UESTION # 2: (20 Marks) The thick cylinder shown in Fig. Q2(a) is made of high strength steel wit...
MEE2001/2015 Q5. A thin walled steel cylinder with 10 mm wall thickness and internal diameter of 200 mm (Fig. Q5) is subjected to an internal pressure, p. The steel used for the cylinder has a yield stress of 240 MPa. +F 200 mm Fig. Q5 (a) If a tensile axial force of 1MN is applied to the end plate, show that the maximum internal pressure that can be applied before the cylinder yields according to the Tresca criterion is 16.2...
A thick-walled steel cylinder with internal diameter = 16 mm and external diameter = 24 mm is subjected to a gradually increasing internal pressure P. I. Using accurate formulation, determine the value of P and sketch the distribution of radial, tangential and maximum shear stresses when: a. The material of the cylinder first commences to yield. b. Yielding progressed to mid-depth of the cylinder wall (at D= 20 mm ). c. The material of the cylinder suffers complete collapse (fully...
Problem 1: (a)A thick-walled cylinder, made from a homogeneous and isotropic elastic material, has an inner radius a and outer radius b. The cylinder is subjected to an internal pressure pi, and is under plane stress conditions. In this case the displacement field is of interest is given by and the stress field of interest is given by C2 C2 where, with (E and v) denoting the Young's modulus and the Poisson's Ratio. EA EB Show that b2 b2 (b/a)2-1)...
with steps please Question4 A thick-walled cylinder of mild steel with internal diameter of 80 mm and external diameter of 120 mm is loaded by internal pressure. The yield strength of the material is 300 MPa. a. Find the internal pressure required to initiate yielding in the cylinder using Lame's formulation. Sketch the stress distribution giving significant stress values. b. Find the plastic limit pressure at which the cylinder is fully plastic using non-linear formulation. Sketch the stress distribution giving...
4.A thin-walled cylindrical column carries a weightless arch and is loaded as shown in Figure 4. The column has an internal diameter of 250 mm with a thickness of 2 mm Given: E-200 GPa and 0.3 The answer to each part of the question is to be used for subsequent parts (a)Determine the stresses on the outer surface of the cylinder at points A and B due to (8 marks) (b) Determine the minimum internal pressure p required if the...
Question 1 The motor shown in Fig. 1 supplies power to Gear C through solid steel motor shaft GF (having a diamet of 200 mm) and Gear F. The torque delivered to Gear C is 200 kNm. Gears A, B, D and E supply powers to er three machines. The torques delivered by gear A, gear B and gear E to the machines are 60 kNm, 30 kNm and 40 kNm, respectively. Shaft ABCDE is also made of steel (G...