I'm working on a prelab titled: Analysis of Water for Dissolved Oxygen. The question is: Calculate...
I'm working on a prelab titled: Analysis of Water for Dissolved Oxygen. The question is: Calculate the concentration in mg/L (ppm) of a solution that is 4*10^-3M in O2, assuming a density of 1g/mL for the solution.
I'm not sure if I provided all of the information needed, seeing as how I don't entirely understand the question. Any help would be appreciated. Thank you.
Homework Answers
4*10^-3 M means 4*10^-3 moles per litre
now, mass = mole*molar mass
= 4*10^-3*32
= 0.128 grams/L
or 128mg /L
so, 128mg/L
any query please comment
if satisfied please rate it thanks
Add Answer to:
I'm working on a prelab titled: Analysis of Water for Dissolved
Oxygen. The question is: Calculate...
Question 13 Calculate the amount of dissolved oxygen (ppm 02) using the following data: • Sample...
Question 13 Calculate the amount of dissolved oxygen (ppm 02) using the following data: • Sample volume (mL) = 224.893 • Buret Reading, initial (mL) = 3.581 • Buret Reading, final (mL) = 18.25 • Volume of Na2S203 dispensed (mL) = • Average molar concentration of Na2S203 (mol/L) = 0.0219 • Moles of Na2S203 dispensed (mol) = • Moles of 13° reduced by S2032-(mol) = • Moles of O2 (mol) = • Mass of O2 (mg) • Dissolved oxygen, ppm...
Calculate the concentration in units of mg/L for oxygen dissolved in 1050.0 mL of water at...
Calculate the concentration in units of mg/L for oxygen dissolved in 1050.0 mL of water at 25 °C, if the partial pressure of O2 in gas phase in equilibrium with the water is 238.1 mm Hg. Assume the density of water =1 g/mL
Dissolved Oxygen in Water Sample Question 1. Calculate the dissolved oxygen for 300 ml sample of...
Dissolved Oxygen in Water Sample Question 1. Calculate the dissolved oxygen for 300 ml sample of water that was analyzed using Winkler method with azide modification. The sample were titrated against standard 0.025 N of sodium thiosulphate, and the required volume of sodium thiosulphate to reach the colorless endpoint was 13.5ml. Question 2. A student conducted an experiment to measure the biochemical oxygen demand for 400 ml of waste water. She diluted the sample by adding 600 ml of oxygen...
A. 0.191 g of steel was dissolved in acid and diluted to 100 mL with water. The solution was found to contain 7.7 ppm Mn by atomic absorption analysis. What was the weight percent Mn in the steel? B....
A. 0.191 g of steel was dissolved in acid and diluted to 100 mL with water. The solution was found to contain 7.7 ppm Mn by atomic absorption analysis. What was the weight percent Mn in the steel? B. A multivitamin tablet with a label value of 13 mg Zn per tablet was dissolved in acid and diluted to 100 mL with water. What is the theoretical Zn concentration of the solution? Answer in ppm.
Hard water normally contains mineral ions, such as Ca2+ and Mg2+ ions, from minerals that dissolved...
Hard water normally contains mineral ions, such as Ca2+ and Mg2+ ions, from minerals that dissolved in the ground water. For water of low hardness, the concentration of Ca2+ ions is usually expressed as ppm CaCO3 in the water sample. Parts per million (ppm) is defined as one part of solute mass per 1,000,000 parts of solution mass, as shown in the following equation. Please note, the unit of denominator and numerator needs to be the same. Since ppm expresses...
Q 1(a) [13.33 Marks] Levels of dissolved oxygen in water can be determined by the Winkler...
Q 1(a) [13.33 Marks] Levels of dissolved oxygen in water can be determined by the Winkler method in the Leaving Certificate Chemistry course as follows: Under alkaline conditions manganese(II) sulphate produces a white precipitate of manganese(II) hydroxide: Mn2+(aq) + 2OH-(aq) → Mn(OH)2(s) This reacts with the dissolved oxygen to produce a brown precipitate. 2Mn(OH)2(s) + O2(aq) → 2MnO(OH)2(s) Addition of concentrated H2SO4 releases free iodine from KI. MnO(OH)2(s) + 4H+(aq) + 21-(aq) + Mn2+(aq) + 12(aq) + 3H2O(1) The free...
Biochemistry Question: I'm having trouble understanding how to calculate % yield with the given i...
Biochemistry Question:
I'm having trouble understanding how to calculate %
yield with the given information (Volume & Concentration), I
don't necessarily need the answers, but I'd like to know how to
calculate them. Additionally, while I'm asking this, how could one
evaluate those results to determine if the purification was 'good'
or not?
Thank you
S., Finish this protetn purification table: (4 pts) volume 10 ml 12.5 Fraction 56.3 25.36 Homogenate DEAB Gel filtration Was this a 'good purification? Evaluate...
how would I calculate my results from the first two data the first data is my...
how would I calculate my results from the first two data the
first data is my results and the second data I have to calculate
each of those with the information that I have on the first 3
trails I really really need help and i just dont understand thank
you.
1 concentration of EDTA solution 2 molar mass of CaCO3 0.0100 M 100.09 g/mol Trail 1 -Trail 2 Trail 3 12 12.01 11.99 5 Unknown analysis Part 1 (pH...
barometric pressure 101 kpa. Is my working out correct? can you please solve this. Thankyou. Trial...
barometric pressure 101 kpa. Is my working out
correct? can you please solve this. Thankyou.
