A lossless transmission line with characteristic impedance of 75Ω measures 1.4λ at a certain working frequency....
A lossless transmission line with characteristic impedance of 75Ω measures 1.4λ at a certain working frequency. The line is powered by a generator with negligible impedance and an open circuit voltage of Vg=10∠0° [V]. A load of 50-i50Ω is connected at the end of the line.
Find
a) The reflection coefficient.
b)The stationary wave ratio.
c)The input impedance of the line.
d)The voltage at the entrance of the line.
e)The voltage at the load.
f)The average power delivered to the line.
g)The average power delivered to the load.
h)The voltage at 1m from the load.
i)The current at 50 cm from the load.
**Please write down the formulas used.
Homework Answers
Add Answer to:
A lossless
transmission line with characteristic impedance of 75Ω measures
1.4λ at a certain working frequency....
1) A lossless transmission line that is 3N2 long with an impedance of 75Ω terminated by a load of...
1) A lossless transmission line that is 3N2 long with an impedance of 75Ω terminated by a load of 25 Ω The generator has a voltage of V,r-2sin(et) V and an internal impedance Ζ'50Ω (a) For this circuit give Vg, T, and the voltage standing wave ratio. (b) Give Vin. Inand Vo (c) Give and I (d) Give the voltage and current at the midpoint of the line (ie. P(z) and I(2) at z-3/4). (e) From the answer of (d)...
3, A lossless transmission line of length 1 = 1.57λ and characteristic 17 +j60Ω. impedance Z,...
3, A lossless transmission line of length 1 = 1.57λ and characteristic 17 +j60Ω. impedance Z, = 50Ω is loaded with an impedance of ZL Compute the following: (a) Reflection coefficient at the load in both rectangular and polar form. (b) SWR, and RL (c) Input impedance at the generator. (d) Reflection coefficient at the input to the transmission line in both rectangular and polar form
Q1. (20pts) Consider a lossless transmission line with characteristic impedance Zo=50 Q is used to connect...
Q1. (20pts) Consider a lossless transmission line with characteristic impedance Zo=50 Q is used to connect a sinusoidal source with internal resistance Rs=50 2, and 10 Volts peak value to feed a load of ZL=300 Q. At an operating signal wavelength of do, the length of the transmission line is L=2.25o. Determine the followings: a) Standing wave ratio on the line b) Average power delivered to the load in dBm. c) The voltage and current phasor expressions on the transmission...
Question 4 (a) The input impedance of a lossless air-core transmission line with characteristic impedance Ro. phase constant B and length I terminated in an impedance Z, is given by R,+Z, tan( i....
Question 4 (a) The input impedance of a lossless air-core transmission line with characteristic impedance Ro. phase constant B and length I terminated in an impedance Z, is given by R,+Z, tan( i. Determine the length of an open circuit 50Ω line required to create a 0.1 nH inductor at a frequency of 10 GHz. (6 marks) ii. Determine the input impedance of the line in part () if the open circuit is changed to a short circuit. (3 marks)...
A transmission line with characteristic impedance of 100 ? is connected to a 200+j400 ? load....
A transmission line with characteristic impedance of 100 ? is connected to a 200+j400 ? load. Use Smith chart to calculate (i) standing wave ratio (ii) reflection coefficient (iii) lengths and locations of a short circuited shunt stub to match the load to the transmission line.
A 2.5 meter long section of Zo=50 12 lossless coaxial transmission line is connected to a...
A 2.5 meter long section of Zo=50 12 lossless coaxial transmission line is connected to a source with vg(t) = 10 sin(611 10't + 60°) (V) and Zg=150 12. If the line, which uses insulating material with a relative permittivity of &r=4, is terminated in a load ZŁ=(100 – j 50) (2, determine: (a) Wavelength a on the line. (b) The reflection coefficient I at the load. (c) The input impedance at the source. (d) The voltage phasor V; at...
For a lossless transmission line extending from 1 = -1 to 1 = 0) with characteristic...
For a lossless transmission line extending from 1 = -1 to 1 = 0) with characteristic impedance Zo, and terminated with a load impedance, ZL, find the ratio of the backward to forward voltage wave amplitude, V /V+.
Problem 2.25 A lossless transmission line is terminated in a short circuit. How long (in wavelengths)...
Problem 2.25 A lossless transmission line is terminated in a short circuit. How long (in wavelengths) should the line be in order for it to appear as an open circuit at its input terminals? Problem 2.27 A 75-Ω resistive load is preceded by a λ/4 section of a 50-Q lossless line, which itself is preceded by another λ/4 section ofa 100-Q line. What is the input impedance? Problem 2.31 A generator with 300 V and Znected to a load ZL...
32 1. There are three transmission line and one 4 transmission line (all characteristic impedance of transmission l...
32 1. There are three transmission line and one 4 transmission line (all characteristic impedance of transmission line is v2zo and assume lossless line) and there are two loads of load impedance Zo 214 iz Zi=?> 2/4 A/4 short 32/4 (a) Find the input impedance (Zn) (b) If the input power is 1 watt, find the transmitted power to each load Zo
32 1. There are three transmission line and one 4 transmission line (all characteristic impedance of transmission line...
7) Two half-wave dipole antennas, each with an impedance of 75 Ω, are connected in parallel throu...
