with catalyst pellets on the feed side. The reactor has an inner diameter of 1...
Methane gas is burned with 30 percent excess air. This fuel enters a steady- flow combustor at 0.8 atm and 25oC and is mixed with the air. The products of combustion leave this reactor at 0.8 atm and 1600 K. Determine the equilibrium composition of the products of combustion and the amount of heat released by this combustion in kJ/kmol methane. Use data from the tables CH 25°C CO2, H3O chamber NO. O2 N2 1600 K 30% excess air 25°C...
1. Which of the following are the sites within the human body where carbon dioxide and oxygen are exchanged? A. Alveoli B. Arteries C. Synapses D. Venules 2. Which of the following describes the most important reason for repeating an experimental investigation? A. To verify the validity of the original findings B. To expand upon the original investigation C. To manipulate the independent variable D. To attempt to disprove the hypothesis 3. Lithium has an atomic number of 3 and...