Homework Answers
Hope it will helpful for you :)
Add Answer to:
A. Label a clean 50-mL beaker as "Co(NO)2" and place a small nitrate into the beaker. Add to diss...
Need help calculating molatity if the solution in the lab listed below. 4. Place a weigh...
Need help calculating molatity if the solution in the lab listed below. 4. Place a weigh boat on the scale. Tare the scale and then weigh out approximately 4.1 g of sodium acetate. 5. Record the exact mass (if you were slightly off from 4.1, that’s fine…just write down the actual value so the math is not incorrect later) of the sodium acetate in your lab notes. 6. Transfer the sodium acetate into a 100 mL beaker. 7. Use a...
can someone fill in the blanks? Procedure: (1) Reaction between sodium iodide and lead (II) nitrate:...
can someone fill in the blanks?
Procedure: (1) Reaction between sodium iodide and lead (II) nitrate: Note the appearance 1. Weigh approximately 3.55 g of Nal (0.0237) and place it in the 100 beaker. Record the exact mass in the data table below. Note the a of the Nal crystals in the observation section. 2. Add 30 mL of distilled water to the beaker containing the Nal crystals. S the solution until all of the Nal crystals have dissolved. Record...
Preparation of 0.05 M Sodium Hydroxide (NaOH): In a clean, 2-liter plastic bottle place approximately 1.5...
Preparation of 0.05 M Sodium Hydroxide (NaOH): In a clean, 2-liter plastic bottle place approximately 1.5 liter of deionized water and add a sufficient volume of 50 wt% sodium hydroxide solution (density = 1.52 g∙mL–1) to produce an approximately 0.05 M solution? How do I prepare this solution?
i. Add about 2 mL of cobalt (II) chloride solution, CoCl2(aq), to a clean test tube....
i. Add about 2 mL of cobalt (II) chloride solution, CoCl2(aq), to a clean test tube. Add about 10 drops of the sodium hydroxide solution, NaOH(aq). Observe any changes. j. Place about 2 mL of silver nitrate solution, AgNO3(aq), to a clean test tube. Add about 10 drops of 3M hydrochloric acid, HCl(aq). Observe any changes. i. Reactants Type of Reaction Observations: Balanced Equation i. Reactants Type of Reaction Observations: Balanced Equation
EXPERIMENT: 26 ELECTROCHEMISTRY: GALVANIC AND ELECTROLYTIC CELLS Materials Required : 50 mL beake...
Help please
EXPERIMENT: 26 ELECTROCHEMISTRY: GALVANIC AND ELECTROLYTIC CELLS Materials Required : 50 mL beakers (2) test tubes sandpaper glass U-tube cotton voltmeter 9.0 V battery connecting wires with alligator clips (2) thermometer iron nail paper clips (2) copper wire magnesium ribbon magnesium sulfate (MgSO) copper sulfate pentahydrate (CuSO, 5H,O) sodium chloride (NaCI) saturated sodium chloride (NaCI)solution phenolphthalein indicator SAFETY PRECAUTIONS: EYE PROTECTION MUST BE WORN AT ALL TIMES IN LABORATORY. Purpose of Experiment: Oxidation-reduction reactions will be performed and...
f. Place about 2 mL of iron (III) chloride solution, FeCl3(aq), in a test tube. Add...
f. Place about 2 mL of iron (III) chloride solution, FeCl3(aq), in a test tube. Add about 10 drops of potassium thiocyanate solution, KSCN(aq). Observe any changes. Place a small amount of solid sodium bicarbonate, NaHCO3. also known as baking soda) in the bottom of a dry test tube. Cover the bottom to a depth of about 1 em. Quickly pour in about 2 mL of acetic acid, HC2H309. Observe any changes. There are really two reactions occurring here, one...
Balance the equation for the reaction observed: _ Cu(s) + HNO3(aq) → Cu(NO3)2(aq) +_ NO2(g) + H2O(1) 3. Add 40 mL...
Balance the equation for the reaction observed: _ Cu(s) + HNO3(aq) → Cu(NO3)2(aq) +_ NO2(g) + H2O(1) 3. Add 40 mL of 3.0 M NaOH (sodium hydroxide) to the solution in your beaker. Write the balanced equation for the reaction observed: 4. Add 2-3 boiling chips to your beaker and carefully heat the solution, while stirring with a stirring rod, just to the boiling point. (Do NOT boil. Have a low flame and keep the beaker well above the flame.)...
How Do I solve question 8, 10 and 13? Activity #1: Dissolution of ammonium nitrate in...
How Do I solve question 8, 10 and 13?
Activity #1: Dissolution of ammonium nitrate in water Fill a 100 ml beaker half-full with water. Place your hand on the outside of the beaker to gauge the temperature Add a large scoop of ammonium nitrate to the beaker and stir. Feel the temperature of the beaker as the ammonium nitrate dissolves. 1. Write the molecular and total ionic equations for the dissolution of ammonium nitrate. MOLECULAR EQUATION: NH4NO3 +H20) NH4OH...