Trial Caleulation 1 need the following data: R. 8.314 kPa L mol"K! T from the information above in Kelvin V from the information above in L lP .P in kPa Note: the units all have to be in the same form when used in calculations!!! H:O: density is 1.02 g/mL RT 5 mL of hydrogen peroxide was decomposed at 25 °C releasing 48 mL of...
please help me with 3,4,5 Thank you! 3. Which sample had more moles of HA in...
please help me with 3,4,5
Thank you!
3. Which sample had more moles of HA in it initially? Give reas on ! 4. Do the prelab calculation found in part IIIA below 5. Calculate the (expected) initial concentration of your acid solution (see Part IIIB below to get the initial volume of your acid solution) Acid 2 0 50 40 30 0 10 20 Volume of titrant (base) added (mL) III. Experimental Information and Procedures A.Background and preliminary calculation. You...
Question 13 Calculate the amount of dissolved oxygen (ppm 02) using the following data: • Sample volume (mL) = 224.893 • Buret Reading, initial (mL) = 3.581 • Buret Reading, final (mL) = 18.25 • Volume of Na2S203 dispensed (mL) = • Average molar concentration of Na2S203 (mol/L) = 0.0219 • Moles of Na2S203 dispensed (mol) = • Moles of 13° reduced by S2032-(mol) = • Moles of O2 (mol) = • Mass of O2 (mg) • Dissolved oxygen, ppm...
Q 1(a) [13.33 Marks] Levels of dissolved oxygen in water can be determined by the Winkler method in the Leaving Certificate Chemistry course as follows: Under alkaline conditions manganese(II) sulphate produces a white precipitate of manganese(II) hydroxide: Mn2+(aq) + 2OH-(aq) → Mn(OH)2(s) This reacts with the dissolved oxygen to produce a brown precipitate. 2Mn(OH)2(s) + O2(aq) → 2MnO(OH)2(s) Addition of concentrated H2SO4 releases free iodine from KI. MnO(OH)2(s) + 4H+(aq) + 21-(aq) + Mn2+(aq) + 12(aq) + 3H2O(1) The free...
Biochemistry Question:
I'm having trouble understanding how to calculate %
yield with the given information (Volume & Concentration), I
don't necessarily need the answers, but I'd like to know how to
calculate them. Additionally, while I'm asking this, how could one
evaluate those results to determine if the purification was 'good'
or not?
Thank you
S., Finish this protetn purification table: (4 pts) volume 10 ml 12.5 Fraction 56.3 25.36 Homogenate DEAB Gel filtration Was this a 'good purification? Evaluate...
how would I calculate my results from the first two data the
first data is my results and the second data I have to calculate
each of those with the information that I have on the first 3
trails I really really need help and i just dont understand thank
you.
1 concentration of EDTA solution 2 molar mass of CaCO3 0.0100 M 100.09 g/mol Trail 1 -Trail 2 Trail 3 12 12.01 11.99 5 Unknown analysis Part 1 (pH...
barometric pressure 101 kpa. Is my working out
correct? can you please solve this. Thankyou.
Trial Caleulation 1 need the following data: R. 8.314 kPa L mol"K! T from the information above in Kelvin V from the information above in L lP .P in kPa Note: the units all have to be in the same form when used in calculations!!! H:O: density is 1.02 g/mL RT 5 mL of hydrogen peroxide was decomposed at 25 °C releasing 48 mL of...
please help me with 3,4,5
Thank you!
3. Which sample had more moles of HA in it initially? Give reas on ! 4. Do the prelab calculation found in part IIIA below 5. Calculate the (expected) initial concentration of your acid solution (see Part IIIB below to get the initial volume of your acid solution) Acid 2 0 50 40 30 0 10 20 Volume of titrant (base) added (mL) III. Experimental Information and Procedures A.Background and preliminary calculation. You...
Most questions answered within 3 hours.
-
PHP
Create an HTML Form that asks for a series of
personal information from the user,...
asked 23 seconds from now -
The cash account for American Medical Co. at April 30 indicated
a balance of $10,785. The...
asked 5 minutes ago -
aluminum maker Alcoa has a beta of about 1.86, whereas Hormel
Foods has a beta of...
asked 6 minutes ago -
Hewtex Electronics manufactures two products, headsets and
electronic calculators, and sells them nationally to wholesalers
and...
asked 8 minutes ago -
Describe how to measure benefits, including specific examples of
clinical and financial benefits that can be...
asked 21 minutes ago -
Costs associated with the manufacture of miniature
high-sensitivity piezoresistive pressure transducers is $74,000 per
year. A...
asked 36 minutes ago -
Given the following information for Jane Cole complete schedule
D of 1040 through part III and...
asked 35 minutes ago -
Why doesn't a small piece of uranium go naturally into a chain
reaction?
A) A small...
asked 40 minutes ago -
Last year’s freshman class at Big State University totaled 5,324
students. Of those, 1,254 received a...
asked 49 minutes ago -
The transverse displacement of a stretched string from
equilibrium as a function of time and position...
asked 52 minutes ago -
Do a detailed SWOT analysis for a small Agribusiness company in
Brazil
asked 52 minutes ago -
Which two measures of excellence are often in
conflict/contradiction with each other (and therefore difficult to...
asked 51 minutes ago