A radar transmits a pulse every 0.5 ms. It transmits an up-chirp of the duration of...
A radar transmits a pulse every 0.5 ms. It transmits an up-chirp of the duration of 0.01 ms with a bandwidth of 50MHz and starting at 0 Hz. Sketch the time frequency distribution the transmitted train of pulses (consider just 4 pulses in the sketch).
Homework Answers
Add Answer to:
A radar transmits a pulse every 0.5
ms. It transmits an up-chirp of the duration of...
1.) You want to send a "square wave" pulse signal at a frequency of 60 Hz....
1.) You want to send a "square wave" pulse signal at a frequency
of 60 Hz. What characteristics would this signal have?
2.) You want to set up a flicker fusion stimulus with a duty
cycle of 50%. Lets say you want to set up a stimulus that is a
total of 2 seconds long with a frequency of 1 Hz, 10 Hz, 20 Hz, 40
Hz, 60 Hz, 80 Hz, and 100 Hz. How do you do that? What...
A signal f(t) sinc (200 t) is sampled by periodic pulse train pr(t) resented in Fig. P5.1-6. Find and sketch the spectrum of the sampled signal. Explain if you 0.8 ms 4 ms 8 ms Fig. P5.1-6 will be ab...
A signal f(t) sinc (200 t) is sampled by periodic pulse train pr(t) resented in Fig. P5.1-6. Find and sketch the spectrum of the sampled signal. Explain if you 0.8 ms 4 ms 8 ms Fig. P5.1-6 will be able to reconstruct f(t) from these samples. If the sampled signal is passed through an ideal lowpass filter of bandwidth 100 Hz and unit gain, find the filter output. What is the filter output if its bandwidth is B Hz, where...
Consider a binary communication system that transmits information using the pulse g(t) = A[−u(t) + 2u(t...
Consider a binary communication system that transmits information using the pulse g(t) = A[−u(t) + 2u(t − T /2) − u(t − T )] according to the mapping rule “0′′ → −g(t) “1′′ → +g(t) The “0”s and “1”s are transmitted with equal probability, and the channel is an AWGN channel, with a two-sided noise power spectral density of No/2 watts/Hz. a) Determine and sketch the filter h(t) that is matched to g(t). b) Determine and sketch the overall pulse...
4) a. A signal g(t) = 20 cos 50nt.cos 220nt is sampled by a pulse train...
4) a. A signal g(t) = 20 cos 50nt.cos 220nt is sampled by a pulse train of frequency 250Hz. i. Calculate the Nyquist rate for the signal g(t). (4 Marks) ii. Sketch the spectrum of the resulting sampled signal. (5 Marks) iii. Specify the minimum cutoff frequency of the ideal reconstruction filter so as to recover g(t) from its sampled signal. (3 Mark) b. A signal in the frequency range 350 to 3500Hz is limited to peak to peak swing...
Consider additive white Gaussian noise with a double-sided noise power spectral density (PSD) 12-90 dBm/Hz 1E-12 W/Hz....
Consider additive white Gaussian noise with a double-sided noise power spectral density (PSD) 12-90 dBm/Hz 1E-12 W/Hz. This noise corrupts a baseband polar NRZ signal with rectangular pulses, like that 1 mV and the pulse duration is Tb such that the symbol rate is Rb 1/Tb. Since this is binary signaling, the symbol rate equals the bit rate of the incoming baseband pulse train: B Rt. The signal is then sampled at the center of the noisy shown in the...
2. Increase the period of square signal in (b) with keeping same pulse duration, as shown...
2. Increase the period of square signal in (b) with keeping same pulse duration, as shown in the following figure То (c) A -A Ti Find the Fourier series coefficients az, as well as M7 and 8. for (c) T1=(1/4)To. Sketch the spectrum for both cases. Consider what spectrum will be if T1/To → 0. Procedures: Use the Signal Generator to generate the above signals according to the setting listed in Table I and measure the spectral from the Digital...
Problem #1. Topics: Z Transform Find the Z transform of: x[n]=-(0.9 )n-2u-n+5] X(Z) Problem #2. T...
Problem #1. Topics: Z Transform Find the Z transform of: x[n]=-(0.9 )n-2u-n+5] X(Z) Problem #2. Topics: Filter Design, Effective Time Constant Design a causal 2nd order, normalized, stable Peak Filter centered at fo 1000Hz. Use only two conjugate poles and two zeros at the origin. The system is to be sampled at Fs- 8000Hz. The duration of the transient should be as close as possible to teft 7.5 ms. The transient is assumed to end when the largest pole elevated...
Q1. A single-tone FM signal which can be expressed as, s(t) = 4, cos[2oft+ß sin(21f „t)]...
Q1. A single-tone FM signal which can be expressed as, s(t) = 4, cos[2oft+ß sin(21f „t)] is applied to a square-law device with output voltage v2 related to input voltage vi by vz(t)= av (t) where a is a constant. a. Determine analytic expression of the output signal. b. Explain how such a device can be used to obtain an FM signal with a greater frequency deviation (Af) than that available at the input. Q2. The spectrum of a message...
Yes, this is one problem. Please solve ALL PARTS. Guaranteed thumbs up for the person who solves it. 3 1. Photodiode...
Yes, this is one problem. Please solve ALL PARTS. Guaranteed
thumbs up for the person who solves it.
