Use Maple to solve the problem shown below Pt has a work function larger than almost...
Use Maple to solve the problem shown below
Pt has a work function larger than almost any other metal, 6.35 eV. What is the longest wavelength of light that can dislodge an electron from Pt metal?
Homework Answers
Add Answer to:
Use Maple to solve the problem shown below
Pt has a work function larger than almost...
Problem (8 points) For the Photoelectric Effect experiment shown, when ultraviolet light with a wavelength of...
Problem (8 points) For the Photoelectric Effect experiment shown, when ultraviolet light with a wavelength of 240 nm shines on a particular metal plate, electrons are emitted from plate 1, crossing the gap to plate 2 and causing a current to flow through the wire connecting the two plates. The battery voltage is gradually increased until the current in the ammeter drops to zero, at which point the battery voltage is 1.40 V plate 2 AV incident ◇e electrons Tammeter...
1) Light of wavelength 310nm is shined on a metal with work function = 1 eV....
1) Light of wavelength 310nm is shined on a metal with work function = 1 eV. What will be the maximum kinetic energy of the emitted electrons? 2) Light is shined on a metal with work function 2.0 eV, and electrons are emitted creating a photocurrent. When a decelerating voltage of magnitude 1.0 V is applied, the current goes to zero (i.e. the magnitude of the stopping voltage is 1V). What is the wavelength (in nm) of the incoming light?...
The work function for lithium is 300 kJ/mole. What is the wavelength of light that will...
The work function for lithium is 300 kJ/mole. What is the wavelength of light that will remove an electron from an atom in lithium metal so that it has an ejected energy of 0.5 eV once free of the lithium atom?
Sodium metal has a work function of 2.28 eV. (a) At what wavelength of incident light...
Sodium metal has a work function of 2.28 eV. (a) At what wavelength of incident light will electrons be ejected from the material? (b) If light of wavelength 450 nm is incident on the sodium, determine the maximum kinetic energy of the ejected electrons 13.4
Metal A has a higher work function than metal B. The lowest frequency of light that...
Metal A has a higher work function than metal B. The lowest frequency of light that will cause electrons to be emitted from metal B is fB Which of the following is true: Select one: a. light of any frequency will cause photoelectrons to be emitted from metal A, but only above a threshold intensity determined by the work function b. light of any frequency will cause photoelectrons to be emitted from metal A, but the lower the frequency, the...
Quantum Physics - Photoelectric Effect 1 Light Light2 Photo- electrons KEL KEN-W Photoelectric Effect Lenard found...
Quantum Physics - Photoelectric Effect 1 Light Light2 Photo- electrons KEL KEN-W Photoelectric Effect Lenard found that light has to be above a certain frequency in order to observe photoelectrons The Planck constant is 6.626x10^-34 J s. The calcium metal has a work function WO = 2.71 eV, 1eV = 1.6x10^-19). (a) What is the Cutoff frequency for the calcium metal? Write the result in terms of 1014Hz. Keep 3 decimal places. Enter a number x1024Hz Submit (5 attempts remaining)...
Cesium metal is to be used as the photocathode material in a photoemissive electron tube because electrons are relative...
Cesium metal is to be used as the photocathode material in a photoemissive electron tube because electrons are relatively easily removed from a cesium surface. The work function of a clean cesium surface is 1.9 eV. What is the longest wavelength of radiation which can result in photoemission? a. b. If blue radiation of wavelength 450 nm is incident onto the Cs photocathode, what will be the kinetic energy of the photoemitted electrons in eV? What should be the voltage...
1. Calculate the Work Function of a metal that has a threshold frequency of 9.54 x...
1. Calculate the Work Function of a metal that has a threshold frequency of 9.54 x 1014 s-1. answer: 63.3*10^(-20)J 2. What is the wavelength of this light in nm? answer: 314nm 3. What would be the Kinetic Energy of an ejected photoelectron if 3.26 x 1015 s-1 light struck (hit) that same metal? answer: 1.53*10^(-18)J 4. What would be the velocity and De Broglie Wavelength of ejected photoelectron? answer: 1.83*10^(6)m/s 5.What is the wavelength of light (in nm) of...
8. (The next two questions correspond to the same problem.) You irradiate the surface of a metal (with work function of...
8. (The next two questions correspond to the same problem.) You irradiate the surface of a metal (with work function of 4.31 eV) with a KrF laser. The laser wavelength is 248 nm. [3 pts] What is the maximum speed of photoelectrons produced in this experiment? (a) o (b) 123 km/sec (c) 373 km/sec (d) 495 km/sec (e) No photoelectrons are produced. 9. [2 pts) Which action would you take if you would like to reduce the maximum speed of...