1. In a small beaker mix together 5.0 mL of 0.10 M Co(NO3)2 . 6H2O with...
1. In a small beaker mix together 5.0 mL of 0.10 M Co(NO3)2 . 6H2O with 5.0 mL of concentrated HCl. Be sure to mix thoroughly with your glass stirring rod. This is your equilibrium mixture. 2. Place 1.0 mL of your equilibrium mixture in a small test tube add 1.0 mL of concentrated HCl. Observe any color changes and state in which direction (if any) the equilibrium shifted. Place a new 1.0 mL sample of your equilibrium mixture in...
uses a clean spatula to transfer about 0.3 g each of lithium dichromate and barium nitrate,...
uses a clean spatula to transfer about 0.3 g each of lithium dichromate and barium nitrate, respectively, into two separate test-tubes. Then adds about 4.0 mL of deionized water to dissolve each compound. The barium nitrate solution is colorless and transparent, but the lithium dichromate solution, although transparent, has a yellowish color. She cautiously swirls both test tubes to ensure complete dissolution and then pours the lithium dichromate solution into the test-tube containing the barium nitrate solution. Please help ASAP!...
can someone fill in the blanks?
Procedure: (1) Reaction between sodium iodide and lead (II) nitrate: Note the appearance 1. Weigh approximately 3.55 g of Nal (0.0237) and place it in the 100 beaker. Record the exact mass in the data table below. Note the a of the Nal crystals in the observation section. 2. Add 30 mL of distilled water to the beaker containing the Nal crystals. S the solution until all of the Nal crystals have dissolved. Record...
i. Add about 2 mL of cobalt (II) chloride solution, CoCl2(aq), to a clean test tube. Add about 10 drops of the sodium hydroxide solution, NaOH(aq). Observe any changes. j. Place about 2 mL of silver nitrate solution, AgNO3(aq), to a clean test tube. Add about 10 drops of 3M hydrochloric acid, HCl(aq). Observe any changes. i. Reactants Type of Reaction Observations: Balanced Equation i. Reactants Type of Reaction Observations: Balanced Equation
Help please
EXPERIMENT: 26 ELECTROCHEMISTRY: GALVANIC AND ELECTROLYTIC CELLS Materials Required : 50 mL beakers (2) test tubes sandpaper glass U-tube cotton voltmeter 9.0 V battery connecting wires with alligator clips (2) thermometer iron nail paper clips (2) copper wire magnesium ribbon magnesium sulfate (MgSO) copper sulfate pentahydrate (CuSO, 5H,O) sodium chloride (NaCI) saturated sodium chloride (NaCI)solution phenolphthalein indicator SAFETY PRECAUTIONS: EYE PROTECTION MUST BE WORN AT ALL TIMES IN LABORATORY. Purpose of Experiment: Oxidation-reduction reactions will be performed and...
f. Place about 2 mL of iron (III) chloride solution, FeCl3(aq), in a test tube. Add about 10 drops of potassium thiocyanate solution, KSCN(aq). Observe any changes. Place a small amount of solid sodium bicarbonate, NaHCO3. also known as baking soda) in the bottom of a dry test tube. Cover the bottom to a depth of about 1 em. Quickly pour in about 2 mL of acetic acid, HC2H309. Observe any changes. There are really two reactions occurring here, one...
Balance the equation for the reaction observed: _ Cu(s) + HNO3(aq) → Cu(NO3)2(aq) +_ NO2(g) + H2O(1) 3. Add 40 mL of 3.0 M NaOH (sodium hydroxide) to the solution in your beaker. Write the balanced equation for the reaction observed: 4. Add 2-3 boiling chips to your beaker and carefully heat the solution, while stirring with a stirring rod, just to the boiling point. (Do NOT boil. Have a low flame and keep the beaker well above the flame.)...
How Do I solve question 8, 10 and 13?
Activity #1: Dissolution of ammonium nitrate in water Fill a 100 ml beaker half-full with water. Place your hand on the outside of the beaker to gauge the temperature Add a large scoop of ammonium nitrate to the beaker and stir. Feel the temperature of the beaker as the ammonium nitrate dissolves. 1. Write the molecular and total ionic equations for the dissolution of ammonium nitrate. MOLECULAR EQUATION: NH4NO3 +H20) NH4OH...
Most questions answered within 3 hours.
-
Kylie is a single mom with two dependent children,
Tanner, age 7 and Olivia, age 11....
asked 1 hour ago -
Phosphorous + bromine = phosphorous tribromide. If 35.0 g of
bromine are reacted and 27.9 grams...
asked 2 hours ago -
Derive the long wavelength limit of the Planck energy density
distribution
asked 2 hours ago -
Calculate the pH of each of the following solutions.
0.50 M HBr
3.1×10−4 M KOH
4.2×10−5...
asked 6 hours ago -
For the year ended December 31, Depot Max’s cost of merchandise
sold was $85,600. Inventory at the...
asked 6 hours ago -
Week 10 - Professional Memo Assignment
Professional Memo Assignment
Your mission for this week, should you...
asked 6 hours ago -
Write a Python program that stores the data for each
player on the team, and it...
asked 6 hours ago -
In
the last 3 months, mike never knows when he is going to get his
allowance...
asked 6 hours ago -
Is Ca(OH)2 a Bronsted base, Lewis base, or both? Why?
asked 6 hours ago -
1A- Why don’t voters complain about U.S. tariffs on imported
sugar?
Because sugar is only a...
asked 6 hours ago -
Cash Payback Period
Primera Banco is evaluating two capital investment proposals for
a drive-up ATM kiosk,...
asked 6 hours ago -
Create a button in Swift (Xcode) that will create a charge,
create a charge using Stripe's...
asked 6 hours ago