3 1. Photodiode amplifier circuit You are designinga CF photosensor circuit for a light detection and ranging LiDAR) system in autonomous vehicles. The circuit utilizes a transimpedance amplifier to convert low-level RF photodiode current signal to a usable voltage output. It consists of a photodiode, an amplifier, and feedback capacitor/resistor pair as shown in Figure 1. We will derive simple equations to...
1.) You want to send a "square wave" pulse signal at a frequency
of 60 Hz. What characteristics would this signal have?
2.) You want to set up a flicker fusion stimulus with a duty
cycle of 50%. Lets say you want to set up a stimulus that is a
total of 2 seconds long with a frequency of 1 Hz, 10 Hz, 20 Hz, 40
Hz, 60 Hz, 80 Hz, and 100 Hz. How do you do that? What...
A signal f(t) sinc (200 t) is sampled by periodic pulse train pr(t) resented in Fig. P5.1-6. Find and sketch the spectrum of the sampled signal. Explain if you 0.8 ms 4 ms 8 ms Fig. P5.1-6 will be able to reconstruct f(t) from these samples. If the sampled signal is passed through an ideal lowpass filter of bandwidth 100 Hz and unit gain, find the filter output. What is the filter output if its bandwidth is B Hz, where...
4) a. A signal g(t) = 20 cos 50nt.cos 220nt is sampled by a pulse train of frequency 250Hz. i. Calculate the Nyquist rate for the signal g(t). (4 Marks) ii. Sketch the spectrum of the resulting sampled signal. (5 Marks) iii. Specify the minimum cutoff frequency of the ideal reconstruction filter so as to recover g(t) from its sampled signal. (3 Mark) b. A signal in the frequency range 350 to 3500Hz is limited to peak to peak swing...
Consider additive white Gaussian noise with a double-sided noise power spectral density (PSD) 12-90 dBm/Hz 1E-12 W/Hz. This noise corrupts a baseband polar NRZ signal with rectangular pulses, like that 1 mV and the pulse duration is Tb such that the symbol rate is Rb 1/Tb. Since this is binary signaling, the symbol rate equals the bit rate of the incoming baseband pulse train: B Rt. The signal is then sampled at the center of the noisy shown in the...
2. Increase the period of square signal in (b) with keeping same pulse duration, as shown in the following figure То (c) A -A Ti Find the Fourier series coefficients az, as well as M7 and 8. for (c) T1=(1/4)To. Sketch the spectrum for both cases. Consider what spectrum will be if T1/To → 0. Procedures: Use the Signal Generator to generate the above signals according to the setting listed in Table I and measure the spectral from the Digital...
Problem #1. Topics: Z Transform Find the Z transform of: x[n]=-(0.9 )n-2u-n+5] X(Z) Problem #2. Topics: Filter Design, Effective Time Constant Design a causal 2nd order, normalized, stable Peak Filter centered at fo 1000Hz. Use only two conjugate poles and two zeros at the origin. The system is to be sampled at Fs- 8000Hz. The duration of the transient should be as close as possible to teft 7.5 ms. The transient is assumed to end when the largest pole elevated...
Q1. A single-tone FM signal which can be expressed as, s(t) = 4, cos[2oft+ß sin(21f „t)] is applied to a square-law device with output voltage v2 related to input voltage vi by vz(t)= av (t) where a is a constant. a. Determine analytic expression of the output signal. b. Explain how such a device can be used to obtain an FM signal with a greater frequency deviation (Af) than that available at the input. Q2. The spectrum of a message...
Yes, this is one problem. Please solve ALL PARTS. Guaranteed
thumbs up for the person who solves it.
3 1. Photodiode amplifier circuit You are designinga CF photosensor circuit for a light detection and ranging LiDAR) system in autonomous vehicles. The circuit utilizes a transimpedance amplifier to convert low-level RF photodiode current signal to a usable voltage output. It consists of a photodiode, an amplifier, and feedback capacitor/resistor pair as shown in Figure 1. We will derive simple equations to...
Most questions answered within 3 hours.
-
Problem 2: The Problem of Social Cost. A Rancher and Farmer live
side-by-side to each other....
asked 53 minutes ago -
a uniform bar of weight 40N is 4 meter long. weights
on 60N and 100N are...
asked 22 minutes ago -
Define Diet counceling? What are the
responsibilities of a counselor?
asked 2 hours ago -
Hey im just confused about how to put the ' A angle n' and ' S...
asked 2 hours ago -
A short essay about the WSJ article on Oreo versus Hydrox.
asked 2 hours ago -
##8. A program contains the following function definition:
##def cube(num):
##return num * num * num...
asked 2 hours ago -
find the value z of a standard Normal variable that satisfies
each of the given conditions....
asked 2 hours ago -
"banana".find('z')
Out[22]: -1
why is this -1
python 3.7
asked 2 hours ago -
Ilegal Consideration Marna Balin was involved in two automobile
accidents in which she suffered severe injures.She...
asked 2 hours ago -
Walk through the operation of QuickSort when n = 7 and the input
array is A...
asked 2 hours ago -
Answer with True or False. Argue the answers
7) The circulation of field B on any...
asked 2 hours ago -
Chase Co. uses the perpetual inventory method. The inventory
records for Chase reflected the following
Jan...
asked 2 hours ago