Some smaller refrigeration as well as air-conditioning cycles discharge condenser waste heat to the atmosphere via air-cooled heat exchangers. How does it affect the coefficient of performance of a cycle in comparison to a cycle that discharges heat via a wet cooling tower? Explain.
Some smaller refrigeration as well as air-conditioning cycles discharge condenser waste heat to the atmosphere via...
4. A water chiller provides 100 tons 3.516 kw/ton of refrigeration to cool water to a temperature of 12.10 C for an air conditioning system. The heat extracted from the water is to be rejected in a cooling tower at 35.4°C, Assuming that the chiller operates on an ideal vapour refrigeration cycle with the temperature in the evaporator equal to the chilled water temperature and the saturation temperature in the condenser equal to the cooling tower water temperature, determine (a)...
4. Refrigeration and air conditioning is quite useful, but it is, in effect, a way to move heat from a low temperature to a high temperature. Is this possible, given the second law? Answer the following questions below, for R-134a (a common refrigerant), and then state whether you believe refrigeration violates the second law, and why (or why not) a. R-134a arrives to the inside of the refrigerator that you are trying to keep cooled to T- 4°C. The air...
Cooling tower is a special recycling device which applies the heat rejection process. Figure Q4 (a) shows the cooling tower system that extracts waste heat to the atmosphere through the cooling of a water stream to a lower temperature. Sketch the water recycle in the cooling tower Q4 (a) (5 marks) High leaving water temperature will cause a drop in process cooling efficiency, increasing system power consumption, creating physical discomfort to people within an air-conditioned area, and have a detrimental...
summatize the following info and break them into differeng key points. write them in yojr own words apartus 6.1 Introduction—The design of a successful hot box appa- ratus is influenced by many factors. Before beginning the design of an apparatus meeting this standard, the designer shall review the discussion on the limitations and accuracy, Section 13, discussions of the energy flows in a hot box, Annex A2, the metering box wall loss flow, Annex A3, and flanking loss, Annex...