What are the three figures of merit for an operational amplifier?

Question

Question

Answer 1

Answer #1

The three figures of merit for an operational amplifier are

1. Gain : The gain of operational amplifier is defined as ratio of output to input applied to operational amplifier .

2. Bandwidth : it is a range of frequencies where the operational amplifier output gives required performance .

3. Noise : it is a measure of how much noise is introduced in a process of amplification of operational amplifier

Answer 2

Similar Homework Help Questions

What is more critical for reducing the gain distribution of an operational amplifier and why is...

What is more critical for reducing the gain distribution of an operational amplifier and why is that so? Operational amplifier selection or resistor selection?
The operational amplifier in the circuit below is ideal. What is the value ofvo and ib...

The operational amplifier in the circuit below is ideal. What is the value ofvo and ib sooon 20002 +5V 10002
What is the gain of the operational amplifier R2 50kohm R1 U1 5kohm -Vout

What is the gain of the operational amplifier R2 50kohm R1 U1 5kohm -Vout

2. Consider this non-inverting op-amp amplifier This non-inverting amplifier circuit uses an operational amplifier as a...

2. Consider this non-inverting op-amp amplifier This non-inverting amplifier circuit uses an operational amplifier as a building block. Do around. The op-amp's gain is a "little a"), but the overall amplifier's gain is A Cbig A. Derive the value of the output voltage, ve, as a function of the input voltage not confuse the non-inverting amplifier with the operational amplifier that it is built a. and the op-amp's gain a. What is the overall amplifier's gain Avo/v? (20pts) b. We...
Why is it impossible to create an ideal operational amplifier?

Why is it impossible to create an ideal operational amplifier?
The last stage of operational Amplifier is a power amplifier. Class B is a good choice...

The last stage of operational Amplifier is a power amplifier. Class B is a good choice for the power amplifier. However, class B suffer from crossover distortion. Several methods are used to correct this non linearity as was discussed in the lecture (class AB). One of this method is the use of VBE multiplier. Design the output of an operational amplifier using class AB that employ VBE multiplier. For temperature stability RE can be used for the NPN and PNP...

solve it on paper neatly An inverting operational amplifier is to operate according to the following...

solve it on paper neatly An inverting operational amplifier is to operate according to the following specification: Voltage gain = 100 Input resistance (at mid-band) = 10 ke Lower cut-off frequency = 250 Hz Upper cut-off frequency = 15 kHz Confirm a circuit to satisfy the above specification using an operational amplifier I
Resistances (4.7 ko, 10 ka) Operational Amplifier (UA741) IV. Experiment a. Inverting Amplifier 10k Ri 4...

Resistances (4.7 ko, 10 ka) Operational Amplifier (UA741) IV. Experiment a. Inverting Amplifier 10k Ri 4 10V V1 4.7K 10 uA741 i. Calculate the gain of the inverting amplifier. Page 3 of 9
Define operational amplifier and its basic operation mechanism

Define operational amplifier and its basic operation mechanism, calculate output voltage Vout for the below R1 = 20 KOhm, and R2 = 5000 KOhm, Vi = 0.01 V.

An amplifier circuit is shown in Fig. 1b. The operational amplifier (op-amp) Ai can be assumed...

An amplifier circuit is shown in Fig. 1b. The operational amplifier (op-amp) Ai can be assumed as ideal. The input impedance of this amplifier is 1M2. The gain of this amplifier is -100. R2 V R VVV 小小 Ri Fig. 1b (a) Show that 12 = (b) Find the expression of the voltage gain, Av, in terms Ri, R, R3 and R4. (c) Due to practical reasons, the maximum value to be used for the resistors is set at 1M2....