A main conveyor has two conveyors, A and B, feeding it. Feeder conveyor A puts six-packs of canned soda on the main conveyor. Feeder conveyor B puts eight-packs of canned soda on the main conveyor. Both feeder conveyors have counters that count the number of packs leaving them. Construct a PLC program to give a total count on the main conveyor and display this number as a decimal value on a four-digit BCD format LED display. Use the following addresses:
A main conveyor has two conveyors, A and B, feeding it. Feeder conveyor A puts six-packs...
1. Would math instructions be classified as input or output instructions? (1 pt.) 2. What will the value of N7:2 be when the below instruction executes? (1 pt.) -ADD Add Source A 17:0 Source B N7:1 Dest 3. What will the value of N7:5 be when the below instruction executes? (2 pts.) -SUB Subtract Source A N73 30 Source B N7:4 Dest N7:5 4. What will the value of N7:8 be when the below instruction executes? (2 pts.) MUL Multiply...
Note: The conveyor will be operated and programmed in Safety Mode (switch the conveyor output to the NC position) so that the Motor will stop when it receives a signal. When the switch S_3 is activated, the conveyer is required to run (M_R OFF). When the conveyor is running the green light L_2 is to be energized The fiber optic sensor FP_S must count the TOTAL parts that go through the conveyor. The inductive sensor IP S must count the...
please help me write PLC programming, im having trouble doing it. · The Bottle Size selector switch will determine how much to fill up the bottles and how many bottles go into a box. When the selector switch is on then Large bottles are being made - filled for 4.50 seconds and 6 go into a box. If the selector switch is off then Small bottes are being made – filled for 3.00 seconds and 12 go into a box. · ...