Question 7 1 pts When light of wavelength , illuminates the surface of Metal 1, the...
Question 7 1 pts When light of wavelength , illuminates the surface of Metal 1, the stopping voltage is V. In terms of V, what will be the stopping voltage if the same wavelength is used to illuminate the surface of Metal 2? The work function of Metal 1 is 5.7 eV and the work function of Metal 2 is 2.1 eV. 3.6 volts - V O V-3.6 volts OV+3.6 volts 2.1 volts - V 5.7 volts - V Consider...
Problem (8 points) For the Photoelectric Effect experiment shown, when ultraviolet light with a wavelength of 240 nm shines on a particular metal plate, electrons are emitted from plate 1, crossing the gap to plate 2 and causing a current to flow through the wire connecting the two plates. The battery voltage is gradually increased until the current in the ammeter drops to zero, at which point the battery voltage is 1.40 V plate 2 AV incident ◇e electrons Tammeter...
Sodium metal has a work function of 2.28 eV. (a) At what wavelength of incident light will electrons be ejected from the material? (b) If light of wavelength 450 nm is incident on the sodium, determine the maximum kinetic energy of the ejected electrons 13.4
Quantum Physics - Photoelectric Effect 1 Light Light2 Photo- electrons KEL KEN-W Photoelectric Effect Lenard found that light has to be above a certain frequency in order to observe photoelectrons The Planck constant is 6.626x10^-34 J s. The calcium metal has a work function WO = 2.71 eV, 1eV = 1.6x10^-19). (a) What is the Cutoff frequency for the calcium metal? Write the result in terms of 1014Hz. Keep 3 decimal places. Enter a number x1024Hz Submit (5 attempts remaining)...
Cesium metal is to be used as the photocathode material in a photoemissive electron tube because electrons are relatively easily removed from a cesium surface. The work function of a clean cesium surface is 1.9 eV. What is the longest wavelength of radiation which can result in photoemission? a. b. If blue radiation of wavelength 450 nm is incident onto the Cs photocathode, what will be the kinetic energy of the photoemitted electrons in eV? What should be the voltage...
8. (The next two questions correspond to the same problem.) You irradiate the surface of a metal (with work function of 4.31 eV) with a KrF laser. The laser wavelength is 248 nm. [3 pts] What is the maximum speed of photoelectrons produced in this experiment? (a) o (b) 123 km/sec (c) 373 km/sec (d) 495 km/sec (e) No photoelectrons are produced. 9. [2 pts) Which action would you take if you would like to reduce the maximum speed of...
Question 7 1 pts When light of wavelength , illuminates the surface of Metal 1, the stopping voltage is V. In terms of V, what will be the stopping voltage if the same wavelength is used to illuminate the surface of Metal 2? The work function of Metal 1 is 5.7 eV and the work function of Metal 2 is 2.1 eV. 3.6 volts - V O V-3.6 volts OV+3.6 volts 2.1 volts - V 5.7 volts - V Consider...
Most questions answered within 3 hours.
-
Oxidative phosphorylation is achieved through chemiosmotic
coupling, which turns chemical energy into osmotic potential energy
that...
asked 1 hour ago -
Hollywood Shoes would like to maintain their cash account at a
minimum level of $64,000, but...
asked 1 hour ago -
Proteins CtrA-P, DnaA, and GcrA behave similarly to what
molecule in the Eukaryotic Cell Cycle?
asked 1 hour ago -
TRUE OR FALSE
In case of a competitive tender procedure, in the request for
quotation, the...
asked 1 hour ago -
I am a little behind please provide some explanation, will
provide thumbs up.
This question considers...
asked 1 hour ago -
Let say the utility function as U(X,Y) = lnX + Y. Show that the
marginal rate...
asked 1 hour ago -
A current of I=8.0A is flowing in a typical extension cord of
length L=3.00m. The cord...
asked 2 hours ago -
1. When balancing the equation H2SO4 (aq) + NaOH (aq) →
Na2SO4(aq) + H2O(aq), would you...
asked 2 hours ago -
Provide a definition of “classification hierarchy” and
illustrate your definition with an example of how and...
asked 2 hours ago -
1. Describe the four main green solvents. Provide one example of
the use of each solvent....
asked 2 hours ago -
International ethics focus on:
1) exploitation of labor
2)corruption
3) environmental impact
4) none of the...
asked 2 hours ago -
Costing Models You work for XYZ trucking and your boss has asked
you to figure out...
asked 2 hours ago