7) Two half-wave dipole antennas, each with an impedance of 75 Ω, are connected in parallel through a pair of 0.5-A transmission lines, and the combination is connected to a feed 0.25-2 transmission line, as shown in the Figure. 75Ω (Antenna) (a) What is the impedance of the 0.25-2 feed transmission line such that Zin will be matched to a 5042 TL? (b) If the result of (a) is connected to a 50 Ω TL that is, in turn, connected...
1) A lossless transmission line that is 3N2 long with an impedance of 75Ω terminated by a load of 25 Ω The generator has a voltage of V,r-2sin(et) V and an internal impedance Ζ'50Ω (a) For this circuit give Vg, T, and the voltage standing wave ratio. (b) Give Vin. Inand Vo (c) Give and I (d) Give the voltage and current at the midpoint of the line (ie. P(z) and I(2) at z-3/4). (e) From the answer of (d)...
3, A lossless transmission line of length 1 = 1.57λ and characteristic 17 +j60Ω. impedance Z, = 50Ω is loaded with an impedance of ZL Compute the following: (a) Reflection coefficient at the load in both rectangular and polar form. (b) SWR, and RL (c) Input impedance at the generator. (d) Reflection coefficient at the input to the transmission line in both rectangular and polar form
Q1. (20pts) Consider a lossless transmission line with characteristic impedance Zo=50 Q is used to connect a sinusoidal source with internal resistance Rs=50 2, and 10 Volts peak value to feed a load of ZL=300 Q. At an operating signal wavelength of do, the length of the transmission line is L=2.25o. Determine the followings: a) Standing wave ratio on the line b) Average power delivered to the load in dBm. c) The voltage and current phasor expressions on the transmission...
Question 4 (a) The input impedance of a lossless air-core transmission line with characteristic impedance Ro. phase constant B and length I terminated in an impedance Z, is given by R,+Z, tan( i. Determine the length of an open circuit 50Ω line required to create a 0.1 nH inductor at a frequency of 10 GHz. (6 marks) ii. Determine the input impedance of the line in part () if the open circuit is changed to a short circuit. (3 marks)...
A 2.5 meter long section of Zo=50 12 lossless coaxial transmission line is connected to a source with vg(t) = 10 sin(611 10't + 60°) (V) and Zg=150 12. If the line, which uses insulating material with a relative permittivity of &r=4, is terminated in a load ZŁ=(100 – j 50) (2, determine: (a) Wavelength a on the line. (b) The reflection coefficient I at the load. (c) The input impedance at the source. (d) The voltage phasor V; at...
For a lossless transmission line extending from 1 = -1 to 1 = 0) with characteristic impedance Zo, and terminated with a load impedance, ZL, find the ratio of the backward to forward voltage wave amplitude, V /V+.
Problem 2.25 A lossless transmission line is terminated in a short circuit. How long (in wavelengths) should the line be in order for it to appear as an open circuit at its input terminals? Problem 2.27 A 75-Ω resistive load is preceded by a λ/4 section of a 50-Q lossless line, which itself is preceded by another λ/4 section ofa 100-Q line. What is the input impedance? Problem 2.31 A generator with 300 V and Znected to a load ZL...
32 1. There are three transmission line and one 4 transmission line (all characteristic impedance of transmission line is v2zo and assume lossless line) and there are two loads of load impedance Zo 214 iz Zi=?> 2/4 A/4 short 32/4 (a) Find the input impedance (Zn) (b) If the input power is 1 watt, find the transmitted power to each load Zo
32 1. There are three transmission line and one 4 transmission line (all characteristic impedance of transmission line...
7) Two half-wave dipole antennas, each with an impedance of 75 Ω, are connected in parallel through a pair of 0.5-A transmission lines, and the combination is connected to a feed 0.25-2 transmission line, as shown in the Figure. 75Ω (Antenna) (a) What is the impedance of the 0.25-2 feed transmission line such that Zin will be matched to a 5042 TL? (b) If the result of (a) is connected to a 50 Ω TL that is, in turn, connected...
Most questions answered within 3 hours.
-
The free energy change for the following reaction at 25 °C, when
[Sn2+] = 1.17 M...
asked 1 hour ago -
An MNE is this kind of industry when competition in one country
is essentially independent of...
asked 2 hours ago -
. For this set of questions, determine what
proportion of a normal distribution is located betweeneach...
asked 3 hours ago -
A college student is employed as a door-to-door newspaper
salesman. Historical data suggests that the student...
asked 4 hours ago -
MATLAB HW 11 problem using Switch Case and Input commands
Write a script file that calculates...
asked 4 hours ago -
Considering gravitational time dilation, calculate the time that
passes in Earth’s surface while 1 hour passes...
asked 4 hours ago -
Minitab Problem: Take the Lake Hume June rainfall data and find
use the processes outlined in...
asked 5 hours ago -
X Company is trying to decide whether to continue using old
equipment to make Product A...
asked 5 hours ago -
IN PYTHON ONLY !! Program 2: Re-work
program #5 (WeeklyHours) from the previous assignment such that...
asked 6 hours ago -
The average length of time between arrivals at a turnpike
toll-booth is 26 seconds. What is...
asked 7 hours ago -
(a) A piston at 6.1 atm contains a gas that occupies a volume of
3.5 L....
asked 9 hours ago -
Please answer true or false. Words
cannot be changed or added in to make it true...
asked 9 hours ago